Isobar separation at FRS-ESR – a development towards pure isomeric stored beams

One important goal of the ILIMA project at FAIR is the study of masses and decay properties of relativistic isomeric beams stored and cooled in the planned storage-ring complex. A new scheme is described, where a storage-cooler ring is used for high-resolution mass separation. Experimental results on the separation of the isobaric pair ¹⁴⁰Pr-¹⁴⁰Ce are presented. P. Beller, deceased.     

Method of observation of low density interface states by means of X-ray photoelectron spectroscopy under bias and passivation by cyanide ions

X-ray photoelectron spectroscopy (XPS) measurements under bias can observe low density interface states for metal-oxide-semiconductor (MOS) diodes with low densities. This method can give energy distribution of interface states for ultrathin insulating layers for which electrical measurements cannot be performed due to a high density leakage current. During the XPS measurements, a bias voltage is applied to the rear semiconductor surface with respect to the ∼3 nm-thick front platinum layer connected to the ground, and the bias voltage changes the occupation of interface states. Charges accumulated in the interface states shift semiconductor core levels at the interface, and thus the analysis of the bias-induced shifts of the semiconductor core levels measured as a function of the bias voltage gives energy distribution of interface states. In the case of Si-based MOS diodes, the energy distribution and density of interface states strongly depend on the atomic density of silicon dioxide (SiO₂) layers and the interfacial roughness, respectively. All the observed interface state spectra possess peaked-structures, indicating that they are due to defect states. An interface state peak near the Si midgap is attributable to isolated Si dangling bonds at the interface, while those above and below the midgap to Si dangling bonds interacting weakly with Si or oxygen atoms in the SiO₂ layers. A method of the elimination of interface states and defect states in Si using cyanide solutions has been developed. The cyanide method simply involves the immersion of Si in KCN solutions. Due to the high Si-CN bond energy of ∼4.5 eV, the bonds are not ruptured at 800 °C and upon irradiation. The cyanide treatment results in the improvement of the electrical characteristics of MOS diodes and solar cells.     

Improvement of least-squares finite difference method on simulating slider air bearings in head disk systems

Least-squares finite difference (LSFD) method, one of mesh-free methods, is used to solve slider air bearings problem through discritizing the generalized Reynolds equation into nonlinear systems of algebraic equations. Two approximation schemes for the linearization of these equations are presented and compared. And, some new techniques to search supporting points for the reference node in the mesh-free method were proposed and explored. Therefore, these improvements eliminate some potential limitation of the LSFD method previously published and further facilitate its employment in complex slider models. Advanced step slider as an example of negative pressure sliders is simulated and verified using the improved LSFD mesh-free method in head disk systems.     

Lieb–Thirring Inequalities for Schrödinger Operators with Complex-valued Potentials

Inequalities are derived for power sums of the real part and the modulus of the eigenvalues of a Schrödinger operator with a complex-valued potential.     

Transmission of XeCl excimer laser pulses through optical fibers: Dependence on fiber and laser parameters

Measurements of the transmission of XeCl excimer laser pulses (308 nm) through optical all-silica fibers are reported. The observed photodegradation effects during long time irradiation are dependent on the laser energy density and the laser repetition rate. Also the influence of the fiber drawing parameters and fiber geometry have been investigated. Absorption spectra of the fibers in the wavelength range from 200nm to 400nm before and after the irradiation with the excimer laser give some insight in the physical reasons for the changes in transmission properties. A spectral analysis of the fiber fluorescence has been performed.Presented at LASERION '91, June 12–14, 1991, München (Germany)     

On-line nuclear orientation study of184Au

The¹⁸⁴Au→¹⁸⁴Pt decay, studied on-line with the UNISOR facility at HHIRF, is discussed. Gamma-ray and conversion-electron spectroscopy of¹⁸⁴Pt as well as on-line nuclear orientation measurements of¹⁸⁴Au were done. A new low-lying level scheme of¹⁸⁴Pt is proposed. Two coexisting bands with different deformations and their respective γ-vibrational bands are established. Internal conversion coefficients for interband transitions between states with the same spin are extracted from the spectroscopy measurements. The relative E0 contents of the transitions are determined by combining internal conversion coefficients with E2/M1 mixing ratios deduced from gamma-ray anisotropies measured from oriented nuclei.     

An efficient algorithm for elasto-viscoplastic vibrations of multi-layered composite beams using second-order theory

An efficient time-domain algorithm for plane non-linear flexural vibrations of multi-layered composite beams, which are driven into the inelastic range by severe transverse loadings, is presented. The influence of an axial static preload is considered in the sense of the quasi-linear second-order theory of structures. The inelastic parts of strain are treated as additional sources of selfstress in the linear elastic background-structure, driving the elastic response into the inelastic one. The efficiency of this exact formulation lies in the fact that linear solution techniques can be used in their most powerful form: Rubin's useful formulation for the quasi-static second-order transfer-matrix of linear elastic structures is applied in combination with modal analysis. Having in mind multi-metal beams, the classical lamination theory is assumed to be valid. Beams with overhang composed of ideal elastic-plastic and viscoplastic layers are studied as example structures. The fictitious sources of selfstress are calculated from the different material laws of the layers in a numerical time-stepping procedure, where a generalized midpoint-rule in combination with Crisfield's secant-Newton procedure is used.     

Fuzzy incidence matrix of fuzzy simplicial complexes and its folding

In this paper we will introduce a new type of incidence matrices, namely “Fuzzy incidence matrices”. Also we introduce the fuzzy simplicial complexes in its fuzzy form. We will describe some types of foldings especially the folding of a physical character.