KNSBN晶体猫式互抽动相位共轭光特性

在KNSBN：Ce晶体中，利用二波耦合作用，在单一光束无法获得相位共轭光的条件下，实现了“猫”式互抽运相位共轭光输出，获得较高的共轭光发射率，实验结果表明，晶体的二波耦合作用可以使晶体的自抽运相位共轭光的阈值光强降低。入射光的入射角范围增大，响应时间缩短。     

Pt(110)表面自吸附原子能量和力的改进分析型嵌入原子法分析

采用改进分析型嵌入原子法计算了Pt(110)表面自吸附原子的能量和法向力.当Pt吸附原子位于Pt(110)表面第一层原子的二重对称洞位上0.11nm时最稳定.Pt吸附原子的最佳迁移路径是由一个二重对称洞位沿密排方向迁移到最近邻的另一个二重对称洞位.在吸附原子远离表面的过程中，将依次经过排斥、过渡和吸引等三个区域.在排斥区和过渡区，由于吸附原子与表面原子间强的相互作用势，吸附原子的能量和法向力的形貌图均为(110)面原子排列的复形，与对势理论和嵌入原子法得到的结果一致.在吸引区，由于多体相互作用及晶体中原子 关键词： 金属表面 自吸附 能量 力     

一类多线性积分算子的端点有界性

本文对一类相关于非卷积型算子的多线性算子,证明了其在端点情形上的有界性,该算子包括Littlewood-Paley算子和Marcinkiewicz算子．     

广义Hénon映射的滑模变结构控制同步

基于可线性化的非线性离散变结构跟踪控制方法实现了广义Hénon映射混沌系统的同步.广义Hénon映射的混沌吸引子比Hénon映射的混沌吸引子要复杂得多,对于保密通信来说,这种复杂性正是所期望的.提出的同步方法允许参数有适当的失配程度,这对工程实现是非常有利的,理论分析和仿真结果证实了该方法的有效性 关键词： 广义Hénon映射 混沌 同步 变结构控制     

Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007     

纳米尺寸的ZnO晶体高压相变的拉曼散射研究(英文)

Weperformedthehigh-pressureRaman measurementofthethreenanosizedZnOcrystals. Wefoundthesmallerthesize,thehigherthe pressuretoinducethephasetransitionfrom w櫣rzitetorock-saltstructure. High-pressureRamanmeasurementsof nona-shapedZnOcrystalswerepreformed.The…     

Operator‐splitting method for the analysis of cavitation in liquid‐lubricated herringbone grooved journal bearings

This paper presents an operator‐splitting method (OSM) for the solution of the universal Reynolds equation. Jakobsson–Floberg–Olsson (JFO) pressure conditions are used to study cavitation in liquid‐lubricated journal bearings. The shear flow component of the oil film is first solved by a modified upwind finite difference method. The solution of the pressure gradient flow component is computed by the Galerkin finite element method. Present OSM solutions for slider bearings are in good agreement with available analytical and experimental results. OSM is then applied to herringbone grooved journal bearings. The film pressure, cavitation areas, load capacity and attitude angle are obtained with JFO pressure conditions. The calculated load capacities are in agreement with available experimental data. However, a detailed comparison of the present results with those predicted using Reynolds pressure conditions shows some differences. The numerical results showed that the load capacity and the critical mass of the journal (linear stability indicator) are higher and the attitude angle is lower than those predicted by Reynolds pressure conditions for cases of high eccentricities. Copyright © 2004 John Wiley & Sons, Ltd.     

Self-assembled DNA-conjugated polymer for novel DNA chip.

We developed DNA-conjugated polymer for DNA chip fabrication. A 30 mer probe DNA and disulfide bridges were covalently attached to the polymer side chain. The DNA-conjugated polymer can be specifically adsorbed on a gold substrate surface by a self-assembly technique. The interaction between fully matched DNA and DNA-conjugated polymer was investigated by surface plasmon resonance (SPR) technique. The DNA-conjugated polymer-modified gold surface highly recognized fully matched DNA, rather than unmatched DNA. Therefore, DNA-conjugated polymer can be used for novel DNA chip fabrication.     

Triterpenoid Constituents of Huperzia miyoshiana

Thirteen triterpenoids, including three new ones, miyoshianois A (1), B (2) and C (3), were isolated from Huperzia miyoshiana. The structures of these new compounds were established as 3-O-dihydroferuloyltohogenol (1), 16-oxo-3β,21β-dihydrox-y-serrat-14-en-24-ferulate (2) and 16-oxo-3a, 21β-dihydroxy-serrat-14-en-24-ferulate (3), respectively, on the basis of their spectroscopic analysis.