Experimental observation of stable bound solitons in a figure-eight fiber laser

Temporal bound solitons are observed experimentally in a passively mode-locked figure-eight fiber laser with a dispersion-imbalanced nonlinear optical loop mirror (DI-NOLM). Soliton interactions are suppressed by use of a spectral bandpass filter, and Gordon-Haus timing jitter is eliminated with a DI-NOLM, which removes the cw light component in the laser cavity. The bound solitons are found to be stable for several hours in the laser cavity when no external perturbation is applied.     

Nanomanipulator-assisted fabrication and characterization of carbon nanotubes inside scanning electron microscope

We have installed two nanomanipulators, which can travel about 20mm with a minimum increment of 1 nm, for manipulation of nanostructured materials inside field-emission scanning electron microscope (FE-SEM). Both manipulators render motions in x, y, and z directions, providing various manipulation freedoms such as moving, bending, cutting, and biasing. In addition, we have conducted in situ characterization of the electrical breakdown of multi-walled carbon nanotubes (MWCNTs). Our results demonstrate the possibility that MWCNTs can be used as a gas sensor.     

Effect of conformational heterogeneity on excitation energy transfer efficiency in directly meso-meso linked Zn(II) porphyrin arrays

We have investigated the overall excitation energy relaxation dynamics in linear porphyrin arrays as well as the energy transport phenomena by attaching an energy acceptor to one end of a linear porphyrin array by using steady state and time-resolved spectroscopic measurements. We have revealed that the solvation dynamics as well as the conformational dynamics contributes significantly to the energy relaxation processes of linear porphyrin arrays. Consequently, long porphyrin arrays no longer serve as good energy transmission elements in donor-acceptor linked systems due to conformational heterogeneities which provide the non-radiative deactivation channels as energy quenchers.     

Waveform preservation of the backscattered stimulated Brillouin scattering wave by using a prepulse injection

We have found that it is possible to preserve the temporal waveform of the reflected wave generated from stimulated Brillouin scattering (SBS) by using a prepulse technique. The waveform of the SBS wave usually shows a steep rising edge in the ordinary SBS process. It has been found that the waveform of the reflected wave depends on both the prepulse energy and the time delay between the main pulse and the prepulses. A prepulse energy of 5 mJ and a time delay of 5 ns have been measured to be the optimum values under the experimental conditions. This prepulse method is useful in developing a multistage system employing several SBS cells in series for high-power laser applications.     

Titania-Doped Silica Fibers Prepared by Electrospinning and Sol-Gel Process

Titania-doped silica fibers were prepared by electrospinning of the sol of silica containing titania. The electrospun fibers had ribbon type morphology. The fibers had significant quantities of hydroxyl groups of Si—OH and Ti—OH. The fibers did not have crystalline structure. Diameters of the fibers were reduced by solvent evaporation and calcination. The hydroxyl groups on the fibers disappeared by calcination. The hydroxyl groups, M—OH (MSi, Ti) were changed to M—O—M by intermolecular and intramolecular condensation reactions.     

Simultaneous acquisition of perfusion and permeability from corrected relaxation rates with dynamic susceptibility contrast dual gradient echo

This study compared two methods, corrected (separation of T(1) and T(2)* effects) and uncorrected, in order to determine the suitability of the perfusion and permeability measures through Delta R(2)* and Delta R(1) analyses. A dynamic susceptibility contrast dual gradient echo (DSC-DGE) was used to image the fixed phantoms and flow phantoms (Sephadex perfusion phantoms and dialyzer phantom for the permeability measurements). The results confirmed that the corrected relaxation rate was linearly proportional to gadolinium-diethyltriamine pentaacetic acid (Gd-DTPA) concentration, whereas the uncorrected relaxation rate did not in the fixed phantom and simulation experiments. For the perfusion measurements, it was found that the correction process was necessary not only for the Delta R(1) time curve but also for the Delta R(2)* time curve analyses. Perfusion could not be measured without correcting the Delta R(2)* time curve. The water volume, which was expressed as the perfusion amount, was found to be closer to the theoretical value when using the corrected Delta R(1) curve in the calculations. However, this may occur in the low concentration of Gd-DTPA in tissue used in this study. For the permeability measurements based on the two-compartment model, the permeability factor (k(ev); e = extravascular, v = vascular) from the outside to the inside of the hollow fibers was greater in the corrected Delta R(1) method than in the uncorrected Delta R(1) method. The differences between the corrected and the uncorrected Delta R(1) values were confirmed by the simulation experiments. In conclusion, this study proposes that the correction for the relaxation rates, Delta R(2)* and Delta R(1), is indispensable in making accurate perfusion and permeability measurements, and that DSC-DGE is a useful method for obtaining information on perfusion and permeability, simultaneously.     

Tuning of particle morphology and pore properties in mesoporous silicas with multiple organic functional groups

A synthetic method has been developed that can control both multifunctionalization and morphology of the mesoporous organic-inorganic hybrid materials by introducing different molar ratios of organoalkoxysilane precursors to a base-catalyzed co-condensation of silicate.     

Reversible switching of high-speed air-liquid two-phase flows using electrowetting-assisted flow-pattern change

This work is the first demonstration of electrical modulation of surface energy to reversibly switch dynamic high-speed gas-liquid two-phase microfluidic flow patterns. Manipulation of dynamic two-phase systems with continuous high-speed flows is complex and interesting due to the multiple types of forces that need to be considered. Here, distinct stable flow patterns are formed through a multipronged approach: both surface tension forces generated by surface chemistry modulation as well as viscous and inertial forces produced by fluid flows are employed. The novel fluidic actuation mechanism provides insights into better understanding microscale two-phase flow dynamics and offers new opportunities for the development of two-phase biochemical microsystems that are mechanically simple and operational at high speeds.