Chickpeas from a Chilean Region Affected by a Climate-Related Catastrophe: Effects of Water Stress on Grain Yield and Flavonoid Composition

The Valparaiso region in Chile was decreed a zone affected by catastrophe in 2019 as a consequence of one of the driest seasons of the last 50 years. In this study, three varieties (‘Alfa-INIA’, ‘California-INIA’, and one landrace, ‘Local Navidad’) of kabuli-type chickpea seeds produced in 2018 (control) and 2019 (climate-related catastrophe, hereafter named water stress) were evaluated for their grain yield. Furthermore, the flavonoid profile of both free and esterified phenolic extracts was determined using liquid chromatography-mass spectrometry, and the concentration of the main flavonoid, biochanin A, was determined using liquid chromatography with diode array detection. The grain yield was decreased by up to 25 times in 2019. The concentration of biochanin A was up to 3.2 times higher in samples from the second season (water stress). This study demonstrates that water stress induces biosynthesis of biochanin A. However, positive changes in the biochanin A concentration are overshadowed by negative changes in the grain yield. Therefore, water stress, which may be worsened by climate change in the upcoming years, may jeopardize both the production of chickpeas and the supply of biochanin A, a bioactive compound that can be used to produce dietary supplements and/or nutraceuticals.     

Determination of organophosphate esters in air samples by dynamic sonication-assisted solvent extraction coupled on-line with large-volume injection gas chromatography utilizing a programmed-temperature vaporizer

An on-line method for the determination of airborne organophosphate esters based on dynamic sonication-assisted solvent extraction and large-volume injection (LVI) gas chromatography with nitrogen-phosphorous detection is introduced. The LVI is performed with a programmed-temperature vaporizer. The entire extracted fraction of 800 microl (hexane-methyl-tert.-butyl ether, 7:3, v/v) is introduced directly into the GC system without any clean-up step following extraction. The extraction and analysis step were completed in less than 15 min. The limit of detection of the investigated organophosphate esters was established to be in the range of 5-32 pg/filter. The correlation coefficients (r2) were investigated in the linear range study of the entire system and established to be approximately 0.9900 for all the investigated organophosphates esters. Applications of the method was demonstrated with the extraction of air samples collected onto glass fiber filters from different indoor environments. Six organophosphate esters were found at the levels 0.4-138 ng/m3.     

SURFACTANT-OIL-WATER SYSTEMS NEAR THE AFFINITY INVERSION. PART X: EMULSIONS MADE WITH ANIONIC-NONIONIC SURFACTANT MIXTURES.

Anionic and nonionic surfactants exhibit opposite changes in hydrophilicity with a change of temperature. This antagonism can be harnessed by the use of mixtures. The phase behavior and emulsion type are mapped on a temperature water-oil/ratio diagram for different anionic-nonionic mixtures. It is shown that the mixing can result in insensitivity to temperature of different kinds of emulsions.     

Sol-gel technique for the generation of europium-doped mesoporous and dense thin films: A luminescent study

In this paper, a series of europium-activated titania mesoporous and dense thin films were prepared by sol-gel process. Structural characterizations show that high europium ion loadings can be incorporated into titanium dioxide walls without destroying the mesoporous arrangement. However, high europium content locks the titanium dioxide crystallization process. Upon 10% europium ions loading, mesoporous thin films are mainly amorphous, whereas dense ones are still partially crystallized. Eu³⁺ ion luminescence has been investigated by exciting through the semiconductor host lattice. Emission features reveal that europium ions adopt similar environments (nanocrystalline and glassy-like ones) in both dense and mesoporous thin films. Fluctuations of europium emission under continuous UV excitation have been observed. One observes that the effect strongly depends on the thin films’ crystalline character which is strongly related with the texturation and existence at the mesoscopic length scale.     

Fuzzy Markov Chains and Decision-Making

Decision-making in an environment of uncertainty and imprecision for real-world problems is a complex task. In this paper it is introduced general finite state fuzzy Markov chains that have a finite convergence to a stationary (may be periodic) solution. The Cesaro average and the -potential for fuzzy Markov chains are defined, then it is shown that the relationship between them corresponds to the Blackwell formula in the classical theory of Markov decision processes. Furthermore, it is pointed out that recurrency does not necessarily imply ergodicity. However, if a fuzzy Markov chain is ergodic, then the rows of its ergodic projection equal the greatest eigen fuzzy set of the transition matrix. Then, the fuzzy Markov chain is shown to be a robust system with respect to small perturbations of the transition matrix, which is not the case for the classical probabilistic Markov chains. Fuzzy Markov decision processes are finally introduced and discussed.     

Necessary contact conditions for charge injection development into KBr single crystals

We have studied the current vs time behaviour of KBr single crystals by applying a constant voltage between a pointed cathode and a flat anode at constant temperature. The obtained curves are characterized by three or four different zones. We report here very detailed results on the first one. We conclude that in this zone the current through the crystal is purely ionic. As a consequence of this ionic transport, K atoms accumulate at the pointed cathode to form a new electrode. This acts as an injecting contact for electronic current. Electron injection currents and, therefore, colour center clouds that developed upon the formation of this new injecting contact, mark the start of zone II of the current vs time curve. Simple equations are proposed to explain the kinetics of zone I. Experiments by other authors are also analyzed. Finally, a discussion on the simpler experimental conditions required to create the new injecting contact is presented. Results on zones II and III will be published in the near future.     

Analytical properties of 2-oximinodimedone dithiosemicarbazone

The synthesis and analytical properties of 2-oximinodimedone dithiosemicarbazone are described.     

Mise en evidence de la chiralité de l'édifice spirophosphoranique

The chirality of the spirophosphorance skeleton of the recemic mixture 2a , 2ā , is revealed by the NMR chiral shift reagent.     

Improvement of the PLD process assisted by RF plasma for AlN growth

The pulsed-laser-deposition (PLD) method is particularly well suited for the growth of oxide thin films, but in the case of other compounds, such as nitrides, PLD presents some limitations which are mainly due to the low reactivity of nitrogen in comparison with oxygen. A possible way to overcome this problem is to increase the reactivity of the constituent species, via plasma assisted-pulsed-laser deposition. A plasma is coupled to the ablation chamber, in order to increase the density of reactive atomic species, which can be further incorporated in the growing film. This approach is described in this paper as well as the nature, energy, and concentration of the atomic and molecular species in the plasma as determined by various plasma diagnostics. These results are correlated to the growth of thin films in the particular case of the aluminum nitride compound. The composition and structure of the films are studied as a function of the growth conditions, and the positive effects of the additional discharge are evidenced on the film purity and properties. The fundamental problem with the PLD technique, especially with metallic targets, is the production of unwanted droplets that significantly worsen the properties of the films. To eliminate these droplets, a thin film has been grown with an experimental setup using two targets and crossed laser beams which gave positive results. PACS 81.15.Fg; 52.80.Pi; 77.84.Bw