Concentric-ring structures in an atmospheric pressure helium dielectric barrier discharge

This paper performs a numerical simulation of concentric-ring discharge structures within the scope of a two-dimensional diffusion--drift model at atmospheric pressure between two parallel circular electrodes covered with thin dielectric layers. With a relative high frequency the discharge structures present different appearances of ring structures within different radii in time due to the evolvement of the filaments. The spontaneous electron density distributions help understanding the formation and development of self-organized discharge structures. During a cycle the electron avalanches are triggered by the electric field strengthened by the feeding voltage and the residual charged particles on the barrier surface deposited in the previous discharges. The accumulation of charges is shown to play a dominant role in the generation and annihilation of the discharge structures. Besides, the rings split and unify to bring and annihilate rings which form a new discharge structure.     

Numerical investigation of slow solitons in Bragg gratings with a hyperbolic tangent apodization

This paper numerically and analytically investigates the formation and propagation motion of optical soliton in the Bragg grating.We choose the fibre Bragg grating with hyperbolic tangent apodization in the middle section in order to obtain slower solitons.Optical fibre soliton but not Bragg grating soliton is used as input pulse in the discussion,which is much more approximate to the light source for the practical purpose.We discuss in detail the effects of the soliton’s velocity with some parameters in the process of transmission.The results show that by choosing special parameters,one can make the soliton slow-down with a little distortion and energy decay and obtain tunable time-delay on a small scale.     

基于COMSOL软件下截锥体电阻的计算

本文应用Comsol软件讨论了截锥体内电势和电流的分布,并计算了截锥体的电阻.     

High power efficiency in single layer blue phosphorescent organic light-emitting diodes

High efficiency single layer blue phosphorescent organic light-emitting diodes (PHOLEDs) without any charge transport layer were developed. A mixed host of spirobifluorene based phosphine oxide (SPPO13) and 1, 1-bis[(di-4-tolylamino)phenyl]cyclohexane (TAPC) was used as the host in the emitting layer. A high maximum external quantum efficiency of 15.8% and a quantum efficiency of 8.6% at 1000 cd/m² were achieved in the single-layer blue PHOLEDs without any charge transport layer. The maximum power efficiency and power efficiency at 1000 cd/m² were 31.4 and 16.9 lm/W, respectively.     

Field Trial of 40 Gbit/s ETDM Prototype System over 219 km of Installed Single Mode Fiber

Transmission of 40Gbit/s NRZ signal was successfully demonstrated over 219km of installed SMF in KT's Daejeon area network. After transmission, the measured power penalty was 0.5dB for all the tributary channels.     

Temperature measurements using fiber optic polarization interferometer

A novel measurement method of temperature based on the phenomena that the phase difference between principle polarization states in the optical retarder is function of temperature is described. The polarization state of optical beam is changed as it passes through the optical retarder, which depends on the temperature. The temperature of optical retarder is determined by comparison of the power difference between principal polarization states. We demonstrate successfully the temperature measurement by using a polarization maintaining fiber as the optical retarder. With a 100 mm length of the fiber optic retarder, the change rate of phase difference on temperature was 0.236 rad/°C and the measurement error was ±0.038°C over the temperature range of −2.6 – +3.4°C. With a 11.5 mm length of the fiber optic retarder, the change rate of phase difference on temperature was 0.021 rad/°C and the measurement error was ±0.79°C over the temperature range of −8.5 – +86.5°C.     

石墨-六角氮化硼微晶混合物与水高压反应产物分析

 利用球磨法制备石墨-六角氮化硼微晶混合物，并在6.1 GPa、800~1 500 ℃条件下与水进行高压反应，以便研究用水作触媒合成B-C-N三元化合物的可能性。通过对反应产物的XRD、XPS谱分析发现：高压下随着温度的升高，反应产物中出现再结晶石墨，其晶化程度逐渐提高；但没有出现再结晶六角氮化硼，也未出现立方氮化硼。在球磨不充分条件下，石墨-六角氮化硼混合物的XRD谱没有完全弥散，它们与水高压反应时，能观察到石墨与立方氮化硼分别结晶的现象，但都没有形成B-C-N晶化结构。     

贝壳固硫过程热重研究

利用LCT-2型热天平对贝壳的固硫反应过程进行了实验研究。探讨了贝壳在含SO2模拟烟气气氛下的固硫能力、温度特性及SO2浓度对其钙利用率的影响特性;并利用JXA-840扫描电镜实验观察了贝壳与石灰石微观结构特性的主要差别。结果表明:贝壳具有良好的微观结构特性和固硫反应活性,其最佳固硫反应温度比石灰石高出约100℃,大部分贝壳更适合作900~1000℃温度下的燃煤固硫剂。     

EAST超导托卡马克装置中的大型超导磁体技术

随着大型超导核聚变装置、超导储能装置、超导强磁场装置及高能超导加速器技术参数的不断提高,大型超导磁体的应用也在加速发展中.大型超导磁体的场强较高、储能较大,对导体的结构、磁体结构、绝缘结构、制造工艺等要求与通常小型超导磁体有很大的不同.本文旨在对国家重大科学工程项目"EAST(HT-7U)超导托卡马克核聚变实验装置"的大型超导磁体关键技术作一介绍.     

Observation of ferromagnetism at room temperature for Cr ions implanted ZnO thin films

Single crystalline ZnO films were grown on c-plane GaN/sapphire (0 0 0 1) substrates by molecular beam epitaxy. Cr⁺ ions were implanted into the ZnO films with three different doses, i.e., 1 × 10¹⁴, 5 × 10¹⁵, and 3 × 10¹⁶ cm⁻². The implantation energy was 150 keV. Thermal treatment was carried out at 800 °C for 30 s in a rapid thermal annealing oven in flowing nitrogen. X-ray diffraction (XRD), atomic force microscopy, Raman measurements, transmission electron microscopy and superconducting quantum interference device were used to characterize the ZnO films. The results showed that thermal annealing relaxed the stress in the Cr⁺ ions implanted samples and the implantation-induced damage was partly recovered by means of the proper annealing treatment. Transmission electron microscopy measurements indicated that the first five monolayers of ZnO rotated an angle off the [0 0 0 1]-axis of the GaN in the interfacial layer. The magnetic-field dependence of magnetization of annealed ZnO:Cr showed ferromagnetic behavior at room temperature.