Highly porous magnetite/graphene nanocomposites for a solid-state electrochemiluminescence sensor on paper-based chips

Graphene-nanosheet-based highly porous magnetite nanocomposites (GN-HPMNs) have been prepared using a simple solvothermal method and used as an immobilization matrix for the fabrication of a solid-state electrochemiluminescence (ECL) sensor on paper-based chips. Highly porous Fe₃O₄ nanocrystal clusters were coated with acrylate and wrapped tightly on the skeleton of graphene nanosheets. The structures and sizes of the GN-HPMNs could be tuned by varying the proportions of the solvents ethylene glycol and diethylene glycol. Then, the relatively highly porous ones with an average diameter of about 65 nm were combined with Nafion to form composite films on an electrode surface for immobilization of Ru(bpy)₃ ²⁺ (bpy is 2,2′-bipyridine). Because of their porosity, negatively charged surface, and cooperative characteristics of magnetic nanomaterials and graphene, under an external magnetic field, the GN-HPMNs ensured effective immobilization, excellent electron transfer, and long-term stability of Ru(bpy)₃ ²⁺ in the composite film. The sensor developed exhibited excellent reproducibility with a relative standard deviation of 0.65 % for 30 continuous cycles. It was found to be much more favorable for detecting compounds containing tertiary amino groups and DNAs with guanine and adenine. A detection limit (signal-to-noise ratio of 3) of 5.0 nM was obtained for tripropylamine. As an application example, 0.5 nM single-nucleotide mismatch could be detected. This was the first attempt to introduce magnetic nanomaterials and an external magnetic field into paper-based chips. The sensor developed has the advantages of high sensitivity, good stability, and wide potential applicability as well as simplicity, low cost, and good disposability.

Determination of 48 fragrance allergens in toys using GC with ion trap MS/MS

This paper presents a method for the simultaneous determination of 48 fragrance allergens in four types of toys (plastic toys, play clays, plush toys, and paper toys) based on GC with ion trap MS/MS. Compared with single‐stage MS, MS/MS is superior in terms of the qualification and quantification of a large range of compounds in complicated matrices. Procedures for extraction and purification were optimized for each toy type. The method proved to be linear over a wide range of concentrations for all analytes with correlation coefficients between 0.9768 and 0.9999. Validation parameters, namely, LODs and LOQs, ranged from 0.005–5.0 and from 0.02–20 mg/kg, respectively. Average recoveries of target compounds (spiked at three concentration levels) were in the range of 79.5–109.1%. Intraday and interday repeatabilities of the proposed method varied from 0.7–10.5% and from 3.1–13.4%, respectively. The proposed method was used to monitor fragrance allergens in commercial toy products. Our findings indicate that this method is an accurate and effective technique for analyzing fragrance allergens in materials composed of complex components.     

Facile synthesis of a porous network-like silver film for electrocatalytic detection of nitrate

We have developed a method for in-situ construction of a porous network-like silver film on the surface of a glassy carbon electrode (GCE). It is based on a galvanic replacement reaction where a layer of copper nanoparticles is first electrodeposited as a sacrificial template. The silver film formed possesses a porous network-like structure and consists of an assembly of numerous nanoparticles with an average size of 200 nm. The electrode displays excellent electrocatalytic activity, good stability, and fast response (within 2 s) toward the reduction of nitrate at a working potential of −0.9 V. The catalytic currents linearly increase with the nitrate concentrations in the range of 0.08–6.52 mM, with a detection limit of 3.5 μM (S/N = 3) and a repeatability of 3.4 % (n = 5).

A facile method was developed for in situ construction of a porous network-like Ag film on a glassy carbon electrode by a galvanic replacement reaction, where a layer of Cu nanoparticles previously electrodeposited as a sacrificial template. Thus-formed Ag film displays excellent electrocatalytic activity, good stability, and fast response (within 2 s) toward nitrate reduction.

     

Efficient Method for Synthesis of the Derivatives of 5‐Arylidene Barbituric Acid Catalyzed by Aminosulfonic Acid With Grinding

Aminosulfonic acid is an environmentally friendly catalyst. Grinding a mixture of aromatic aldehydes, barbituric acid, and H₂NSO₃H at room temperature (without any solvent) gave 5‐arylidene barbituric acid in high yields, providing a simple and efficient route to synthesis of these compounds.     

Clean,One‐Pot Synthesis of Naphthopyran Derivatives in Aqueous Media

A general and practical one‐pot synthesis of naphthopyran derivatives using hexadecyltrimethylammonium bromide (HTMAB) as catalyst (10 mol%) is described. This method provides several advantages such as neutral conditions, high yields and simple workup procedure. The catalyst is low cost, facile, active, environmentally friendly, and reusable. In addition, water is chosen as a green solvent.     

Cloning, Expression, and Characterization of β-mannanase from Bacillus subtilis MAFIC-S11 in Pichia pastoris

The β-mannanase gene (1,029 nucleotide) from Bacillus subtilis MAFIC-S11, encoding a polypeptide of 342 amino acids, was cloned and expressed in Pichia pastoris. To increase its expression, the β-mannanase gene was optimized for codon usage (mannS) and fused downstream to a sequence-encoding modified α-factor signal peptide. The expression level was improved by 2-fold. This recombinant enzyme (mannS) showed its highest activity of 24,600 U/mL after 144-h fermentation. The optimal temperature and pH of mannS were 50 °C and 6.0, respectively, and its specific activity was 3,706 U/mg. The kinetic parameters V _max and K _m were determined as 20,000 U/mg and 8 mg/mL, respectively, representing the highest ever expression level of β-mannanase reported in P. pastoris. In addition, the enzyme exhibited much higher binding activity to chitin, chitosan, Avicel, and mannan. The superior catalytic properties of mannS suggested great potential as an effective additive in animal feed industry.     

A facile one-pot, three-component synthesis of 3,3′-(4-arylpyridine-2,6-diyl)bis(2H-chromen-2-one) derivatives under microwave irradiation

A series of 3,3′-(4-arylpyridine-2,6-diyl)bis(2H-chromen-2-one) derivatives have been synthesized by the one-pot, three-component reaction of 3-acetylcoumarin, an aromatic aldehyde, and ammonium acetate in acetic acid under microwave irradiation. This procedure has the major advantages of short reaction time, good yields, low energy consumption, easy operation, and environmental friendliness. All of the products were characterized by IR and NMR spectroscopy, MS, and elemental analysis.     

Electrochemical‐Reduction‐Assisted Assembly of a Polyoxometalate/Graphene Nanocomposite and Its Enhanced Lithium‐Storage Performance

Herein, we present an electrochemically assisted method for the reduction of graphene oxide (GO) and the assembly of polyoxometalate clusters on the reduced GO (rGO) nanosheets for the preparation of nanocomposites. In this method, the Keggin‐type H₄SiW₁₂O₄₀ (SiW₁₂) is used as an electrocatalyst. During the reduction process, SiW₁₂ transfers the electrons from the electrode to GO, leading to a deep reduction of GO in which the content of oxygen‐containing groups is decreased to around 5 %. Meanwhile, the strong adsorption effect between the SiW₁₂ clusters and rGO nanosheets induces the spontaneous assembly of SiW₁₂ on rGO in a uniformly dispersed state, forming a porous, powder‐type nanocomposite. More importantly, the nanocomposite shows an enhanced capacity of 275 mAh g^?1 as a cathode active material for lithium storage, which is 1.7 times that of the pure SiW₁₂. This enhancement is attributed to the synergistic effect of the conductive rGO support and the well‐dispersed state of the SiW₁₂ clusters, which facilitate the electron transfer and lithium‐ion diffusion, respectively. Considering the facile, mild, and environmentally benign features of this method, it is reasonable as a general route for the incorporation of more types of functional polyoxometalates onto graphene matrices; this may allow the creation of nanocomposites for versatile applications, for example, in the fields of catalysis, electronics, and energy storage.