煤粉再燃对600 MW锅炉NOx排放的影响

在国内某台燃用褐煤的600 MW机组锅炉上进行了煤粉再燃技术示范并进行了工业试验.机组在600 MW负荷下运行时,NOx排放可控制在274 mg/m3(烟气中氧量折算到6%,下同)的水平,比改造前下降了65.36%,同时燃烧效率没有降低.进行了常规通风、空气分级和煤粉再燃三个工况下的试验,结果表明,煤粉再燃对NOx的控制效果最好,其次为空气分级.再燃煤粉比例对NOx排放也有明显的影响,在试验条件下,随着再燃燃料比例的增加,NOx排放呈降低趋势.     

Timing Jitter and Frequency Shift in Dispersion-Managed Soliton Systems with Raman Scattering Effect

We have studied the timing jitter in dispersion-managed soliton systems with a Gaussian pulse by two methods. Firstly, the timing jitter expressions for dispersion-managed soliton are derived by use of the perturbed variational method. By analyzing and simulating the timing jitter expressions, one can find that the timing jitter is induced by the amplifier spontaneous emission noise, the frequency shift, etc. The chirp sign, the soliton self-frequency shift, and the filters action also have effects on the timing jitter. Secondly, the timing jitter is calculated and analyzed by the moment method. The results of the two methods are proved to be consistent.     

Improved crystal quality of GaN film with the in-plane lattice-matched Ino.17Alo.s3N interlayer grown on sapphire substrate using pulsed metal-organic chemical vapor deposition

We report on an improvement in the crystal quality of GaN film with an Ino.17Alo.83N interlayer grown by pulsed metal-organic chemical vapor deposition, which is in-plane lattice-matched to GaN films. The indium composition of about 17% and the reductions of both screw and edge threading dislocations （TDs） in GaN film with the InA1N interlayer are estimated by high resolution X-ray diffraction. Transmission electron microscopy （TEM） measurements are employed to understand the mechanism of reduction in TD density. Raman and photoluminescence measurements indicate that the InA1N interlayer can improve the crystal quality of GaN film, and verify that there is no additional residual stress induced into the GaN film with InA1N interlayer. Atomic force microscopy measurement shows that the InA1N interlayer brings in a smooth surface morphology of GaN film. All the results show that the insertion of the InA1N interlayer is a convenient method to achieve excellent crystal quality in GaN epitaxy.     

耗散粒子动力学GPU并行计算研究

研究了耗散粒子动力学基于计算统一设备架构的图形处理器(GPU)并行计算的实施.对其中涉及的算法映射模型、Cell-List法数组的并行化更新、随机数生成、存储器访问优化、负载平衡等进行了详细的讨论.进一步模拟了Poiseuille流动和突扩突缩流动,从而验证了GPU计算结果的正确性.计算结果表明,相对于基于中央处理器的串行计算,在耗散粒子动力学中实施GPU并行计算可以获得约20倍的加速比.     

低聚壳聚糖几何结构和物理化学属性的理论研究

运用密度泛函B3LYP/6-31G+(d)方法对gg构象的低聚壳聚糖进行了结构优化、频率计算和电子结构,并用更高精度的WB97XD/6-311+G(d,p)方法计算了平均结合能及零点能校正,分析了热力学性质.结果表明,由于低聚壳聚糖中的氢键作用,使其形成螺旋结构;聚合度的增加,使平均结合能随之下降,结构的稳定性增强;在降解过程中,均为放热反应,验证了利用降温来提高降解产率的实验的可行性;此外,聚合度的增加,使能隙减小且快速收敛于聚合度为7的6.99 eV,稳定的反应活性与实验相符;HOMO、LUMO的电子密度分布表明,化学活性集中在C2位的氨基、C6位的羟基以及链的两端位置.该结果对低聚壳聚糖模型的建立和低聚壳聚糖降解过程、活性位置以及物理化学属性的尺寸依赖等现象的研究有着指导意义.     

荧光显微镜研究极端pH值诱导磷脂支撑膜的侧向再组织

利用荧光显微镜研究了极端pH值诱导支撑磷脂双层膜的侧向再组织.结果表明,在强酸/强碱性溶液中,流动性较好的二油酰磷脂酰胆碱支撑膜出现破裂、分离、出芽或生出微管等与细胞内吞和外排相似的现象.基于极性分子与H+/H3O+或OH-的相互作用,以电中性的磷脂首基为核吸附溶液中的H+/H3O+或OH-.当磷脂膜上下叶吸附的电荷量不同时,引起两叶有效面积差,即磷脂膜曲率不对称,从而诱发磷脂膜出现各种结构和动力学的响应.本研究有助于理解极端环境对生物膜的影响,为研究生物膜的形变过程提供了参考.     

Intelligibility enhancement for noisy whispered speech using asymmetric cost function

We proposed two whispered speech enhancement methods based on asymmetric cost functions in this paper to deal with the amplification and attenuation distortions of whispered speech distinctively.The modified Itakura-Saito（MIS）distance function provides more penalties to speech amplification distortion,whereas the Kullback-Leibler（KL）divergence function gives more penalties to speech attenuation distortion.The experimental results show that the MIS function based method achieves significant improvement of intelligibility in contrast to the conventional speech enhancement algorithms when the signal-to-noise ratio（SNR）falls below-6 dB,whereas the KL function based one achieves the similar result as the minimum mean square error（MMSE）speech enhancement method.The results show that the effects of the amplification and attenuation distortions on the intelligibility of the enhanced whisper are different,where larger attenuation distortion may result in better intelligibility of speech with low SNR.However,the attenuation distortion has small effects on intelligibility of speech with high SNR.     

Joint decision and Naive Bayes learning for detection of space multi-target

In the photoelectric tracking system, the detection of space multi-target is crucial for target localization and tracking. The difficulties include the interferences from CCD smear and strong noise, the few characteristics of spot-like targets and the challenge of multiple targets. In this paper, we propose a hybrid algorithm of joint decision and Naive Bayes (JD-NB) learning, and present the duty ratio feature to discriminate the target and smear blocks. Firstly, we extract the proper features and train the parameters of the Naive Bayes classifier. Secondly, target blocks are preliminarily estimated with the Naive Bayes. Lastly, the 4-adjacent blocks of the candidate target blocks are jointed to analyze the distribution pattern and the true target blocks are secondarily extracted by the method of pattern matching. Experimental results indicate that the proposed JD-NB algorithm not only possesses a high recognition rate of better than 90% for the target block, but also effectively overcomes the disturbance of the smear block. Moreover, it performs well in the detection of small and faint targets when the SNR of the block is higher than about 0.014.     

双硬度靶对球形弹丸的防护性能

以钢/铝双硬度爆炸焊接复合靶为研究对象,采用系列弹道实验和数值模拟方法,研究了其在球形弹丸垂直侵彻作用下的抗侵彻性能。侵彻实验利用直径为14.5mm的滑膛枪发射直径为6mm的钢质球形弹丸;采用LS-DYNA3D非线性有限元程序和有限元-光滑粒子流体动力学(FE-SPH)耦合法,进行数值模拟。基于实验和数值模拟结果,分析了不同靶板的毁伤机理和破坏模式,以及靶板厚度、强度等因素对复合靶抗侵彻性能的影响。结果表明:在球形弹丸的垂直侵彻作用下,钢面板发生剪切冲塞破坏,铝背板发生延性扩孔破坏;对于双层靶而言,钢面板与铝背板的厚度比约为2/3时,复合靶的抗侵彻性能最差;数值计算结果与实验结果吻合良好,表明FE-SPH耦合算法可较好地预测双层复合靶板的抗侵彻性能。     

基于超临界流体技术制备葡萄糖脂质体的实验研究

脂质体由于其特殊的结构和性能,是一种很有发展潜力的药物载体,在医药和化妆品等行业具有广阔的应用前景。超临界逆向蒸发法是用超临界流体代替有机溶剂制备脂质体的方法,具有对水溶性药物脂质体制备过程简单、包覆率高等特点。以葡萄糖为模型药物,利用该方法制备出了葡萄糖脂质体,并详细考察了不同工艺条件对脂质体粒径和包覆率的影响。结果表明:用超临界逆向蒸发法可成功地制备出最小粒径为290nm、包覆率最高可达41.3%的葡萄糖脂质体。压力、温度和平衡时间对粒径和包覆率都有较大的影响。压力在10~30MPa时,随压力的增加,脂质体粒径显著减小至某一值后,基本趋于稳定,而包覆率逐渐增加,达到25.7%~27.5%,随后包覆率逐渐减小;温度在35~65℃时,随温度的增加粒径显著减小至最小值,然后逐渐增大,而包覆率一直增大,最高可达41.3%;平衡时间在15~45min时,随平衡时间的增加,粒径相对稳定,而包覆率显著增加,超过45min之后,粒径显著增加,包覆率显著下降。