Determination of the fluoride distribution in rabbit bone using instrumental neutron activation analysis

An instrumental neutron activation analysis (INAA) technique, based on the¹⁹F(n,)²⁰F reaction, has been development for the determination of fluoride in bone. The purpose was to study fluoride distribution in different kinds of bone samples using a rabbit model. The rationale for the study stems from the posible correlation between fluoride in bone and osteoporosis. The sodium concentration in the bone was used to correct the²⁰F peak area for the²³F(n,)²⁰F contribution. Two secondary standards, teflon tape and teflon coated dacron line, were used to quantify fluoride concentration. They proved to be stable and consistent with respect to their fluoride concentration. Bone specimens from 10 sites and two tooth samples were analyzed for fluoride. Fluoride concentration ranged from 305 ppm in the tibia long bone to 585 ppm in the humerus trochanter end and the magnitude of fluoride concentration levels is age depdentent. The detection limit of the fluoride is approximately 5 ppm using a 100 mg bone sample.     

Phenylsulfonyl ene-allenes as efficient precursors to bicyclic systems via intramolecular [2 + 2]-cycloaddition reactions

Various phenylsulfonyl allene derivatives were prepared with double bonds tethered either to the alpha-position or the gamma-position of the allene. These substrates underwent a highly regio- and stereospecific thermal [2 + 2]-cycloaddition across the nonactivated cumulene double bond, forming distal cycloadducts (i.e., 57) in the case of alpha-tethered allenes and proximal adducts (i.e., 25) in the case of gamma-tethered allenes. The mechanistic rationale for the observed stereospecificity involves initial diradical formation, followed by a rapid ring closure to the more stable cis-fused ring system. The tether may be equipped with heteroatoms, allowing for the formation of fused heterocycles (e.g., 61), and the cycloaddition can be facilitated by the introduction of sterically bulky groups and/or by conformational rigidity to the tether. Other modes of cyclization were observed in the presence of sodium benzenesulfinate or Lewis acids, in which cases polar mechanisms prevail. The chemoselectivity is reversed for [4 + 2]-cycloadditions, which prefer instead to engage the vinyl sulfone moiety, independent of whether the tether is attached to the alpha- or gamma-position of the allene.     

Three-dimensional hydrogen-bond geometry and probability information from a crystal survey

Summary An extensive crystal survey of the Cambridge Structural Database has been carried out to provide hydrogen-bond data for use in drug-design strategies. Previous crystal surveys have generated 1D frequency distributions of hydrogen-bond distances and angles, which are not sufficient to model the hydrogen bond as a ligand-receptor interaction. For each hydrogen-bonding group of interest to the drug designer, geometric hydrogen-bond criteria have been derived. The 3D distribution of complementary atoms about each hydrogen-bonding group has been ascertained by dividing the space about each group into bins of equal volume and counting the number of observed hydrogen-bonding contacts in each bin. Finally, the propensity of each group to form a hydrogen bond has been calculated. Together, these data can be used to predict the potential site points with which a ligand could interact and there-fore could be used in molecular-similarity studies, pharmacophore query searching of databases, or de novo design algorithms.     

Ab initio quantum-mechanical calculations on trifluoromethylamine

Extensive ab initio molecular-orbital calculations were carried out on trifluoromethylamine (TFM) to elucidate changes in geometry and electronic structure upon fluorination. The calculations show that the decomposition of CF₃NH₂ is slightly endoenergetic, and the heats of atomization of CF₃NH₂ and CH₃NH₂ show decreased stability of the species upon fluorination. Characteristic of CF₃NH₂ is a highly polar, strong, short CN bond. More limited calculations were carried out on CF₃OH and CH₃OH, and the electronic structure of CF₃OH is found to be generally similar to that of CF₃NH₂. The reduced basicity of the fluorinated amine cannot be ascribed to the inductive effect; the enhanced acidity of the fluorinated alcohol reflects the weakening of the OH bond. No evidence leads to a confirmation of the existence of nitrogen–fluorine hyperconjugation in the fluorinated amine.     

Minimization of water vapor interference in the analysis of non-methane volatile organic compounds by solid adsorbent sampling

Water vapor can be a significant interference in the analysis of air for non-methane volatile organic compounds (NMVOCs) using solid-adsorbent sampling techniques. The adsorbent materials used in sampling cartridges have different hydrophobic characteristics, and it is therefore necessary to characterize solid-adsorbent cartridges over a wide range of humidity. Controlled humidity experiments were performed to assess the extent of water vapor interference when samples are collected onto AirToxics solid-adsorbent cartridges. It was found that elevating the temperature of the cartridge to 10 degrees C above the temperature of the air sample greatly reduced water vapor adsorption and interferences and resulted in > or = 90% recovery of NMVOCs, biogenic VOCs and chlorofluorocarbons. Similar collection efficiencies were obtained at ambient temperature by reducing the relative humidity to > or = 60% in the sample by dilution with dry, scrubbed ambient air. A procedure also was developed and optimized for dry-purging cartridges prior to analysis. However, under optimized conditions, significant losses of C3-C5 compounds still occurred under highly humid conditions. It was determined that these losses were due to reduced retention during sampling rather than loss during the dry purge procedure. The dry purge method was shown to be adequate at high humidities for sampling NMVOCs with retention indices greater than 500.     

Dications of fluorenylidenes. The effect of substituent electronegativity and position on the antiaromaticity of substituted tetrabenzo[5.5]fulvalene dications

Oxidation of 3,6-disubstituted tetrabenzo[5.5]fulvalenes by SbF(5) results in the formation of dications that behave like two antiaromatic fluorenyl cations connected by a single bond. Both fluorenyl systems exhibit the paratropic shifts and nucleus independent chemical shifts (NICS) characteristic of antiaromatic species. Comparison with analogous 2,7-disubstituted tetrabenzo[5.5]fulvalenes reveals that the antiaromaticity of the substituted ring system can be altered substantially by changes in the placement of the substituents, possibly due to changes in the delocalization of charge in the system. Substituents in the 3,6-position decrease the antiaromaticity because of the increase in the benzylic resonance compared to 2,7-substituents.     

Isolation and structure of [HC[CH(SiMe(3))(SnMe(3))](2)](+): a remarkably stable sec-alkyl cation

The reaction of the tin-substituted propene Me3Sn(R)CHCH=CHR (R = SiMe3) with MCl4 in dichloromethane in the presence of Me3SnCl gives the first examples of isolable sec-alkyl carbocation salts, [HC{CH(R)SnMe3}2]+M2Cl9- (M = Zr, Hf). The compounds are thermally stable and, unlike previously isolated trialkyl carbocations, do not require superacidic media or weakly coordinating anions for stability. The crystal structure and DFT calculations suggest polarization of the Sn substituents and hyperconjugation as the reason for the unexpected stability. The stabilizing effect of tin is significantly stronger than that of Si. The carbocations are effective initiators for the polymerization of isobutene, isoprene, and alpha-methylstyrene.     

Longitudinal nuclear relaxation measurements in hcp H2

Measurements of T₁ in the hep phase of H₂, over the temperature range 2°–12°K and the ortho concentration range between 0.5 and 0.97 are presented. At temperatures below 10°K, the thermally activated self-diffusion is negligible and the mechanism for nuclear relaxation is that attributed by Moryia and Motizuki and by Harris to intramolecular dipolar interaction, modulated by intennolecular electric quadrupole-quadrupole (EQQ) interaction. The gaussian approximation for the correlation function was used by these authors to predict T₁. From the comparison between experiment and theory, we determine the EQQ parameter Γ/k_B to be 0.67°K. Above 10°K the effect of diffusion influences T₁, and the experimental results for an 88 per cent ortho H₂ sample up to the melting point suggest that the relaxation mechanisms resulting from EQQ interaction and diffusion are not independent of one another.