Flow‐Injection Online Reduction Atomic Fluorescence Spectrometry Determination of Se(IV) and Se(VI) with Electrochemical Hydride Generation

Abstract

A new flow‐injection online reduction electrochemical hydride generation system for the determination of Se(IV) and Se(VI) by atomic fluorescence spectrometry (AFS) was developed. In the system, an electromagnetic induction oven was used as heating resource to reduce Se(VI) to Se(IV) and a homemade tubular electrolytic cell as hydride generator. All analytical procedures were automatically controlled by a computer. The conditions of online reduction, including temperature, HCl concentration, and reduction time, have been studied in detail. The detection limits (3σ) of Se(IV) and Se(VI) in aqueous solution were 0.26 µg L^?1 and 0.23 µg L^?1, respectively. The precision for 11 replicate measurements of 50 µg L^?1 Se(IV) and Se(VI) was 2.2% and 2.5%. This proposed method has been applied to the determination of Se(IV) and Se(VI) in springwater samples.     

Formation of hydrophobic coating on PMMA surface using unipolar nanosecond-pulse DBD in atmospheric air

Dielectric barrier discharge (DBD) can modify the material surface and result in complicated physical and chemical reactions to improve the surface hydrophilicity, which is proved to be an effective method for surface modification. Compared with the traditional ac-excitation DBD, the DBD using unipolar pulses can avoid local overheat of microdischarges and can improve discharge efficiency under some conditions. In this paper, DBD excited by repetitive unipolar nanosecond generator was used to improve the hydrophobicity of Plexiglass (PMMA) surface by means of the interaction between air plasma and silicone oil. The output voltage had a rise time of 40 ns and a full width at half maximum of about 70 ns. The surface hydrophobicity of the PMMA, before and after the surface modification, was evaluated via the contact angle measurement under different experimental conditions. The values of the contact angle shown in this paper were the average of eight measured values, and the standard deviations were also calculated. The surface energy including polar and dispersion components was calculated using the measured average contact angles of distilled water and polyethyleneglycol. The results showed that, as the increase of the discharge voltage, the contact angle increased but the surface energy decreased. With the increase of treatment time, the water contact angle of the modified surface increased at the beginning, and it would reach to a maximum at 7.5 min treatment, and then decreased. The effect of pulse frequency on the modification results was different at various treatment times. In addition, the possible physical and chemical reaction among the DBD plasma, silicone oil and the PMMA surface was discussed.     

Ultrasonic evidence for short-range charge-ordering state in the low-doping regime of La1– x Sr x FeO3 (1/3 ≤ x ≤ 0.45)

The longitudinal ultrasonic velocity (V) and attenuation at a frequency of 10?MHz, as well as magnetization and resistivity, have been measured in the single-phase polycrystalline La_{1– x} Sr _x FeO₃ (x?=?1/3, 0.4, 0.45). Upon cooling down from high temperature, a slight softening in V and dramatic stiffening are observed in all samples, and this stiffening is coincided with a big attenuation peak. The relative increase of V is proportional to the Sr concentration, which implies that this anomaly is strongly correlated with Fe⁴⁺. However, no obvious changes in magnetic and electric properties are found at this temperature range. The analysis suggests that this feature may be caused by the Jahn–Teller effect of Fe⁴⁺ and correspond to the formation of short-range charge-ordering state.     

Effect of Environment on the Scattering of Electrons by a Junction of Different Topological Materials

The studies of electron transport through a junction of topological materials in the literature so far ignore the coupling of a topological material to its surrounding environment. Here, the dynamics of an open system through a stochastic Hamiltonian are simulated to investigate the influence of the environment on the scattering of electrons by a junction of different topological materials, such as a Dirac–Weyl magnetic junction and a topological insulator. It is found that, although the detrimental effect of the environment is inevitable, the Landauer conductance can be enhanced via adjusting the system–environment coupling strength. This result supplies the possibilty of changing the transport feature of topological materials by modulating the surrounded environment. It is also demonstrated that a non-Hermitian Hamiltonian can be used to replace the stochastic Hamiltonian for this study, when the system and the environment coupling are weak.     

氮杂冠醚的研究Ⅱ.N-取代苯并氮杂冠醚的1H和13CNMR谱

本文研究了15种新合成的单、双N取代二苯并18冠6的¹H及¹³C NMR谱。结果表明,¹³C NMR谱的化学位移能显示分子的电荷分布,而¹H NMR谱的偶合常数则部份地反映了大环的构象。氮原子的杂入大环结构和取代基的改变对聚醚环上的电荷分布影响的结果说明,这些改变可能会对冠醚的络合作用发生影响。     

Orientation dependence of structural transition in fcc Al driven under uniaxial compression by atomistic simulations

By molecular dynamics simulations employing an embedded atom method potential,we have investigated structural transformations in single crystal Al caused by uniaxial strain loading along the [001],[011] and [111] directions. We find that the structural transition is strongly dependent on the crystal orientations. The entire structure phase transition only occurs when loading along the [001] direction,and the increased amplitude of temperature for [001] loading is evidently lower than that for other orientations. The morphology evolutions of the structural transition for [011] and [111] loadings are analysed in detail. The results indicate that only 20% of atoms transit to the hcp phase for [011] and [111] loadings,and the appearance of the hcp phase is due to the partial dislocation moving forward on {111} fcc family. For [011] loading,the hcp phase grows to form laminar morphology in four planes,which belong to the {111} fcc family; while for [111] loading,the hcp phase grows into a laminar structure in three planes,which belong to the {111} fcc family except for the (111) plane. In addition,the phase transition is evaluated by using the radial distribution functions.     

LD泵浦Nd∶LuVO4/Cr4+∶YAG被动调Q激光器

采用大功率半导体激光器端面泵浦Nd∶LuVO4晶体，利用Cr4+∶YAG晶体作为可饱和吸收元件，实现了1.06 μm激光的被动调Q运转.在泵浦功率为19.1 W时，获得最高平均输出功率为4.58 W，脉冲宽度为84 ns，单脉冲能量为36.6 μJ以及峰值功率为436.2 W的激光脉冲.     

周期性梯度折射率多层膜的软X射线反射率

由于界面互扩散的存在,实际的超薄多层膜很难具有清晰的界面结构.假设超薄多层膜为具有周期性梯度折射率的多层膜结构,用直线模型和余弦模型模拟了周期性梯度折射率多层膜的软X射线反射率.结果证明,折射率余弦渐变的多层膜虽然不具有清晰的界面,但它同样具有很高的反射率.     

Defect-induced failure of optical coating filters

Optical filters composed of Ag, Al₂O₃, and ZnSe films were prepared on BK7 substrates by evaporation. By employing spectrophotometer, microscope, scanning electron microscope (SEM), and energy dispersive spectrum (EDS) analysis, the moisture-dependent stability of the samples was tested. The experimental results revealed that filter failure often occurs initially at defect sites. Small sputtering particles and pinhole are found to be two types of defects that induced the optical coating filter failure. The mechanisms of the defect-induced failure of the filters also are discussed in the article.     

Optical travelator: transport and dynamic sorting of colloidal microspheres with an asymmetrical line optical tweezers

We report the transport, funnelling and dynamic sorting of colloidal microspheres in an aqueous suspension using line optical tweezers with asymmetrical intensity profiles. The line tweezers readily trapped and propelled the microspheres along the length of the line tweezers. Using this simple technique, transporting and funnelling of microspheres within a microscopic region were demonstrated. To illustrate the dynamic particle-sorting capability of the line tweezers, a binary colloidal system comprising of microspheres with diameters of 1.1 μm and 3.2 μm were driven past the line tweezers by electrophoresis. As the optical trapping force is dependent on the size of the microspheres, the line tweezers was able to change the path of the larger spheres while exerting little influence on the smaller spheres thus sorting the two types of microspheres. At optimized laser power and flow rate of microspheres, sorting efficiency greater than 90% has been achieved. PACS 42.15.Eq; 87.80.Cc; 87.80.Fe; 82.70.Dd