Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

一个反应扩散方程的自由边界问题

该文研究了一个描述原细胞生长的反应扩散方程的自由边界问题.利用非线性分析中的线性化思想和偏微分方程的估计理论,证明了该自由边界问题局部古典解的存在唯一性.     

四能级原子系统中量子相干增强的Kerr非线性效应的研究

应用密度矩阵方程计算了四能级原子系统中三阶非线性极化率随信号光和探针光频率失谐的变化关系。结果表明，由于量子干涉对信号光强度的敏感性，使四能级原子介质的交叉Kerr非线性作用大大增强，与三能级系统相比，四能级原子介质的Kerr非线性系数可增强两个数量级。     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

Triterpenoid Constituents of Huperzia miyoshiana

Thirteen triterpenoids, including three new ones, miyoshianois A (1), B (2) and C (3), were isolated from Huperzia miyoshiana. The structures of these new compounds were established as 3-O-dihydroferuloyltohogenol (1), 16-oxo-3β,21β-dihydrox-y-serrat-14-en-24-ferulate (2) and 16-oxo-3a, 21β-dihydroxy-serrat-14-en-24-ferulate (3), respectively, on the basis of their spectroscopic analysis.     

ICF研究中的Rayleigh-Taylor不稳定性实验用靶

 概述了当前研究Rayleigh-Taylor不稳定性增长实验所用的靶型情况。从实验用靶来看，调制靶的设计正从平面向立体发展，出现了球形和柱形等新靶形，制备手段包括精密机械微加工、激光束、电子束和离子束加工、半导体工艺和微米纳米技术加工等。根据对国外新靶型的研究，结合国内工艺条件和实验需求，对国内可能采用的靶型进行了研究探索。     

Synthesis,X-Ray Structure and Characterization of a Triruthenium Cluster Complex Ru_3~Ⅲ(μ_3-O)(μ-CH_3COO)_6(py)_2Cl with Four Steps One-electron Redox Processes

Great attention is currently paid to the synthesis of polynuclear transition metal complexes as well as their photochemical, photophysical, and electrochemical properties. The design of multicomponent systems capable of performing useful light- and/or redox-induced function is of special interest1. The oxo-centered carboxylate-bridge trinuclear ruthenium clusters have been investigated extensively during recent decades because they have remarkable electron-transfer properties, intense visibl…     

Time-Resolved Femtosecond Degenerate Four-Wave Mixing in LiNbO3：Fe,Mg Crystal

Forward degenerate four-wave mixing （DFWM） processes are investigated with a femtosecond pulsed laser in lithium niobate crystal doubly-doped with magnesium and iron （LiNbO3：Fe, Mg）. The pulse energy dependence reveals a pure third-order nonlinear response, and the third-order nonlinear susceptibility x^（3） in the material is evaluated to be 4.96 × 10^-13 esu. The time-resolved DFWM process shows a response time of x^（3） shorter than 100fs, which is due to the nonresonant electronic nonlinearities. Our results indicate that LiNbO3 crystals have potentials for ultrafast real-time optical processing systems, which require a large and fast x^（3） optical nonlinearity.     

Endpoint estimates for certain commutators of fractional and singular integrals

In this paper, the authors obtain the endpoint estimates for a class of non-standard commutators with higher order remainders and their variants. Moreover, the authors show that these operators are actually not bounded in certain cases.

     

聚苯硫醚／石墨基双极板复合材料性能的研究

以聚苯硫醚树脂和人造石墨为原料一次模压成型制备双极板复合材料.研究了模压成型过程中加压时机、冷却方式及人造石墨原料对复合材料电导率和弯曲强度的影响.结果表明,制备聚苯硫醚/石墨基双极板材料宜选用石墨化程度较高且结构密实的石墨粉料;采用保温后加压及空气中冷却方式制备的复合材料的综合性能较优.