Characterization of the signature of subwavelength variation from far-field irradiance

The dynamic signature of the subwavelength variation of a slit is shown to be determinable from far-field irradiance with a precision of better than 1 nm. One can increase the efficiency of measurement of the subwavelength's signature by adjusting the detection width over which the subwavelength variation is detected. The subwavelength variation of a rectangular aperture was also examined to show the general feasibility.     

1.5-mum emissions from laser-diode-pumped Nd-doped microchip solid-state lasers

1.5-mum emissions from Nd:YAG, Nd:YVO(4), and LiNdP(4) O>(12) microchip lasers pumped by laser diodes have been observed. These coherent emissions are attributed to the effect of high-energy modified lattice vibration owing to the existence of Nd ions as well as to stimulated intracavity Raman scattering enhanced by the microchip configuration. A four-wave mixing process involving two lasing fields and a Stokes field was identified as the generator of new adjacent 1.5-mu;m emission.     

Design and Synthesis of 3‐Aryl‐5‐Alicylic‐[1,2,4]‐oxadiazoles as Novel Platelet Aggregation Inhibitors

A series of 4‐[2‐(alicyclic‐[1,2,4]oxadiazol‐3‐yl)phenoxy]‐butyric acids were synthesized from N‐hydroxy‐2‐isopropoxy benzamidine in 4 steps with good yields. These [1,2,4]oxadiazoles are novel platelet aggregation inhibitors preventing human platelet aggregation induced by thromboxane derivative U44,619 and adenosine diphosphate. A structure‐activity‐relationship study revealed that the potency for these 5‐oxadiazoles increases with the increase in the ring size of the alicylic rings. Derivative 8f may be useful as a template for the design of more potent anti‐platelet agents.     

Synthesis and characterization of chitosan‐modified polymethyl methacrylate latex particles

Stable chitosan‐modified polymethyl methacrylate (PMMA) latex particles were prepared by using 2,2′‐azobis(2‐amidinopropane) dihydrochloride (V‐50) as the cationic initiator. The polymerization rate (R_p) is controlled by the V‐50 concentration ([V‐50]) and R_p is less sensitive to the chitosan concentration ([C]) used in the synthesis work. The reaction system follows Smith–Ewart Case III kinetics due to the relatively large particles produced. The zeta potential data show that the isoelectric point (pI) of the latex particles is 10.7. The amounts of V‐50 (C_V‐50) and chitosan (C_c) ultimately incorporated into the particles correlate reasonably well with [V‐50] and [C], respectively. At pH 7, the quantity of the negatively charged bovine serum albumin (BSA, pI = 4.8) adsorbed on the positively charged chitosan‐free particles (Q) via the electrostatic interaction increases with increasing C_V‐50. However, Q is relatively insensitive to changes in C_c. This result implies that only the outermost region of the hairy chitosan‐modified particles is available for adsorption of the relatively large protein species. Colloidal stability shows a significant influence on the BSA adsorption process. © 1999 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 37: 1489–1499, 1999     

The inhibition profiles of 4'-acylpyrrole–5-fluoroindolin-2-ones with a C-3' side chain for VEGFR2, PDGFR-β, and FGFR-1 protein kinases

In this study, we reported the inhibition profiles of 4′-acylpyrrole–5-fluoroindolin-2-one 3 with a C-3′ side chain for VEGFR2, PDGFR-β, and FGFR-1 protein kinases. The pyrrole-fused cyclohexanone moiety provided 3 with the best potency to inhibit the three kinases, and the C-3′ side chains contributed to the different inhibition profiles of 3 . Compound 3b with a C-3′ 2-carboxylethyl side chain showed good potency for the three kinase (IC₅₀: 25–260 nM), and compound 3g with a N,N-dialkyl-2-carbamoylethyl side chain was more active for VEGFR2 (IC₅₀: 59 nM) and PDGFR-β (IC₅₀: 16 nM) than FGFR-1 (IC₅₀: 1.7 μM). The C-3′ 3-(dialkylamino)propyl side chain accomplished 3h – j as selective PDGFR-β inhibitors (IC₅₀: 7.8–13 nM). Compound 3b was further investigated and found potent to inhibit VEGF- and FGF-dependent cell proliferation with moderate in vivo anticancer activity. Results from docking simulations revealed that the interactions of 3b with VEGFR2 and FGFR-1 which could account for the different inhibition profiles of 3 .     

An Efficient Synthesis of 8-Amino-9-Benzylguanine

The reaction of 2,5-diamino-4-benzylamino-pyrimidin-6(III)-one (6) with benzoyl isothiocyanate furnished 2-amino-4-benzylamino-5-[1-(3-benzoylthioureido)]-pyrimidin-6(1H)-one (7) in good yield. The title compound I was synthesized from compound 7 via a cyclodesulfurative reaction with DCC in DMF at 80°C directly to form 8-benzoylamino-9-benzylguanine (9) which was subsequently treated with 1 N sodium hydroxide.     

Study of temperature distribution of sliding block with asperity surface

In this study, a numerical thermal model is developed for sliding block contact under various loads, sliding velocities and surface roughness. The temperature distributions are shown for perfectly insulated thermal conditions along noncontact surfaces. For a particular five‐peaks contact model, the maximum temperature at the central peak is slightly lhigher than the others. The temperature profile decreases as the distance to the symmetry axis increases, and then decreases dramatically at the noncontact area. It is clear to see that the maximum temperature locates at the symmetry central peak of the asperity contact area instead of the leading head of the smooth surface. The maximum temperature rise parameter increases as the pressure, sliding velocity and asperity roughness increased or conductivity decreased. This phenomenon becomes obvious for cases at high pressure, velocity and roughness and low conductivity. Particularly, the influence of roughness is not significant for low velocity. Similar results are found for the maximum temperature rise parameter difference between peaks or peaks/valleys. The simulation results of this asperity surface sliding block contact model are able to provide essential information for the components of microelectro—mechanical systems (MEMS) and biochemical reaction mechanism. Copyright © 2011 John Wiley & Sons, Ltd.     

Synthesis of 2‐[4‐(Imidazolin‐2‐Ylideneamino)Benzyl]‐Indan‐1‐Ones as Novel Potent Prostacyclin Antagonists

Prostacyclin is involved in many pathological conditions, such as sensitization of inflammation induced pain and isovolumetic distention. Therefore, antagonism of prostacyclin action may be useful in the alleviation of these conditions. In this study, novel potent prostacyclin antagonists, 2‐[4‐(imidazolin‐2‐ylideneamino)benzyl]‐indan‐1‐ones were synthesized from their respective substituted indanones in three steps. The construction of the amino‐imidazole moiety of these derivatives is achieved by using in situ generation of chloro‐imidazole and reaction with their respective anilines. Thus, these N‐substituted 2‐imidazolines can be prepared safely and efficiently. Moreover, these compounds show potent prostacyclin antagonistic activity by inhibition of prostacyclin agonist induced ERK_1/2 phosphorylation in human erythroleukemia cells. Moreover, we observed an increase in activity with the increase in electro‐donating property of the substitution on the indanone aromatic ring. Prostacyclin antagonists with increased potency may be designed based on these findings. These compounds may also be invaluable tools for the study of the physiological functions of prostacyclin.     

1,2,4-benzothiadiazine 1,1-dioxides 3. Reactions of 2-aminobenzenesulfonamide with chloroalkyl isocyanates

Reactions of 2-aminobenzenesulfonamide ( 1 ) with allyl, methyl, 2-chloroethyl aor 3-chloropropyl isocyanates gave 2-(methylureido)-, 2-(allylureido)-, 2-(2′-chloroethylureido)- and 2-(3′-chloropropylureido)-benzene sulfonamides 3a,b and 7a,b in excellent yields. Treatment of 3a,b at refluxing temperature of DMF afforded 2H-1,2,4-benzothiadiazin-3(4H)-one 1,1-dioxide ( 4 ) in good yield. However, when compounds 7a,b were refluxed in 2-propanol, 3-(2′-aminoethoxy)-2H-1,2,4-benzothiadiazine 1,1-dioxide ( 11a ) and 3-(3′-aminopropoxy)-2H-1,2,4-benzothiadiazine 1,1-dioxide ( 11b ) were obtained in a form of the hydrochloride salts 10a,b in 87% and 78% yields respectively. Heating 11b in ethanol gave a dimeric form of 2H-1,2,4-benzothiadiazin-3(4H)-one 1,1-dioxide and 3-(3′-aminopropoxy)-2H-1,2,4-benzothiadiazine 1,1-dioxide ( 12 ) in 55% yield. Treating of 7a,b or 11a,b with triethylamine at the refluxing temperature of 2-propanol afforded 3-(2′-hydroxyethylamino)-2H-1,2,4-benzothiadiazine 1,1-dioxide ( 2a ) and 3-(3′-hydroxypropylamine)-2H-1,2,4-benzothiadiazine 1,1-dioxide ( 2b ) via a Smiles rearrangement.     

Nonreductive deiodination of ortho-iodo-hydroxylated arenes using tertiary amines

A convenient and nonreductive deiodination is reported for the ortho-iodo-hydroxylated arenes including derivatives of quinolinol, phenol, and naphthol. Tertiary amines pyridine, triethylamine, and N-methylmorpholine in the presence of water initiated deiodination of ortho-iodo-hydroxylated arenes without affecting para-iodine and other reduction-susceptible groups. This reported method also works efficiently for polyiodinated systems. Simplicity, short reaction times, and absence of reducing catalyst are features of this method.