An interior trust region algorithm for solving linearly constrained nonlinear optimization

In this paper, an interior point algorithm based on trust region techniques is proposed for solving nonlinear optimization problems with linear equality constraints and nonnegative variables. Unlike those existing interior-point trust region methods, this proposed method does not require that a general quadratic subproblem with a trust region bound be solved at each iteration. Instead, a system of linear equations is solved to get a search direction, and then a linesearch of Armijo type is performed in this direction to obtain a new iteration point. From a computational point of view, this approach may in general reduce a computational effort, and thus improve the computational efficiency. Under suitable conditions, it is proven that any accumulation of the sequence generated by the algorithm satisfies the first-order optimality condition.     

Pt(110)表面自吸附原子能量和力的改进分析型嵌入原子法分析

采用改进分析型嵌入原子法计算了Pt(110)表面自吸附原子的能量和法向力.当Pt吸附原子位于Pt(110)表面第一层原子的二重对称洞位上0.11nm时最稳定.Pt吸附原子的最佳迁移路径是由一个二重对称洞位沿密排方向迁移到最近邻的另一个二重对称洞位.在吸附原子远离表面的过程中，将依次经过排斥、过渡和吸引等三个区域.在排斥区和过渡区，由于吸附原子与表面原子间强的相互作用势，吸附原子的能量和法向力的形貌图均为(110)面原子排列的复形，与对势理论和嵌入原子法得到的结果一致.在吸引区，由于多体相互作用及晶体中原子 关键词： 金属表面 自吸附 能量 力     

描述光伏效应的新解析模型

 对陆启生等人提出的描述光伏效应的解析模型涉及的边界条件进行了讨论，提出了一个适用性更宽的解析模型。通过对新模型、陆的模型以及另一个解析模型的比较，对前两个模型能够描述光伏型光电探测器在强光辐照时的信号饱和效应的原因进行了解释。     

双轴晶体Nd^3＋：KGd（WO4）2的非偏振吸收光谱研究

报道了用三个方向相互垂直的非偏振吸收光谱测量计算Ｊｕｄｄ－Ｏｆｅｌｔ参数从而算出双轴晶体Ｎｄ３＋ＫＧｄ（ＷＯ４）２的荧光寿命、荧光分支比和发射截面的方法。得到的荧光寿命为１１９μｓ，平均发射截面为２．３×１０－１９ｃｍ２。     

基于变芯径光纤的光学系统在光造型中的应用

光学系统采用变芯径光纤，可大幅度提高光的传输效率，增加光学子系统柔性。描述了光造型工作原理及其理论依据，在介绍所研制的光的成型系统光学子系统的基础上，阐述了紫外光源的选择与设计，及变芯径光纤的设计、传输、耦合与聚焦等技术。该套基于变芯径光纤的光学子系统成本低、体积小、效率高，巳成功应用于所研制的台式低成本快速成型系统中，为该系统的进一步推广奠定了技术基础。     

二层多目标规划的最优性条件

本文在集值优化的框架下提出了一个二层多目标规划模型（BLMOP）.利用集值映射的相依导数和相依上导数,给出了几个有关（BLMOP）的弱有效解的必要或充分最优性条件.     

离子束引起的在Al／Cr双层薄膜界面处的原子混合

用600keV的Kr~ 离子轰击Al/Cr双层薄膜样品进行界面原子反应及相互混合的研究。实验样品是在单晶硅上蒸镀约500nm厚的铝膜,相继再蒸上所需厚度的铬膜而制成的。轰击剂量为2.0×10~(15)-2.5×10~(16)Kr~ /cm~2。用2.0MeVa粒子对轰击前后的样品进行了卢瑟福背散射(RBS)分析,发现界面处有明显的原子混合存在;当轰击剂量≥1.0×10~(16)Kr~ /cm~2时,RBS谱出现有明显的坪台,经拟合计算和x射线衍射(XRD)测量证实确有化合物Al_(13)Cr_2存在;还分别得到了原子混合量及混合效率与轰击剂量的关系;最后对界面处的原子混合机制进行了讨论。     

Preparation of well-aligned carbon nanotubes by pyrolysis of phenolic resin in anodic alumina pores

Well-aligned carbon nanotubes (CNTs) of high quality were synthesized by pyrolysis of phenolic resin at 800 °C in anodic alumina oxide (AAO) pores under argon protection. The innocuous source materials and safe operational conditions permit this method to synthesize well-aligned CNTs in large-scale and low cost. The formation mechanism of the synthesized CNTs is also proposed in this work by a series of visual sketches and is proved with obvious evidence. Firstly, phenolic resin nanotubes form in the template pores through the evaporation of solvent. Heat treatment then transfers these tubes into CNTs.     

Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007