MCM-41分子筛负载钼钴系催化剂的噻吩HDS研究

通过氧吸附量、噻吩吸附热及反应速率常数的测定，研究了MoO3/MCM-41、MoO3-CoO(NiO)/MCM-41系列催化剂，发现，对于MoO3/MCM-41催化剂，当MoO3的质量分数（以MCM－41为底数，即MCM－41＝1g时，MoO3含量为0．15g，下同）从15％增加到20％时，其噻吩的加氢硫（HDS）活性增大，至25％时活性下降，所对应的氧吸附量（mL/g催化剂）也是先增大后减少，并且两者有很好的线性对应关系，而且噻吩吸附热则基本保持不变，采用不同的MoO3-CoO(NiO)浸渍顺序制备的MoO3-CoO(NiO)/MCM-41催化剂中，先浸渍CoO(NiO）再浸渍MoO3的催化剂，其噻吩HDS活性明显优于对其它浸渍顺序制备的催化剂，同时催化剂的氧吸附量和噻吩吸附热也最大。     

Spectroscopy and Structure of Sol-Gel Systems

Sol-gel derived glasses may differ from conventional melt-quenched glasses owing to the peculiar microstructures existing at the gel state, such that, even after gel densification, some differences may remain in their composition and molecular structure.This paper discusses structural characteristics of thin film oxide gels and glasses, with a special emphasis on SiO2-TiO2 based systems, which are of particular interest for sol-gel integrated optics applications. Short range structure aspects are discussed based on infrared, X-ray photoemission and X-ray photoabsorption spectroscopies. The chemical homogeneity of sol-gel materials is evaluated, based on X-ray photoemission and nuclear magnetic resonance spectroscopies, dealing in particular with the issue of homo- vs. heterocondensation. Finally, some microstructural features of sol-gel derived films are analyzed, namely the relationship between infrared absorption and porosity and the structure of nanocrystalline sol-gel films, based on grazing incidence X-ray diffraction and micro-Raman spectroscopy. The types of structural information obtainable by each different technique are compared in detail.     

微波辐射-酶耦合催化(MIECC)反应

将微波辐射用于非水相酶催化可以获得很多有别于常规加热下的反应结果.本文讨论了微波的非热效应在酶促反应中的表现,探讨了微波辐射对酶的结构、构象、活性及酶催化反应动力学的影响,以及微波辐射-酶耦合催化对反应的对映选择性、底物专一性、前手性选择性和区域选择性的影响.在大多数场合,适当的微波辐射不会损伤酶活而且可以提高反应速率,而对酶特异性的影响则不一而论.     

Sensitive Voltammetric Response of p‐Nitroaniline on Single‐Wall Carbon Nanotube‐Ionic Liquid Gel Modified Glassy Carbon Electrodes

An ionic liquid (i.e., 1‐butyl‐3‐methylimidazolium hexafluorophosphate, BMIMPF₆)‐single‐walled carbon nanotube (SWNT) gel modified glassy carbon electrode (BMIMPF₆‐SWNT/GCE) is fabricated. At it the voltammetric behavior and determination of p‐nitroaniline (PNA) is explored. PNA can exhibit a sensitive cathodic peak at ?0.70 V (vs. SCE) in pH 7.0 phosphate buffer solution on the electrode, resulting from the irreversible reduction of PNA. Under the optimized conditions, the peak current is linear to PNA concentration over the range of 1.0×10^?8–7.0×10^?6 M, and the detection limit is 8.0×10^?9 M. The electrode can be regenerated by successive potential scan in a blank solution for about 5 times and exhibits good reproducibility. Meanwhile, the feasibility to determine other nitroaromatic compounds (NACs) with the modified electrode is also tested. It is found that the NACs studied (i.e., p‐nitroaniline, p‐nitrophenol, o‐nitrophenol, m‐nitrophenol, p‐nitrobenzoic acid, and nitrobenzene) can all cause sensitive cathodic peaks under the conditions, but their peak potentials and peak currents are different to some extent. Their peak currents and concentrations show linear relationships in concentration ranges with about 3 orders of magnitude. The detection limits are 8.0×10^?9 M for p‐nitroaniline, 2.0×10^?9 M for p‐nitrophenol, 5.0×10^?9 M for o‐nitrophenol, 5.0×10^?9 M for m‐nitrophenol, 2.0×10^?8 M for p‐nitrobenzoic acid and 8.0×10^?9 M for nitrobenzene respectively. The BMIMPF₆‐SWNT/GCE is applied to the determination of NACs in lake water.     

反相高效液相三元流动相台阶梯度分离条件的快速优化方法

 根据溶质在柱内的迁移规律 ,建立了一种利用线性梯度实验快速获得溶质保留值方程系数 ,然后以串行响应函数为优化指标进行多台阶梯度分离条件优化的方法。与利用等度实验获得保留值方程的方法相比 ,该法可以大大缩短优化时间。通过该方法对芳香胺和衍生化氨基酸样品进行了分离 ,获得了满意的分离度 ,表明该方法的预测精度很好。     

溶剂热法制备Ag/TiO2纳米材料及其光催化性能

以乙醇为溶剂, 钛酸四丁酯为前驱体, 用溶剂热法制备了Ag表面修饰的负载型纳米二氧化钛光催化剂. 利用X射线衍射(XRD)、N₂吸附-脱附(BET)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外-可见(UV-Vis)光谱等技术对其进行了系统的表征, 以亚甲基蓝(MB)溶液的脱色降解为模型反应, 考察了不同Ag含量样品的光催化性能. 结果表明: 用溶剂热法制备的样品中TiO₂皆为锐钛矿相, 金属Ag颗粒沉积在TiO₂表面, 粒径为2 nm左右, 比表面积较溶胶凝胶法制备的样品大大增加, 最高可达151.44 m²·g^-1; UV-Vis光谱和光催化实验表明: Ag修饰使TiO₂对光的吸收能力大大增强, 吸收带边红移至可见光区, 亚甲基蓝在该复合材料上的光催化降解反应遵循一级反应动力学模型; 溶剂热法制备样品的光催化性能明显好于溶胶凝胶法制备的样品, 在紫外光和可见光下, Ag摩尔分数为5%的样品表现出最佳的光催化活性.     

失效原子力显微镜硅针尖再生

原子力显微镜的传统商品硅针尖在使用过程中极易因磨损而失效，本文研究了一种在实验室条件下简易可行的回收利用失效硅针尖的方法。在原子力显微镜的敲击模式下使用曲率半径大于100 nm的失效硅针尖对生长单壁碳纳米管的样品表面进行扫描，把样品表面的单壁碳纳米管管束粘接到硅针尖上，可制得直径在5～20 nm的碳纳米管针尖。实验对碳纳米管针尖和新的商品硅针尖进行了成像对比，所制备的碳纳米管针尖不仅在成像分辨率而且在成像稳定性上都优于新的商品硅针尖。     

Single Atoms of Iron on MoS2 Nanosheets for N2 Electroreduction into Ammonia

Efforts have been devoted to achieving a highly efficient artificial synthesis of ammonia (NH₃). Reported herein is a novel Fe-MoS₂ catalyst with Fe atomically dispersed onto MoS₂ nanosheets, imitating natural nitrogenase, to boost N₂ electroreduction into NH₃ at room temperature. The Fe-MoS₂ nanosheets exhibited a faradic efficiency of 18.8 % with a yield rate of 8.63 μg mg_cat.⁻¹ h⁻¹ for NH₃ at −0.3 V versus the reversible hydrogen electrode. The mechanism study revealed that the electroreduction of N₂ was promoted and the competing hydrogen evolution reaction was suppressed by decorating the edge sites of S in MoS₂ with the atomically dispersed Fe, resulting in high catalytic performance for the electroreduction of N₂ into NH₃. This work provides new ideas for the design of catalysts for N₂ electroreduction and strengthens the understanding about N₂ activation over Mo-based catalysts.     

三甲氧基苄啶分子印迹整体柱的制备及色谱性能

选择甲基丙烯酸为功能单体\, 甲基丙烯酸乙二醇双酯为交联剂, 制备了三甲氧基苄啶分子印迹整体柱, 对整体柱材料的形貌进行了表征, 并且研究了TMP和5种磺胺类药物在分子印迹整体柱上的色谱行为.     

聚(ε-己内酯)薄膜结晶形貌及分子取向研究

用匀胶机通过溶液铸膜方法在硅片和铝箔基板上分别制备具有不同厚度的聚(ε-己内酯)(PCL)薄膜. 通过原子力显微镜(AFM)和偏光衰减全反射傅里叶红外光谱(ATR-FTIR)对薄膜中PCL的结晶形貌、 片晶生长方式及分子链取向进行了研究. AFM结果表明, 在200 nm或更厚的薄膜中, PCL主要以侧立(edge-on)片晶的方式生长; 对于厚度小于200 nm的薄膜, PCL片晶更倾向于以平躺(flat-on)的方式生长. 这种片晶生长方式的改变在硅片和铝箔基板上都表现出同样的倾向. 此外, 在15 nm或更薄的薄膜中, PCL结晶由通常的球晶结构变为树枝状晶体. 偏光ATR-FTIR结果表明, 当膜厚小于200 nm时, 薄膜结晶中PCL分子链沿垂直于基板表面方向取向, 并且膜越薄, 取向程度越高, 与AFM的观测结果一致.