Viscosity,particle size distribution,and structural investigation of tetramethyloxysilane/2‐hydroxyethyl methacrylate sols during the sol–gel process with acid and base catalysts

The tetramethoxysilane (TMOS)/2‐hydroxylethyl methacrylate (HEMA) hybrid gels were synthesized with acid and base catalysts, via the in situ polymerization of HEMA, with and without the cosolvent methanol. With methanol in the TMOS/HEMA sol, the enhanced esterification and depolymerization reactions of the silanols resulted in a slower growth of silica particles. The silica particles that were synthesized with an acid catalyst were less than 40 nm. The thermal resistance of the poly(2‐hydroxyethyl methacrylate) (PHEMA) chains was enhanced by the addition of colloidal silica. The Fourier transform infrared characterizations and the exothermal peaks on the differential scanning calorimetry traces of these hybrid gels indicated chemical hybridization occurring as a result of condensation of the colloid silica and PHEMA at higher temperatures. Hence, the residual weight content of the hybrid gel after its synthesis with the base catalyst was even higher than the content of TMOS in the hybrid sol. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3476–3486, 2004     

DNA-conjugated polymers for self-assembled DNA chip fabrication.

We developed two DNA-conjugated polymers, one based on polyallylamine and the other on polyacrylic acid, for use in DNA chips. A 30-mer single-stranded DNA probe and thioctic acid were covalently attached to polyallylamine as sidechains. The same single-stranded DNA and 3-(pyridyldithio)propionyl hydrazide were covalently attached to polyacrylic acid as sidechains. Both DNA-conjugated polymers could be specifically immobilized onto a gold sensor substrate by a self-assembly technique. The interactions between fully matched DNA and each DNA-conjugated polymer were investigated by surface plasmon resonance. A gold surface modified with either DNA-conjugated polymer recognized fully matched DNA much better than unmatched DNA. The hybridization selectivity and efficiency of DNA-conjugated polyallylamine was optimized by adjusting the pH so as to reduce the effects of cationic polymer sidechains. The hybridization selectivity and efficiency of DNA-conjugated polymers were higher than those of a conventional immobilized thiol-based DNA. The coating of DNA-conjugated polymers reduced nonspecific adsorption of DNA by the gold substrate. DNA-conjugated polyacrylic acid was more selective toward fully matched DNA than was DNA-conjugated polyallylamine. Therefore, DNA-conjugated polymers show promise for application in novel DNA chips.     

Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

氟代吡啶阳离子的理论研究

利用量子化学密度泛函理论B3LYP方法及 6 31G(d ,p)、6 311G(d ,p)、6 31+G(d ,p)和 6 311+G(d ,p)基组对五氟代吡啶、2 ,6 二氟代吡啶和 2 氟代吡啶分子的阳离子进行了计算研究 .B3LYP构型优化和频率分析计算结果表明这三种氟代吡啶阳离子的结构分别具有C2v、C2v和Cs 对称性 ,电子基态分别为2 A2 、2 A2 和2 A″ .对离子和分子的计算构型做了比较 .利用B3LYP方法和不同的基组对这三种阳离子及其分子进行了自然布居分析计算 .用B3LYP方法对这三种阳离子 (自由基 )中的超精细结构进行了计算 ,对五氟代吡啶、2 ,6 二氟代吡啶和2 氟代吡啶分子的垂直电离势和绝热电离势进行了计算 ,与实验值符合得很好     

聚乙烯基咔唑与Alq3混合薄膜的发光性能与能量传递过程

研究了Alq3与聚乙烯基咔唑(PVK)按不同比例的混合体系制备的薄膜的发光特性.通过对混合薄膜的吸收光谱、激发光谱和发射光谱的分析，研究了PVK与Alq3之间的 能量传递规律.当Alq3与PVK的质量比为1∶7时，能量传递效率最高.用一个由单链模 型扩展到包括杂质的哈密顿量对实验进行模拟，发现该模型能够较好地解释有关的实验结果. 关键词： 吸收光谱 激发光谱 发射光谱 能量传递     

Zn(BTZ)2白色有机电致发光材料的合成及其器件制备

以PCl₃为脱水剂,将邻氨基硫酚与水杨酸脱水环化合成出2-(2-羟基苯基)苯并噻唑,并进一步将所得产物与乙酸锌反应合成出2-(2-羟基苯基)苯并噻唑螯合锌(Zn(BTZ)₂)材料。以该配合物作为发光层制备出结构为ITO/PVK:TPD/Zn(BTZ)₂/Al近白色电致发光器件,其色坐标位于白场之内(x=0.242,y=0.359),在驱动电压为16V时,亮度达3200cdm²,对应的量子效率为0.32%。进一步在Zn(BTZ)₂中掺入橙红色染料Rubrene,制成ITO/PVK:TPD/Zn(BTZ)₂:Rubrene/Al结构器件,实现了纯白色发光(色坐标值:x=0.324,y=0.343),非常接近于白色等能点,且量子效率达0.47%。最后对上述器件的发光和电学性能进行了深入的研究和探讨。     

Synthesis and Photochemical Properties of a New Substituted Phenol Covalently Linked to Ruthenium （Ⅱ） Tris-bipyridine Containing Four Ester Groups as Sensitizer

As photosensitizer for solar cell, a new ruthenium (Ⅱ) complex with four ester groups had been synthesized, in which a phenol substituted by {[(2-hydroxy-5-tert-butylbenzyl)(pyridyl-2-methyl)amino]methyl} is covalently linked to ruthenium (Ⅱ) tris-bipyridine. The structures of the new compounds were confirmed by NMR and ESI-MS spectra. The electrochemical and photochemical properties were also studied.     

The Isoelectric Point and the Points of Zero Charge of Fe-Al-Mg Hydrotalcite-like Compounds

The relation of the isoelectric point (IEP) and the point of zero net charge (PZNC) of the hydrotalcite-like compounds was discussed. It was found that the IEP does not equal to the PZNC and the IEP is higher than the PZNC. The structural positive charges existing in the HTlc,which cause the difference between the IEP and the PZNC. The effects of the structural positive charges of the HTlc on its IEP and PZNC are the same as the specific adsorption of metal cations.     

Additive Maps Preserving Nilpotent Operators or Spectral Radius

Let X be a （real or complex） Banach space with dimension greater than 2 and let B0（X） be the subspace of B（X） spanned by all nilpotent operators on X. We get a complete classification of surjective additive maps Ф on B0（X） which preserve nilpotent operators in both directions. In particular, if X is infinite-dimensional, we prove that Ф has the form either Ф（T） = cATA^-1 or Ф（T） = cAT＇A^-1, where A is an invertible bounded linear or conjugate linear operator, c is a scalar, T＇ denotes the adjoint of T. As an application of these results, we show that every additive surjective map on B（X） preserving spectral radius has a similar form to the above with ｜c｜ = 1.     

Bounds for the Least Laplacian Eigenvalue of a Signed Graph

A signed graph is a graph with a sign attached to each edge. This paper extends some fundamental concepts of the Laplacian matrices from graphs to signed graphs. In particular, the relationships between the least Laplacian eigenvalue and the unbalancedness of a signed graph are investigated.