Light‐induced degradation of PECVD aluminium oxide passivated silicon solar cells

Light‐induced degradation (LID) has been identified to be a critical issue for solar cells processed on boron‐doped silicon substrates. Typically, Czochralski‐grown silicon (Cz‐Si) has been reported to suffer from stronger LID than block‐cast multicrystalline silicon (mc‐Si) due to higher oxygen concentrations. This work investigates LID under conditions practically relevant under module operation on different cell types. It is shown that aluminium oxide (AlOx) passivated mc‐Si solar cells degrade more than a reference aluminium back surface field mc‐Si cell and, remarkably, an AlOx passivated Cz‐Si solar cell. The defect which is activated by illumination is shown to be doubtful a sole bulk effect while the AlOx passivation might play a certain role. This work may contribute to a re‐evaluation of the suitability of boron‐doped Cz‐ and mc‐Si for solar cells with very high efficiencies. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Influence of the steel powder type and processing parameters on the debinding of PM compacts with gelatin binder

Binders present an important part of the powder metallurgy technology as they are vital to provide efficient powder agglomeration and/or lubrication during shaping. At the same time, they have to be easily removed from the compacts during initial stages of sintering without any harmful effect for the base material, as well as for the environment. Therefore, behavior of gelatin as a binder for stainless- and tool-steel gas-atomised powder compacts was studied by thermal analysis and electron microscopy. Thermal analysis showed that peak mass-loss occurred in the range between 340 and 370 °C, depending on the base powder and heating rate. Risk for base powder oxidation at temperatures below 425 °C was detected. Based on the obtained results, it is recommended to perform debinding at ~425 °C after applying a heating rate of around 7.5 °C min^?1. Only in this way efficient enough binder removal can be obtained concurrently to avoiding base powder oxidation.     

MVF Sensor Enables Analysis of Nucleic Acids with Stable Secondary Structures

One major challenge in nucleic acids analysis by hybridization probes is a compromise between the probe's tight binding and sequence‐selective recognition of nucleic acid targets folded into stable secondary structures. We have been developing a four‐way junction (4WJ)‐based sensor that consists of a universal stem‐loop (USL) probe immobilized on an electrode surface and two adaptor strands (M and F). The sensor was shown to be highly selective towards single base mismatches at room temperature, able to detect multiple targets using the same USL probe, and have improved ability to detect folded nucleic acids. However, some nucleic acid targets, including natural RNA, are folded into very stable secondary and tertiary structures, which may represent a challenge even for the 4WJ sensors. This work describes a new sensor, named MVF since it uses three probe stands M, V and F, which further improves the performance of 4WJ sensors with folded targets. The MVF sensor interrogating a 16S rRNA NASBA amplicon with calculated folding energy of ?32.82 kcal/mol has demonstrated 2.5‐fold improvement in a signal‐to‐background ratio in comparison with a 4WJ sensor lacking strand V. The proposed design can be used as a general strategy in the analysis of folded nucleic acids including natural RNA.     

Determination of the gas chromatographic elution sequences of the (+)- and (−)-enantiomers of stable atropisomeric PCBs on Chirasil-dex

Pure enantiomers of chiral (atropisomeric) polychlorinated biphenyls (PCBs) obtained by high-performance liquid chromatography were used to establish the gas chromatographic elution sequences of the (+)- and (−)-enantiomers of six PCB atropisomers on Chirasil-Dex. The elution order was found to be (−/+) for PCBs 84, 132, 136, and 176 and (+/−) for PCBs 135 and 174. The retention characteristics of all 19 tri- and tetra-ortho atropisomeric PCBs were also investigated. Nine of the atropisomers could be separated using this chiral selector. PCBs 95, 132, and 149 were completely resovled and PCBs 84, 91, 135, 136, 174, and 176 were partially separated (R = 0.7–0.9). All of the separated congeners are 2,3,6-substituted in at least one ring, and conversely – none of the congeners that lacks 2,3,6-substitution could be separated. Thus, chiral recognition and enantiomer separation seems to be strongly governed by 2,3,6-substitution.     

Chain transfer reactions in emulsion polymerization of butadiene/styrene

Calculation of regulating index r from M̄_W values determined by experiments is proposed. The calculation is based on the assumption that the M̄_W values only depend on the conversion and the regulating index in emulsion polymerization. On this basis the calculation of regulator concentration in the latex particles was also possible. M̄_W values calculated in this way and experimental M̄_W values show good agreement.     

A Chimeric DNA/RNA Antiparallel Quadruplex with Improved Stability

Nucleic acid quadruplexes are proposed to play a role in the regulation of gene expression, are often present in aptamers selected for specific binding functions and have potential applications in medicine and biotechnology. Therefore, understanding their structure and thermodynamic properties and designing highly stable quadruplexes is desirable for a variety of applications. Here, we evaluate DNA→RNA substitutions in the context of a monomolecular, antiparallel quadruplex, the thrombin-binding aptamer (TBA, GGTTGGTGTGGTTGG) in the presence of either K⁺ or Sr²⁺. TBA predominantly folds into a chair-type configuration containing two G-tetrads, with G residues in both syn and anti conformation. All chimeras with DNA→RNA substitutions (G→g) at G residues requiring the syn conformation demonstrated strong destabilization. In contrast, G→g substitutions at Gs with anti conformation increased stability without affecting the monomolecular chair-type topology. None of the DNA→RNA substitutions in loop positions affected the quadruplex topology; however, these substitutions varied widely in their stabilizing or destabilizing effects in an unpredictable manner. This analysis allowed us to design a chimeric DNA/RNA TBA construct that demonstrated substantially improved stability relative to the all-DNA construct. These results have implications for a variety of quadruplex-based applications including for the design of dynamic nanomachines.     

Application of flow-injection analysis in the on-line monitoring of sugars,lactic acid,protein and biomass during lactic acid fermentations

A laboratory system for the on-line monitoring of important lactic acid fermentation variables is described. The system contains flow-injection analysers for glucose, lactose, galactose, lactate and protein and a continuous-flow analyser for the biomass concentration. The sugar and lactate analysers are based on enzymatic reactions involving oxidases followed by chemiluminescence detection of the hydrogen peroxide formed. The protein analyser is based on the biuret reaction. The system has been used to monitor many fermentation experiments, and some results are presented as examples.