Simultaneous determination of some active ingredients in cough-cold syrups by gas-liquid chromatography

A simple, efficient and accurate gas-liquid chromatography (GLC) method for the simultaneous determination of eight active ingredients in cough-cold syrups has been developed. The active ingredients under study were bromhexine, chlorpheniramine, codeine, dextromethorphan, diphenhydramine, ephedrine/pseudoephedrine, guaiphenesin and papaverine. Before injection, the active ingredients were first separated, from the excipients present in the cough-cold syrups, with chloroform, from alkaline medium. They were then separated by GLC on a glass column (5 ft x 2 mm i.d.) packed with 3% of OV-25 supported on Supelcoport (80-100 mesh). The column temperature was maintained at 170 degrees C for 1 min, then programmed to 265 degrees C at a rate of 10 degrees C min-1, and maintained at this temperature for 10 and 1 min, respectively, for samples with and without papaverine. The flow-rate of the nitrogen carrier gas was 30 ml min-1. A flame-ionisation detector was used for detection, and clomipramine hydrochloride was used as the internal standard. The recoveries of the drugs ranged from 96.0 to 99.7%, and the relative standard deviations for ten replicate determinations ranged from 0.49 to 4.7%. Results are reported for nine commercially available cough-cold syrups.     

Effect of Showerhead Configuration on Coherent Raman Spectroscopically Monitored Pulsed Radio Frequency Plasma Enhanced Chemical Vapor Deposited Silicon Nitride Thin Films

The effect of showerhead design, number of holes and geometry, in a parallel plate reactor was studied by measuring the concentration of silane reactant by coherent anti-Stokes Raman scattering (CARS) spectroscopy as a function of radio frequency (rf) pulse width and peak power during pulsed power plasma enhanced chemical vapor deposition (PECVD) of silicon nitride thin films. Film deposition rate, stress, SiH/NH ratio, and thickness and index of refraction homogeneity were correlated with the change in silane concentration for each of the three head geometries: radial, square, and asymmetrical. The asymmetrical head caused plasma quality problems which affected the films' qualities. The square pattern showed good mixing qualities, but produced a film with high compressive stress. The radial head provided the most homogenous film, with respect to index of refraction and film thickness. With a 10 ms pulse width, however, the radial head plasma acted as a continuous plasma for depletion and stress data. The showerhead geometry affects plasma qualities, like stability and intensity, and reactant gas velocities, which in turn affect the nitride film thickness, nitride composition, and stress.     

Partial cross sections and density-of-states effects in the valence-band photoemission from solid nitrogen

Photoelectron energy distribution curves from solid nitrogen were measured for excitation energies to 40 cV using synchrotron radiation. Partial cross sections for emission from 3σ_g, 1π_u and 2σ_u derived valence bands show pronounced mauna 3, 4, 2.9 and 3.0 eV above the vacuum levels, interpreted as due to high density of conduction-band final states. These states are related to π*_g negative-ion shape resonances.     

Simultaneous determination of cocaine and its metabolites with caffeine in rat serum microsamples by high-performance liquid chromatography

A single, isocratic high-performance liquid chromatographic method is described for the determination of cocaine and three of its metabolites along with caffeine in serum microsamples (50 microliters). The small sample size permits the tracking of pharmacokinetic data over time in individual, small animals. The method also was used to demonstrate that cocaine, benzoylecgonine and norcocaine in rat serum samples were stable for at least a month without the presence of sodium fluoride.     

Modification of silicon AFM cantilever tips with an oligo(ethylene glycol) derivative for resisting proteins and maintaining a small tip size for high-resolution imaging

We demonstrate that silicon AFM tips can be modified by etching with 2% HF solution followed by reaction with an alpha,omega-oligo(ethylene glycol)alkene. Tips properly modified by this technique maintain a small tip size and effectively reduce the nonspecific interaction with fibrinogen and bovine serum albumin, resulting in greatly improved image resolution and contrast for high-coverage fibrinogen films.     

The Reactivity of Cr‐Te Superlattice Reactants and of Co‐deposited Cr‐Te Films: Studies with in‐situ X‐ray Diffractometry

The reactivity of a Cr‐Te multilayer film consisting of 326 Cr/Te double‐layers with about 88(3) at% Te was investigated with in‐situ X‐ray diffraction. The occurrence of a superstructure reflection caused by the multilayer system is observed. During the annealing procedure between 80 and 90 °C the layer‐by‐layer arrangement is destroyed and elemental Te crystallizes. After 6 h isothermal annealing at 140 °C CrTe₃ starts to crystallize. The amount and the crystal size of CrTe₃ increase with raising temperature and Te is consumed during the growth process. At 220 °C the formation of crystalline Cr₂Te₃ is observed and between 220 and 260 °C CrTe₃ is completely decomposed into Cr₂Te₃. The two Cr tellurides grow as highly textured materials. The size of CrTe₃ crystals is significantly larger than that of Cr₂Te₃. For a co‐deposited Cr‐Te film with composition 77(3) at% Te the tri‐telluride and elemental Te crystallize simultaneously. The texture of CrTe₃ is less pronounced and different reflections of the tri‐telluride occur besides the (h00)‐reflections. Up to 160 °C a pronounced increase of the crystallite size is observed and the crystals are significantly larger than those obtained with the multifilm sample. At 130 °C the crystallization kinetics seem to be controlled by nucleation.     

Analysis of Ginkgo biloba for the presence of ginkgotoxin and ginkgotoxin 5'-glucoside

Hot water extracts of Ginkgo biloba seeds were analyzed for the presence of ginkgotoxin (4'-O-methylpyridoxine) by reversed-phase liquid chromatography (LC) using methanol-0.05M KH2PO4 (1 + 9, v/v) adjusted to pH 3 as mobile phase. Detection was by fluorescence (excitation 280 nm, emission 370 nm). A straight line calibration curve was obtained for the 10-100 ng injected. After addition of beta-glucosidase (37 degrees C/h), an earlier eluting peak disappeared and the ginkgotoxin peak increased. The identity of the ginkgotoxin was confirmed by LC/MS and LC/MS/MS. LC/MS/MS also confirmed the 5'-glucoside by comparison with the 3-glucoside. This is the first identification of a glucoside of ginkgotoxin in Ginkgo biloba. An unknown compound of MW 267 also observed in the Ginkgo biloba seed extract was shown not to be 3,5'-diacetylginkgotoxin by its different LC retention time. Extraction of ground Ginkgo biloba seeds with boiling water in a Soxhlet for 2 x 2 h yielded a total of 179 microg/g of free ginkgotoxin. The concentration in powder from Ginkgo biloba capsules was several times lower than this (17-64 microg/g) in 3 samples but higher in another (457 microg/g). Canned ginkgo seeds (white nuts) contained no detectable free ginkgotoxin but the glucoside was present. Different extraction times were studied: 0.5 h gave only 52 microg/g free ginkgotoxin in the ginkgo seeds. However, boiling an extract for 4 h showed about 15% loss of ginkgotoxin and its glucoside.     

A theoretical examination of the acid-catalyzed and noncatalyzed ring-opening reaction of an oxirane by nucleophilic addition of acetate. Implications to epoxide hydrolases

Ab initio and density functional calculations have been performed to gain a better understanding of the epoxide ring-opening reaction catalyzed by epoxide hydrolase. The S(N)2 reaction of acetate with 1S,2S-trans-2-methylstyrene oxide to provide the corresponding diol acetate ester was studied with and without general-acid catalysis. MP2 and DFT (B3LYP) calculations predict, for the noncatalyzed reaction, a central barrier of approximately 20-21 kcal/mol separating the reactants from products depending on which carbon center in the epoxide is undergoing attack. From these gas-phase reactions the immediate alkoxide products are not energetically far below their associated transition states such that the reaction is predicted to be endothermic. Inclusion of aqueous solvation effects via a polarizable continuum model predicts the activation barrier to increase by almost 10 kcal/mol due to the solvation of the acetate ion nucleophile. The activation barrier for the epoxide ring-opening reaction is reduced to approximately 10 kcal/mol when phenol, as the general-acid catalyst, is included in the gas-phase calculations. This is due to the immediate product being the neutral ester rather than the corresponding alkoxide. The transition state in the general-acid-catalyzed reaction is earlier than that for the noncatalyzed reaction and the reaction is highly exothermic. Molecular mechanics calculations of 1S,2S-trans-2-methylstyrene oxide in the active site of murine epoxide hydrolase show two possible binding conformations. Both conformers have the epoxide oxygen forming hydrogen bonds with the acidic hydrogens of the catalytic tyrosines (Tyr381 and Tyr465). These two conformations likely lead to different products since the nucleophile (Asp333-CO(2)(-)) is positioned to react with either carbon center in the epoxide.     

Femtosecond Spectroscopic Studies on the Red Light-Absorbing Form of Oat Phytochrome and 2,3-Dihydrobiliverdin

Abstract— The excited state behavior of the red light-absorbing form of phytochrome (Pr) was studied on the femtosecond time scale. After excitation of Pr with 75 fs laser pulses at 616 nm the kinetics of the transient absorption changes was recorded at selected wavelengths probing mainly the bleaching of the Pr ground-state absorption and the stimulated emission. The kinetic data obtained indicate the population of an excited state with a 3 ps lifetime immediately after excitation. This state precedes the formation of another excited state with a 32 ps lifetime. The decay of the latter state is followed by the appearance of a first product state that is assumed to represent lunii-R. In addition, 2,3-dihydrobiliverdin, which is considered to be an adequate model of the Pr chro-mophore, was included in the femtosecond studies. The absorption difference spectra recorded at various delay times show an immediate bleaching of the ground-state absorption. Simultaneously with bleaching a broad transient absorption appears between 410 and 525 nm. The data analysis yields similar kinetic components as they were observed in the decay of Pr. It is suggested from this finding that within the first tens of picoseconds after excitation the excited-state properties of Pr are mainly determined by the properties of the chromophore itself.     

Analysis of the contribution of skeletal vibrations to the heat capacity of linear macromolecules in the solid state

Automatic computer programs are developed to calculate one- two-, and three-dimensional Debye functions. Prior tables of these functions are critically reviewed. Also, strategies are derived to calculate Debye temperatures from heat capacities. Both, simple three-dimensional Debye analyses and Tarasov analyses were carried out on 35 linear macromolecules. The experimental heat capacities for these analyses were collected in the ATHAS data bank. It is shown that the skeletal heat capacity of linear macromolecules is often best represented by only two vibrations per chain atom. For most of the all-carbon chain macromolecules the intramolecular skeletal heat capacity can be given by C_vs=D₁[520 (28/MW)^1/2] whereMW is the molecular mass andD ₁ represents the one-dimensional Debye function. Polyoxides show a higher intramolecular theta temperature, but a lower intermolecular theta temperature. Double bonds and phenylene groups in the chain increase the intramolecular theta temperature.Dedicated to Prof. Dr. F. H. Müller.On leave from the Lumumba Peoples' Friendship University, Moscow, USSR.