INFLUENCE OF A LEVELNESS DEFECT IN A THRUST BEARING ON THE DYNAMIC BEHAVIOUR OF AN ELASTIC SHAFT

This paper examines the non-linear dynamic behaviour of a flexible shaft. The shaft is mounted on two journal bearings and the axial load is supported by a defective hydrodynamic thrust bearing at one end. The defect is a levelness defect of the rotor. The thrust bearing behaviour must be considered to be non-linear because of the effects of the defect. The shaft is modelled with typical beam finite elements including effects such as the gyroscopic effects. A modal technique is used to reduce the number of degrees of freedom. Results show that the thrust bearing defects introduce supplementary critical speeds. The linear approach is unable to show the supplementary critical speeds which are obtained only by using non-linear analysis.     

Effect of hydrogen on the photoelectronic properties of GaAs/InGaAs quantum-well heterostructures with an island palladium layer on the surface

The effect of hydrogen on the photoluminescence and planar conductivity of GaAs/InGaAs quantum-well heterostructures with an island Pd layer at the anodically oxidized surface was studied. Unlike continuous deposited Pd layers, island layers do not cause the formation of defects in the GaAs surface region and yet the Pd layer maintains high catalytic activity with respect to hydrogen. It is found that the thermal treatment of such a structure in a hydrogen atmosphere causes atomic-hydrogen passivation of the defects in quantum wells. Studies of the characteristics of planar photoresistors with an island Pd layer acting as hydrogen sensors show that their hydrogen detectivity is approximately two orders of magnitude higher than that of diode structures with continuous Pd layers.     

High-throughput screening of fuel cell electrocatalysts

The drawbacks of our earlier report of preparing fuel cell catalyst arrays by borohydride reduction of inkjet prepared arrays of metal salts are discussed along with the need for inclusion of state-of-the-art metrics in all array screening. An alternative method for screening of hydrogen/air cathode catalysts, direct methanol fuel cell (DMFC) anode catalysts, and catalyst loading studies is provided. State-of-the-art Johnson Matthey catalysts were used in control experiments to demonstrate the utility of the array fuel cell for high throughput screening of fuel cell catalysts in the 3-4 mg/cm² range. This report lays out hard learned rules for high throughput screening and demonstrates that the array fuel cell can be used for very precise screening of libraries of membrane electrode assembly (MEA) components without the pitfalls discussed in the introduction.     

Raman spectroscopy of topotecan, an inhibitor of DNA topoisomerase I

Topotecan (TPT), a water-soluble derivative of camptothecin (inhibitor of human DNA topoiomerase I), has found wide application in cancer chemotherapy. The central problem in using topotecan is the presence of lactone rings in its molecules, which undergo hydrolysis at a physiological pH yielding an inactive and even toxic form of the drug. The analysis of Raman spectra of TPT in H₂O and D₂O solutions made it possible to assign the spectral bands to the vibrations of particular molecular groups. Spectral features indicative of the opening of the lactone rings of the TPT molecules, deprotonation of the hydroxyl groups in their quinoline fragments, and of possible participation of the hydroxyl and carbonyl groups in H bonding are found. The data obtained are necessary to study the molecular mechanisms of TPT-DNA interaction and the formation of ternary complexes between TPT, DNA, and DNA topoisomerase I.     

Dynamical Characteristics of Traveling Wave Packets of Total Electron Content Disturbances

Using the COPHASE method and the GPS interferometry method for travelling ionospheric disturbances, we analyze in detail the spatio-temporal properties of travelling wave packets (TWP) of total electron content (TEC) disturbances. The analysis is performed on the example of a clearest TWP manifestation observed in California, USA, in October 18, 2001, using the GLOBDET technique, developed at the Institute of Solar-Terrestrial Physics of the Siberian Branch of RAS for global detection and monitoring of natural and technogenic ionospheric disturbances on the basis of TEC variations retrieved from the global network of GPS receivers. In the time domain, TWPs are quasi-periodic TEC oscillations of duration about 1 h, period of 10–20 min, and amplitude exceeding that of the background TEC fluctuations by at least one order of magnitude. The velocity and direction of TWP motion are similar to those of mid-latitude mesoscale travelling ionospheric disturbances, as obtained earlier from the analysis of phase parameters of HF radio signals and the signals of geostationary satellites and discrete space radio sources.     

Temperature and junction-type dependency of Andreev reflection in MgB2

We studied the voltage and temperature dependency of the dynamic conductance of normal metal-MgB₂ junctions obtained either with the point-contact technique (with Au and Pt tips) or by making Ag-paint spots on the surface of MgB₂ samples. The fit of the conductance curves with the generalized BTK model gives evidence of pure s-wave gap symmetry. The temperature dependency of the gap, measured in Ag-paint junctions (dirty limit), follows the standard BCS curve with 2Δ/k_BT_c=3.3. In out-of-plane, high-pressure point-contacts we obtained almost ideal Andreev reflection characteristics showing a single small s-wave gap Δ=2.6±0.2 meV (clean limit).     

Towards Treating Correlations in Bose Condensates

 We use the adiabatic hyperspheric expansion and the Faddeev decomposition of the wave function with only s-waves. We derive for a fixed hyperradius an integro-differential equation for the angular eigenvalue and wave function. The correlations lower the interaction energy for N = 20 by about a factor of 5. Received October 22, 2001; accepted for publication November 5, 2001     

TOPOLOGY DESIGN OF STRUCTURES SUBJECTED TO PERIODIC LOADING

Although a lot of attention in the topology optimization literature has focused on the optimization of eigenfrequencies in free vibration problems, relatively little work has been done on the optimization of structures subjected to periodic loading. In this paper, we propose two measures, one global and the other local, for the minimization of vibrations of structures subjected to periodic loading. The global measure which we term as the “dynamic compliance” reduces the vibrations in an overall sense, and thus has important implications from the viewpoint of reducing the noise radiated from a structure, while the local measure reduces the vibrations at a user-defined point. Both measures bring about a reduction in the vibration level by moving the natural frequencies which contribute most significantly to the measures, away from the driving frequencies, although, as expected, in different ways. Quite surprisingly, the structure of the dynamic compliance optimization problem turns out to be very similar to the structure of the static compliance optimization problem. The availability of analytical sensitivities results in an efficient algorithm for both measures. We show the effectiveness of the measures by presenting some numerical examples.     

Miscibility of bisphenol-A polycarbonate with poly(methyl methacrylate)

The miscibility of bisphenol-A polycarbonate (PC) with poly(methyl methacrylate) (PMMA) has been reexamined using differential scanning calorimetry (DSC) and optical indications for phase separation on heating, i.e., lower critical solution temperature (LCST) behavior. Various methods have been used to prepare the blends including methylene chloride (CH₂Cl₂) and tetrahydrofuran (THF) solution casting, melt mixing, and precipitation of PC and PMMA simultaneously from THF solution by using the nonsolvents methanol and heptane. It is shown that the resulting phase behavior for PC/PMMA blends is strongly affected by the blend preparation method. However, these blends are miscible over the whole blend composition range (unambiguous single composition-dependent T_g's and LCST behavior) when prepared by precipitation from solution using heptane as the nonsolvent. To the contrary, solution-cast and melt-mixed PC/PMMA blends were all phase separated, which may be attributed to the “solvent” effect and LCST behavior, respectively, not discovered in previous reports. Methanol precipitation does not lead to fully mixed blends, which demonstrates the importance of the choice of nonsolvent when using the precipitation method.