Restoration of solar and star images with phase diversity-based blind deconvolution

The images recorded by a ground-based telescope are often degraded by atmospheric turbulence and the aberration of the optical system. Phase diversity-based blind deconvolution is an effective post-processing method that can be used to overcome the turbulence-induced degradation. The method uses an ensemble of short-exposure images obtained imultaneously from multiple cameras to jointly estimate the object and the wavefront distribution on pupil. Based on signal estimation theory and optimization theory, we derive the cost function and solve the large-scale optimization problem using a limited memory Broyden-Fletcher-Goldfarb-Shanno (L-BFGS) method. We apply the method to the urbulence degraded images generated with computer, the solar images acquired with the swedish vacuum solar telescope (SVST, 0.475m) in La Paima and the star images collected with 1.2-m telescope in Yunnan Observatory. In order to avoid edge effect in the restoration of the solar images, a modified Hanning apodized window is adopted.The star image till can be estored when the defocus distance is measured inaccurately. The restored results demonstrate that the method is efficient for removing the effect of turbulence and reconstructing the point-like or extended objects.     

Highly efficient Cherenkov radiation generation in the irregular point of hollow-core photonic crystal fiber

Highly efficient Cherenkov radiation(CR) is generated by the soliton self-frequency shift(SSFS) in the irregular point of a hollow-core photonic crystal fiber(HC-PCF) in our laboratory.The impacts of pump power and wavelength on the CR are investigated,and the corresponding nonlinear processes are discussed.When the average power of the 120 fs pump pulse increases from 500 mW to 700 mW,the Raman soliton shifts from 2210 nm to 2360 nm,the output power of the CR increases by 2.3 times,the maximum output power ratio of the CR at 539 nm to that of the residual pump is calculated to be 24.32:1,the width of the output optical spectrum at the visible wavelength broadens from 35 nm to 62 nm,and the conversion efficiency η of the CR in the experiment can be above 32%.     

夹套冰温库内流场的数值模拟

随着计算机技术的飞速发展,计算流体力学(CFD)越来越广泛地应用于各个领域。通过CFD对复杂流动问题进行研究,能够较精确地反映流场的流动情况。利用CFD技术对夹套冰温库内的流场进行了稳态数值模拟,分析了夹套冰温库内流场的分布情况,讨论了该库体结构下不同送风速度对库内流场均匀性的影响。研究表明,具有夹套结构的冰温库,库内流场分布均匀,采用顶部静压箱送风,底部四周回风的送回风方式,能够使库内形成自上而下的均匀活塞流,不同送风速度对冰温库内流场的影响很小。研究结果证明数值模拟能较好地反映现实情况。     

Converse flexoelectric effect in comb electrode piezoelectric microbeam

We demonstrate the converse flexoelectric effect in a lead zirconate titanate microbeam. The fringe electric field of a comb electrode induces converse flexoelectric responses in uniformly poled and depoled beams. The simulated electric field distribution shows that bending of the beam is induced by piezoelectric and _μ11${\mu }_{11}$, _μ12${\mu }_{12}$ flexoelectric coefficients. Simulations indicate that piezoelectric displacement occurs in different directions in the two opposite poled samples while flexoelectric displacement remains the same. This finding is verified by the displacement measurement results.     

Measurement of absolute phase Shift on reflection of thin films using white-light spectral interferometry

A novel method to measure the absolute phase shift on reflection of thin film is presented utilizing a white-light interferometer in spectral domain. By applying Fourier transformation to the recorded spectral interference signal, we retrieve the spectral phase function Ф, which is induced by three parts： the path length difference in air L, the effective thickness of slightly dispersive cube beam splitter Teff and the nonlinear phase function due to multi-reflection of the thin film structure. We utilize the fact that the overall optical path difference （OPD） is linearly dependent on the refractive index of the beam splitter to determine both L and Teff. The spectral phase shift on reflection of thin film structure can be obtained by subtracting these two parts from Ф. We show theoretically and experimentally that our new method can provide a simple and fast solution in calculating the absolute spectral phase function of optical thin films, while still maintaining high accuracy.     

Influence of the illumination on the subband structure and?occupation in AlxGa1?xN/GaN heterostructures

The subband structure and occupation in the triangular quantum well at Al _x Ga_1−x N/GaN heterointerfaces have been investigated by means of temperature dependent Shubnikov–de Haas (SdH) measurements at low temperatures and high magnetic fields under illumination. After the illumination of the heterostructures, the total two-dimensional electron gas concentration increases, and the SdH oscillation amplitudes are enhanced when there is no additional subband occupation. It is also found that the energy separation between the subbands decreases after the illumination. We suggest that the illumination decreases the electric field and thus weakens the quantum confinement of the triangular quantum well at Al _x Ga_1−x N/GaN heterointerfaces. The GaN layer is thought to be the primary contributor of the excited electrons by the illumination.     

Effect of dual-frequency clutter suppression in harmonic Doppler detection

Background

High-frequency Doppler imaging is highly potential for detection of blood flow in microcirculation. In a swept-scan system, however, the spectral broadening of tissue clutter limits the detectability of low-velocity flow signal. Conventionally, the scanning speed of transducer has to be reduced to alleviate the clutter interference but at the cost of imaging frame rate. For example, the blood velocity of 0.5 mm/s becomes detectable only with a scanning speed lower than 1 mm/s. In this study, an alternative method is examined by suppressing the clutter magnitude to reduce the interference to flow signal without sacrificing scanning speed.

Methods

The method of third harmonic (3f₀) transmit phasing can suppress the tissue harmonic clutter by transmitting at the fundamental and the additional 3f₀ frequencies to achieve mutual cancellation between the frequency-sum and the frequency-difference components of the second harmonic signal. With 3f₀ transmit phasing, the cut-off frequency of wall filtering can be reduced to preserve low-velocity flow without compromising the frame rate.

Results

Our results indicate that the 3f₀ transmit phasing effectively reduces the harmonic clutter magnitude and thus improves the flow signal-to-clutter ratio. Compared to the conventional counterpart, the clutter-suppressed color flow and power Doppler images show fewer clutter artifacts and is capable of detecting more low-velocity flow of microbubbles. The resultant color-pixel-density also improves with clutter suppression.

Conclusion

For the swept-scan high-frequency (>20 MHz) system, 3f₀ transmit phasing is capable of providing effective clutter suppression. With the same achievable scanning speed, the resultant Doppler image has higher sensitivity for low-velocity flow and is less susceptible to clutter artifacts.     

Study on parameters influencing analytical performance of laser-induced breakdown spectroscopy

Lens-to-sample distances, delay time, atmospheric condition, laser pulse energy, etc. had obvious effects on the analytical performance of laser-induced breakdown spectroscopy. In this paper, these parameters are investigated in greater detail and we will explain how they have influences on the analytical performance. The results show that the focal plane under the sample surface can improve precision and detection limit, and the delay time should be decided according to sensitivity and accuracy. Spectral line intensity is stronger in argon than helium, nitrogen and air gas environment. Pulse energy should exceed energy threshold (about 50 mJ) which can generate plasma, and the energy should not exceed about 300 mJ to avoid plasma shielding. Under optimum parameters, concentration relative standard deviation of C, Si, Mn, P, S, Ni, and Cr for low-alloyed steel (sample number 11278) which were measured 11 times is 2.37%, 2.18%, 2.23%, 7.8%, 9.34%, 1.92%, and 2.13%, respectively. And the detection limit of C, Si, Mn, P, S, Ni, and Cr for pure steel is 0.0045%, 0.0072%, 0.0069%, 0.0027%, 0.0024%, 0.0047%, and 0.0024%, respectively.     

电场中Eu原子电离阈移动的实验研究

提出了一种新方法, 精确确定了稀土Eu原子第一电离阈的位置. 先用脉冲电场对Eu原子的高激发Rydberg态进行延时场电离探测, 再通过反向静电场排除光电离和自电离等其他路径所产生的离子信号的干扰, 观察并研究了Eu原子第一电离阈随着电场移动的规律. 由此所确定的零场下第一电离阈的数值与采用其他方法所确定的文献值^{[1, 2]}相一致, 从而验证了该方法的可靠性.     

Interaction between graphene and the surface of SiO2

The interaction between graphene and a SiO(2) surface has been analyzed with first-principles DFT calculations by constructing the different configurations based on α-quartz and cristobalite structures. The fact that single-layer graphene can stay stably on a SiO(2) surface is explained based on a general consideration of the configuration structures of the SiO(2) surface. It is found that the oxygen defect in a SiO(2) surface can shift the Fermi level of graphene down which opens up the mechanism of the hole-doping effect of graphene adsorbed on a SiO(2) surface observed in a lot of experiments.