动力学分光光度法测定痕量硫氰酸根的研究

利用SCN~-对溴酸钾氧化罗丹明B反应的抑制作用。建立了动力学光度法测定痕量SCN~-的新方法。检出限为0.30ng SCN~-/ml,测定范围为0.30～8.3ngSCN~-/ml.应用于吸烟者与不吸烟者尿中SCN~-的测定。结果较为满意。     

六钨酸四丁基铵盐和异丙醇体系的催化氧化反应的ESR研究Ⅰ.

本文研究了六钨酸四丁基铵盐在紫外光辐照的条件下催化氧化异丙醇为丙酮的反应。采用自旋捕捉技术与电子自旋共振相结合的方法,在位检测到氧化反应过程中有活泼自由基中间体产生,并观察到光电流产生。文中对六钨酸四丁基铵盐的催化反应机理进行了讨论。     

Deposition of Layer－by－layer Inorganic－organic Nano－hybrid Ultrathin Films onto SBA－15

Deposition of inorganic-organic nano-hybrid ultrathin films onto mesoporous silicate materials has been proven possible by using layer-by-layer assembly method. In combination with sol-gel method, titania, subsequently dye molecules (or polymer) were successfully fabricated onto the inner wall of SBA-15. Their structures were preliminarily characterized by FTIR and solid-state UV-Vis spectroscopy, thermal analysis, and BET surface area measurements,respectively.     

2-氯-2-氧代(硫代)-1, 3, 2-二氧磷杂环己烷的甲醇解及其开环 异构化反应

报道了trans-2-氧代-2-氯-4-苯基-5,5-二甲基-1,3,2-二氧磷杂环己烷以及cis-2-硫代-2-氯-4-苯基-5,5-二甲基-1,3,2-二氧磷杂环己烷甲醇解反应的立体化学。结果表明,反应体系的酸碱性对前者甲醇解反应的立体化学有着重要影响。而硫代环磷酰氯在碱性条件下的甲醇解反应存在一个开环异构化过程。     

AB5型球形合金粉的表面处理研究

由雾化（Gas－atomization）技术制备的AB5型球形合金粉，作为镍氢电池负极材料具有很多优点：粉粒呈球状便于在多孔基片内装填；耐压耐磨性好；抗碱能力强且不易解胶．但它的电化学初活性差，难于活化．有碍电池中的应用．采用适宜的氧化剂（铜盐水溶液）处理，使球粒表面形成一个富铜、富镍亚层，显著地改善了合金粉的电化学活性．经处理的MlNi3.8CO0.5Mn0.3Al0.4球形合金粉，仅3次充放电循环其放电量便可达到240mA·h·g-1；而未经处理的同一合金粉即便经6次充放电循环其放电量也只有103mA·h·g-1．     

钠硼硅酸盐玻璃分相及浸析的NMR研究

用多种ＮＭＲ方法，包括＾２９Ｓｉ、＾２３Ｎａ，＾１１Ｂ ＭａＳ及＾２９Ｓｉ ＣＰ／ＭＡＳ ＮＭＲ，研究了一定组成的ａ２Ｏ－Ｂ２Ｏ３－ＳｉＯ２三元体系玻璃在不同温度下分相处理２４小时及用酸浸析处理后的结构变化。结果表明，在低于分相上界临界温度的范围内，存在着一个温度转折点，低于这一温度时，受动力学因素影响，分相未达平衡态，温度愈低，距平衡态愈过，分相愈下完全。超过这一温度，分相可达平衡态，受热力学控     

聚丙烯中空纤维膜的微孔结构的控制

通过熔纺／冷拉伸法制备了微孔聚丙烯中空纤维膜。研究了工艺条件对微孔聚丙烯中空纤维膜的微孔结构与性能的影响。结果表明：随着纺丝温度的下降或熔体拉伸比的提高，最大可几孔径及孔隙率增大；熔纺中冷却风速提高，最大可几孔径及孔隙率较大；温度低于110℃时，热处理对最大可几孔径及孔隙率的影响较小，在120－130℃时，随着热处理温度的增加，最大孔径及孔隙率有明显增加的趋势；随着初纺中空纤维拉伸倍数的增加，孔隙率先增加而后下降。     

二价氯化稀土催化丁二烯聚合的活性

<正> 稀土催化聚合双烯烃的研究表明,不同稀土元素的催化活性极不一样,对此虽有不同的解释,但通常公认Sm、Eu等活性骤低,可归之于它们在制备催化剂过程中极易被烷基铝从三价还原到二价,又根据大部分具活性的其它稀土元素在催化体系中总是三价的事实,进而推断:只有在体系中能保持三价的稀土化合物方有产生活性的可能,二价化合物则不具活性。然而,由于二价稀土化合物,特别是除Sm、Eu之外的二价化合物难以制得,迄今为止并无直接的实验事实来判断这些推断是否正确。     

A microfluidic device using a green organic light emitting diode as an integrated excitation source

A simply fabricated microfluidic device using a green organic light emitting diode (OLED) and thin film interference filter as integrated excitation source is presented and applied to fluorescence detection of proteins. A layer-by-layer compact system consisting of glass/PDMS microchip, pinhole, excitation filter and OLED is designed and equipped with a coaxial optical fiber and for fluorescence detection a 300 microm thick excitation filter is employed for eliminating nearly 80% of the unwanted light emitted by OLEDs which has overlaped with the fluorescence spectrum of the dyes. The distance between OLED illuminant and microchannels is limited to approximately 1 mm for sensitive detection. The achieved fluorescence signal of 300 microM Rhodamine 6G is about 13 times as high as that without the excitation filter and 3.5 times the result of a perpendicular detection structure. This system has been used for fluorescence detection of Rhodamine 6G, Alexa 532 and BSA conjugates in 4% linear polyacrymide (LPA) buffer (in 1 x TBE, pH 8.3) and 1.4 fmol and 35 fmol mass detection limits at 0.7 nl injection volume for Alexa and Rhodamine dye have been obtained, respectively.     

Preparation of Polyclonal Antibodies Against Testis-specific Protease 50 and Characterization of Antibody Specificity

Introduction TheTSP50genehasbeenidentifiedasoneofthe testis specificoncogenes,whichisexpressedathigh levelsinapproximately92%ofhumanbreastcancer samples,makingitanattractivemolecularmarkerand apotentialtargetfordiagnosisandtherapy[1].Itisho mologoustomany…