一阶导数吸光光度法测定碘酸钾碘盐中碘

采用一阶导数吸光光度法测定碘酸钾碘盐中碘 ,线性范围为 0～ 12 μg·ml-1,检出限为1.6μg·ml-1,对盐样进行重复测定 ,相对标准偏差≤ 1.9% ,对样品进行加标回收试验 ,回收率在 97.0 %～ 10 2 .5 % ,结果良好     

氧杂环丁烷热解机理的量子化学研究

本文利用半经验分子轨道理论研究了氧杂环丁烷热解为甲醛和乙烯的反应机理计算是采用半经验方法AM1进行的, 各种驻点全部运用Berny梯度方法优化. 同时, 对过渡态的结构进行了振动分析的确证. 计算表明: 1)不存在协同的同面-同面反应途径的过渡态, 其驻点只是一个二级鞍点; 2) 协同的同面-异面反应途径需要经过一个能量很高的过渡态; 3)有利的反应途径是包含了双自由基中间体的分步过程。     

2-硝基丙烯热解反应的理论研究

利用MO-AM1方法研究了2-硝基丙烯热解的反应途径。结果表明, 2-硝基丙烯可能首先热解产生一个四元环状中间体。该中间体依照分步过程继续分解时, 存在两种可能的途径, 其中先断N—O键的反应过程比先断C—C键的过程从能量上更为有利。反应过程中电荷无明显转移, 具有双自由基反应特点。     

乙基乙酰胺热解反应机理的MO研究

对于烷基乙酰胺的初始热解反应机理, 通常认为与酯类的热解反应相类似。Maccoll和Nagra通过对该热解反应的动力学研究, 认为两者存在不同。差异之一, 烷基乙酰胺存在两种可能的热解途径【参见本文(129页)前述反应方程(1),(2)】。而在酯类热解反应中(2)的活化能过高, 且四元环过渡态极不稳定。差异之二, 极性溶剂(比如乙酸)对酰胺热解反应的催化作用不明显, 而对酯类等气相热解反应的催化作用是十分显著的。为此, 我们用MINDO/3分子轨道法对乙基乙酰胺的初始热解反应进行了较全面的研究。用能量梯度法对此反应的反应物、中间体和生成物的平衡几何构型进行了全优化。(如图1所示)用极小能量途径法分别寻找反应(1)和反应(2)的初始过渡态, 继而用Powell法全优化过渡态的几何构型, 计算所得的过渡态TS1、TS2和TS3分别见图2a, 图3a和图4a。为了确证这些过渡态, 进行了振动分析研究, 结果表明这些过渡态的力常数矩阵的诸本征值中均只有一个负值, 且虚振动模式展示了走向各自的反应物和生成物的趋势, (如图2b,图3b和图4b所示)。它们的总能量及反应(1)和反应(2)的活化能列于表1. 对整个热解反应(1)作了内禀反应坐标(IRC)理论分析, 反应历程见图5所示. 与IRC相应的总能偶极矩以及部分关键的键长和原子净电荷变化一并列于表2.本文研究结果表明, 在乙基乙酰胺的初始反应中主反应即反应(1)与酯类反应相类似, ...     

Oxidative coupling of methane over Sr?Ti, Sr?Sn perovskites and corresponding layered perovskites

The layered perovskites Sr₂TiO₄ and Sr₂SnO₄ are more active and selective for the oxidative coupling of methane at 1073 K than the corresponding perovskites SrTiO₃ and SrSnO₃. The role of the surface oxygen species for this reaction is discussed.     

The research on the high quality TiO2, MoO3-doped WO3 electrochromic film

The high quality TiO2, MoO3-doped WO3 electrochromic film was prepared by the sol–gel method for the first time. The sol, which has hydrogen peroxide (H2O2) and oxalic acid (H2C2O4), was very stable at room temperature and quite suitable for the deposition of films. The WO3 electrochromic film prepared from this doped sol had excellent performance, such as short response time, no cracks, good adhesion to the substrate, high coloring efficiency and longevity of service.     

Simultaneous Determination of Four Flavonoids in Pigeonpea [Cajanus cajan (L.) Millsp.] Leaves Using RP-LC-DAD

A simple and accurate RP-HPLC method using photodiode array detection (PAD) was developed for the simultaneous determination of four flavonoids, namely quercetin (QU),luteolin(LU),apigenin(AP) and isorhamnetin (IS) in pigeonpea leaves.Extract samples were separated on HIQ SIL C₁₈V column using methanol-acetonitrile-water(31:10:59, v/v/v) as mobile phase.The flavonoids were detected at 254.5 nm for QU and IS, and at 345 nm for LU and AP.Contents were determined with satisfactory repeatability (R. S. D. < 2.2%) and recovery (97.27 – 99.98%). The developed method was found to be simple and efficient.     

Effect of multi-walled carbon nanotubes on non-isothermal crystallization kinetics of polyamide 6

The non-isothermal crystallization behaviors of multi-walled carbon nanotubes (MWNTs)/polyamide 6 (PA6) composites were investigated by differential scanning calorimetry (DSC). Three methods, namely, Avrami, Ozawa and Mo, were carried out to analyze the non-isothermal crystallization data. The results showed that the MWNTs in PA6 acted as effective nucleation agents. However the crystallization rate of composites obtained was lower than that of the neat PA6. It is indicated that the presence of MWNTs influenced the mechanism of nucleation and the growth of PA6 crystallites.     

Diterpene derivative and chromone from Hypericum perforatum

A novel diterpene derivative, 5-methyl-5-(4,8,12-trimethyl-tridecyl)-dihydro-furan-2-one (1) and a new chromone, 5-hydroxy-7-methoxy-3-methyl-chromen-4-one (2), along with a known compound, phytol (3) have been isolated from the aerial parts of Hypericum perforatum. Their structures were established on the basis of spectroscopic analysis and by comparison with published values.     

Molecular and nanoscale materials and devices in electronics

Over the past several years, there have been many significant advances toward the realization of electronic computers integrated on the molecular scale and a much greater understanding of the types of materials that will be useful in molecular devices and their properties. It was demonstrated that individual molecules could serve as incomprehensibly tiny switch and wire one million times smaller than those on conventional silicon microchip. This has resulted very recently in the assembly and demonstration of tiny computer logic circuits built from such molecular scale devices. The purpose of this review is to provide a general introduction to molecular and nanoscale materials and devices in electronics.