Liquid phase selective hydrogenation of phenol to cyclohexanone over Ru/Al<Subscript>2</Subscript>O<Subscript>3</Subscript> nanocatalyst under mild conditions

Highly monodispersed ruthenium nanoparticles were prepared via wet impregnation technique using RuCl₃ · nH₂O as a precursor. Ru nanoparticles were supported on Al₂O₃ to synthesize Ru nanocatalyst. The nanocatalyst was characterized by various techniques like XRD, SEM, TEM and BET analysis. The catalyst was used for hydrogenation of phenol under mild condition. The activity of the catalyst was checked by varying different parameters such as reaction temperature, time, H₂ partial pressure, metal loading and catalyst amount. The catalyst was recovered from product and reused up to four times without significant loss in its catalytic activity. After a reaction time of 1 h, Ru/Al₂O₃ nanocatalyst showed high reactivity (82% conversion) and selectivity to cyclohexanone (67%) at 80°C and 20 bar hydrogen pressure.     

Effect of alkali metal cationization on the collision-induced decomposition of alkyl per-O-acetyl-2-deoxy-2-halo-α-O-mannopyranosides

The effect of alkali metal cationization on the collision-induced decomposition of alkyl per-O-acetyl-2-deoxy-2-bromo-and-iodo-α-O-mannopyranosides was studied. The bromo sugars gave fairly abundant MH⁺, whereas for the iodo sugars the MH⁺ ions were insignificant. However, both the bromo and the iodo derivatives gave abundant M + alkali metal ion complexes. In contrast to the behaviour of the MH⁺ ion, the [M + Li]⁺, [M + Na]⁺ and [M + K]⁺ ions of these compounds do not decompose by loss of the C(1) substituent. Elimination of AcOH is the preferred fragmentation pathway of [M + Cat]⁺. Elimination of HX occurs only after loss of AcOH and CH₂CO from MH⁺, whereas [M + Cat]⁺ directly loses HX. The elimination of HX is more pronounced from [M + Na]⁺ and [M + K]⁺ than from [M + Li]⁺. Loss of AcOLi is an additional fragmentation route observed in the case of the decomposition of [M + Li]⁺ ion.     

有机磷化合物的研究XIX.III亚磷酸二烷基酯钠的相转移催化P-烷基化反应

Sodium dialkyl phosphite reacts with non-activated alkyl halide in the presence of crown ether to give dialkyl alkyl phosphonate in moderate yield. Little or no reaction takes place in the absence of crown ether under the same conditions. In all cases, crown ether was present in catalytic amts. indicating that it behaves as a phase transfer catalyst between solid and liquid phases. The influences of structures of crown ethers, alkyl halides, dialkyl phosphites and the nature of solvent on the P-alkylation of sodium dialkyl phosphite have been investigated.     

Collision-induced dissociation of MCl(+) adducts (M = Mg, Mn, Zn, Co, Ni and Cu) and Cu(+) and Ag(+) adducts of dithioalkyl ketene acetals

Electrospray ionization mass spectra of equimolar solutions of dithioalkyl ketene acetals 1 and 2 and metal chlorides (MgCl(2), MnCl(2), ZnCl(2), CoCl(2), NiCl(2) and CuCl(2)) produced abundant ligated metal ion adducts [1 + MCl](+) and [2 + MCl](+). In addition, CuCl(2) also gave rise to Cu(+) adducts. The ligated metal ion adducts upon collision-induced dissociation (CID) showed characteristic fragmentation pathways reflecting the favoured site of coordination. The results show that MgCl(+) prefers oxygen over sulfur, whereas the reverse is true for ZnCl(+) adducts, exemplified by the preferred fragmentation of [1 + MgCl](+) as elimination of MgCl(OH), while that of [1 + ZnCl](+) is expulsion of ZnCl(SCH(3)). Co and Ni chloride adducts tend to give stable metal coordinated species. Cleavage of the dithiolane ring followed by elimination of C(2)H(4)S is the preferred pathway during the CID of [2 + MCl](+) adducts. The CuCl(+) adducts of 1 and 2 showed reduction of Cu((I)) to Cu((0)) resulting in the M(+)(*)ions of 1 and 2. Abstraction of *CH(3) resulting in elimination of CuCH(3) was observed during CID of Cu(+) adducts of 1 and 2. A comparative study of the corresponding Ag(+) adducts revealed a similar behaviour.     

Screening of Rubiaceae and Apocynaceae extracts for mosquito larvicidal potential

Rubiaceae and Apocynaceae families are well known for the expression of cyclotides having insecticidal properties. Leaves and flowers extracts of plants from the families Rubiaceae (Ixora coccinea) and Apocynaceae (Allamanda violacea) were evaluated for mosquito larvicidal effect against early IVth instars of Aedes aegypti and Anopheles stephensi. Two forms of plant extracts, one untreated and the other treated with heat and proteolytic enzyme were used for assay. After primary assay, the extract showing more than 50% inhibition was further used for quantification purpose. LC₅₀ and LC₉₀ values of all the extracts were found to be reduced with the treated form. Phytochemical analysis of plant extracts was performed. Primary confirmation for the presence of cyclotides was done by Lowry test, thin layer chromatography and haemolytic assay. This novel approach merits use of plant extracts in mosquito control programmes.     

Transition metal chelates: Synthesis,physicochemical, thermal,and biological studies

The transition metal complex of Mn(II), Co(II), Ni(II), Cu(II), Ti(III), Cr(III), Fe(III), Zr(IV), and UO₂(VI) ion with a Schiff’s base ligand derived from 2-hydroxy-[2-oxo-1,2-dihydro-3H-indol-3-ylidene]-benzohydrazide have been prepared. The complexes have been characterized by elemental analysis data, IR and electronic absorption spectra, magnetic moments, and thermogravimetric analysis data. The complexes of the 1: 1 metal-to-ligand stoichiometry have been formed. The physico-chemical data have suggested the octahedral geometry for all the complexes except for Cu(II); the Cu(II) complex has been square planar. Thermal analysis data of the ligand and its complexes have been analyzed, and the kinetic parameters have been determined using the Horowitz–Metzger method. According to the solid-state electrical conductivity measurements, the ligand and its complexes are semiconducting in nature. The antimicrobial activity of the ligand and the complexes towards E. coli, S. typhi, P. aeruginosa, and S. aureus has been tested by the disc diffusion method.     

Evaluation of Properties of Concrete Without Cement Produced Using Fly Ash-Based Geopolymer

The use of ordinary Portland cement (OPC) in the construction industry is inevitable. The huge production of OPC and its use in infrastructural development pose an environmental impact. Greenhouse gas emitted increases the global temperature and it is an alarming sign to everybody on the planet. Concrete is the most consuming material which is produced by using OPC and it is proven that OPC contributes a lot to CO₂ emission. Hence in this study attempt is made to produce concrete by using environment-friendly material like fly ash along with alkaline activators, which is termed Geo polymer concrete. The by-product fly ash is widely available worldwide. It is a by-product of thermal power plants. The use of fly ash in concrete produces less expensive and more cost-effective concrete than concrete made up using OPC. Due to its high silicate and alumina content, fly ash reacts with an alkaline solution to create an aluminosilicate gel that binds the aggregate and results in high-quality concrete. Fly ash is finer than cement, it occupies the pores of cement after hydration. This would result in denser concrete which gives higher strength. In comparison to ordinary concrete, fly ash-based geopolymer concrete offers better resistance to aggressive environments and high temperatures. In the present study, an alkaline activator of molarity 8 is used to prepare geopolymer concrete. The test specimens are cast and cured for 28 days. Test results indicate that an alkaline liquid fly-ash ratio (0.4) produces higher mechanical properties. Hence, geopolymer concrete produced in this study is found to be cost-effective and environment friendly.     

Parity of the band head at 3710 keV in 99Rh using clover detector as compton polarimeter

Clover detector has been used as a Compton polarimeter to measure the linear polarization of γ-rays produced in heavy ion fusion reaction. The polarization sensitivity of the clover detector has been measured over γ-ray energies ranging from 386 to 1368 ke V. The E1 multipolarity of the 1117 keV transition in ⁹⁹Rh has been established using this polarimeter. This has resulted in the assignment of negative parity to the band head at 3710 keV in ⁹⁹Rh.     

Scaffold hopping for identification of novel D2 antagonist based on 3D pharmacophore modelling of illoperidone analogs

The dopamine D(2) receptor is involved in the etiology of a number of disorders, such as Parkinson's disease, Huntington's Chorea, tardive dyskinesia and schizophrenia. Antagonism of D(2) receptors is implicated in the treatment of various psychiatric disorders. In order to understand essential structural features required for D(2) antagonism, this research article elaborates on the generation of a four-point 3D pharmacophore model which was extracted from a series of 45 novel 3-[[(aryloxy)alkyl]piperidinyl]-1,2-benzisoxazole derivatives. The best pharmacophore model generated consisted of four PRRR features: a positively charged group (P), and three aromatic rings (R). Based on the model generated, a statistically valid 3D-QSAR with good predictability (Q(2) = 0.756) was derived. For the validation of the pharmacophore hypothesis, active compounds were docked against the 3D structure of the D(2) receptor which was constructed through homology modeling. Further, the derived pharmacophore was used as a query to search the Zinc 'clean drug-like' database. Hits retrieved were passed progressively through filters, such as fitness score, predicted activity and docking scores. The resulting hits present new scaffolds with a strong potential for D(2) antagonist.     

Fluctuation conductivity in cuprate superconductors

We have measured the in-plane resistivity of Bi₂Sr₂CaCu₂O_8+δ and Tl₂Ba₂ CaCu₂O_8+δ single crystals in the temperature range 70–300 K. The thermodynamic fluctuations in the conductivity of both the samples start around ∼ 125 K. We find the Lawrence and Doniach [1] model to be inadequate to describe the fluctuation conductivity in these materials. The modification suggested by Ramallo et al [4] where by the conductivity is enhanced due to the presence of two superconducting layers in each unit cell is also not adequate. We suggest the fluctuation conductivity to be reduced due to the reduction in the density of states (DOS) of the quasiparticles which results due to the formation of Cooper pairs at the onset of the fluctuations. The data agrees with the theory proposed by Dorin et al [5] which takes into account this reduction in DOS.