Synthesis, Characterization and the Effect of Glucose-lowering of Guanidino Acid Oxovanadium（Ⅳ） Complexes

Two guanidino acid oxovanadium(Ⅳ) complexes have been synthesized. Preliminary tests in vivo have shown that the two title complexes all display lowering glucose activity in vivo to STZ-rats. The effect of glucose-lowering of guanidino acetic acid oxovanadium(Ⅳ) complex in vivo is higher than that of guanidino propanoic acid oxovanadium(Ⅳ) complex.     

反应条件对Mo2C/Al2O3催化的POM制合成气的影响

考察了反应温度、气体空速和进料中CH4：O2比值对Mo2C／Al2O3催化的POM反应制合成气的影响．结果发现较高的温度具有较高的甲烷转化率、CO和H2的选择性；而在较低的温度下，对CO的选择性比对H2的影响更大．反应气体的空速较小时对于甲烷的转化率、CO和H2的选择性是有利的；而在较高的气体空速下，氢气的选择性则更低．进料中CH4：O2比值稍高于2：1时有利于获得高的甲烷转化率、CO和H2的选择性．并且还可以增加催化剂的稳定性．当CH4：O2比值低于2：1时．甲烷转化率、CO和H2选择性随反应的进行急剧下降．而当此比值调整到高于2：1时．转化率和选择件都可以得到恢复。     

炭气凝胶及其有机气凝胶前驱体的研究进展

介绍了炭气凝胶及其有机气凝胶前驱体的发展概况，着重总结了制备工艺条件(如催化剂及其浓度、反应物总浓度、反应物配比、溶剂、反应温度及时间、超临界干燥工艺条件和炭化工艺条件等)对有机气凝胶及其相应炭气凝胶中孔网络结构的影响，综述了中孔网络结构改性研究的进展．     

WATER-BLOWN POLYURETHANE RIGID FOAMS MODIFIED BY CHEMICAL PLASTICATION

1. INTRODUCTIONThese years, HCFC-141b may be the most used blowing agent for its useful properties. But, because of its high global warming effect leading to the destruction of the ozone layer, production of HCFC141b has been forbidden. However, there are…     

提高接肽缩合率的研究进展

本文针对多肽合成中缩合反应存在"困难肽段"的情况, 反析了影响缩合率的原因,归纳了改善缩合率的措施。 它们对提高经典液相法及固相法肽合成的质量均有实际意义。     

膦、胂叶立德的化学与应用——Ⅰ.用红外光谱对膦、胂叶立德结构的研究

以78个带吸电子取代基的膦、胂叶立德的红外光谱的解析为根据,讨论了它们的结构及其与光谱的关系。     

丙烯酸Fe3+型树脂在非水介质中对鞣酸的配位吸附及洗脱性能

将Fe3 载于丙烯酸树脂上,制备了在非水介质中对鞣酸具有良好吸附性能的配位吸附树脂.在甲醇中,树脂对鞣酸的吸附符合Langmuir单分子层吸附模型,静态饱和吸附量为34mg/g,吸附为粒扩散控制过程.动态吸附中,树脂对鞣酸的泄漏吸附量为25mg/g,饱和吸附量32mg/g.采用5%的甲胺乙醇溶液作洗脱剂,洗脱率95%.树脂在吸附及洗脱过程中未见Fe3 脱落.     

Study on thermal stability of poled non-linear optical polymers

A logarithmic expression is proposed to describe relaxation of the polar order in side chain polymers,together with a new way of plotting temperature dependent relaxation data.This results in a straight line extending even below the glass transition temperature in the case of poled nonlinear optics (NLO) side chain polymers.A simple procedure to determine the rotational diffusion constant Dr is given and Dr values of several polymer systems have been evaluated and compared with each other.It appears that,starting from the conventional and well known poled polymer system currently applied,a further lowering of Dr by about 3 orders of magnitude is necessary in order to reach an acceptable orientational stability or lifetime of poled polymers for practical applications.Attempts have been made to introduce electron push-pull substituents into high thermostable molecular frameworks and results of preliminary measurements are reported.     

On the Criteria of Instability for Electrochemical Systems

Both cyclic-voltammetry-based and impedance-based experimental criteria that have been developed recently for the oscillatory electrochemical systems are critically appraised with two typical categories of oscillators.Consistent conclusions can be drawn by the two criteria for the category of oscillators that involve the coupling of charge transfer mainly with surface steps(e.g.ad-and desorption)such as in the electrooxidation of C1 organic molecules.Whereas,impedance-based criterion is not applicable to the category of oscillators that involve the coupling of charge transfer mainly with mass transfer(e.g.diffusion and convection) such as in the Fe(CN)6^3- reduction accompanying periodic hydrogen evolution.The reason is that the negative impedance cannot include the feedback information of convection mass transfer induced by the hydrogen evolution.However,both positive and negative nonlinear feedbacks,i.e., the diffusion-limited depletion and convection-enhanced replenishment of the Fe(CN)6^3- surface concentration,that coexist between the bistability,i.e.,Fe(CN)6^3- reduction with and without hydrogen evolution at lower and higher potential sides respectively,are all reflected in the crossed cyclic voltammogram(CCV).It can be concluded that the voltammetry-based criterion(in time domain)is more intuitive,less time-consuming and has a wider range of applications than the impedancebased one (in frequency domain).     

SOME BLENDING INTERPOLATION METHODS IN CAGD

Some of the blending interpolation methods (which) stated by a convex combination technique are presented. This includes C1 ,C2 blending triangular interpolanls and C1 -blending quadrilateral inter polanls for surfaces. The mentioned methods can be generalized to the construction of C" blending interpolants.