Improved Crystallinity of Poly(3-hexylthiophene-2,5-diyl):[6,6]-Phenyl-C61 Butyric Acid Methyl Ester Film by Pulsed Electrospray Deposition

We investigated crystallinity parameters and ordering domains of poly(3-hexylthiophene-2,5-diyl) blended in [6,6]-phenyl-C₆₁-butyric acid methyl ester films, which were fabricated by pulsed electrospray deposition methods. The crystallinity parameter and the ordering domain were estimated from Raman and optical absorption spectra, respectively. As a result, they were improved with decreasing the off time of pulse voltage, corresponding to the slow evaporation speed of solvent. In addition, both the space-charge limited current mobility and the photoconversion efficiency showed same trend. A highest photoconversion efficiency of 1.11 % was achieved without the thermal annealing process after depositing the active layer.     

Pyrolysis of Hailar lignite in an autogenerated steam agent

An in situ pyrolysis process of high moisture content lignite in an autogenerated steam agent was proposed. The aim is to utilize steam autogenerated from lignite moisture as a reactant to produce fuel gas and additional hydrogen. Thermogravimetric analysis revealed that mass loss and maximum mass loss rate increased with the rise of heating rates. The in situ pyrolysis process was performed in a screw kiln reactor to investigate the effects of moisture content and reactor temperature on product yields, gas compositions, and pyrolysis performance. The results demonstrated that inherent moisture in lignite had a significant influence on the product yield. The pyrolysis of L _R (raw lignite with a moisture content of 36.9 %, wet basis) at 900 °C exhibited higher dry yield of 33.67 mL g^?1 and H₂ content of 50.3 vol% than those from the pyrolysis of the predried lignite. It was also shown that increasing reaction temperature led to a rising dry gas yield and H₂ yield. The pyrolysis of L _R showed the maximum dry yield of 33.7 mL g^?1 and H₂ content of 53.2 vol% at 1,000 °C. The LHV of fuel gas ranged from 18.45 to 14.38 MJ Nm^?3 when the reactor temperature increased from 600 to 1,000 °C.     

Improved electrochemical performance of LiNi0.5Mn1.5O4 as cathode of lithium ion battery by Co and Cr co-doping

Three samples, LiNi_0.5Mn_1.5O₄, LiNi_0.4Mn_1.4Co_0.2O₄, and LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄, were prepared by sol–gel method and characterized by powder X-ray diffraction, Fourier transformed infrared spectroscope, scanning electron microscopy, Brunauer–Emmett–Teller surface area, four-probe resistance, cyclic voltammetry, electrochemical impedance spectroscopy, and charge–discharge test. It is found that the co-doped sample LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄ exhibits an improved performance compared with the Co-doped sample LiNi_0.4Mn_1.4Co_0.2O₄ and the undoped sample LiNi_0.5Mn_1.5O₄, especially at elevated temperature. At 25 °C, the discharge capacity of LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄ is 130 mAh g^?1 at 0.1 C and 103 mAh g^?1 at 10 C. At an elevated temperature (55 °C), its 1 C discharge capacity is 136 mAh g^?1 and maintains 95.6 % of its initial capacity after 100 cycles. Compared with the reported results of LiNi_0.4Mn_1.4Co_0.2O₄ and LiNi_0.475Mn_1.475Co_0.05O₄, the co-doped sample LiNi_0.4Mn_1.4Cr_0.15Co_0.05O₄, with least content of Co, 0.05, possesses not only the high C-rate capacity but also the structural stability. The mechanism on the electrochemical performance improvement of LiNi_0.5Mn_1.5O₄ by the co-doping was discussed.     

Silver(I)‐Catalyzed Hydroazidation of Ethynyl Carbinols: Synthesis of 2‐Azidoallyl Alcohols

The hydroazidation of alkynes is the most straightforward pathway to synthetically useful vinyl azides. However, a general hydroazidation of alkynes remains elusive. Herein, a chemo‐ and regioselective transformation of ethynyl carbinols into vinyl azides is described. This reaction produces a wide variety of 2‐azidoallyl alcohols with high efficiency and in good to excellent yields. These compounds constitute a new class of densely functionalized synthetic intermediates. Their synthetic potential has been demonstrated by further transformations into NH aziridines. The mechanistic aspects of the reaction will attract the attention of chemists working on alkyne chemistry and silver catalysis. The findings that are described in this paper represent significant advances in the regioselective hydroelementation of alkynes and open a new reaction manifold for exploitation.     

Restraint of stress in fabricating the large areas of crack-free porous silica films in the presence of composite polydimethylsiloxane

To present a new method of fabricating the large areas of crack-free porous silica films by introduction of composite polydimethylsiloxanes (PDMS). We employed two kinds of side-chain polyether modified by PDMS terminated with Si–CH₃ and Si–OC₂H₅ groups in preparation of large areas of porous silica films. The porous film presents a mesopore structure with a porosity of 58.0 %, which is fit for thermal-isolating layer applied in pyroelectric devices. The stress evolution on gel-to-ceramic film conversion has been investigated. The results reveal that a slow decrease in tensile stress before 250 °C and a slow increase after 250 °C can be observed, which is closely related to the alteration of chemical composition in the heat-treatment process. It is clear that the stress has been restrained with the addition of composite PDMS.     

A 3D 12‐Ring Zeolite with Ordered 4‐Ring Vacancies Occupied by (H2O)2 Dimers

A germanate zeolite, PKU‐14, with a three‐ dimensional large‐pore channel system was structurally characterized by a combination of high‐resolution powder X‐ray diffraction, rotation electron diffraction, NMR, and IR spectroscopy. Ordered Ge₄O₄ vacancies inside the [4⁶.6¹²] cages has been found in PKU‐14, in which a unique (H₂O)₂ dimer was located at the vacancies and played a structure‐directing role. It is the first time that water clusters are found to be templates for ordered framework vacancies.     

Visible‐Light‐Responsive Reversible Photoacid Based on a Metastable Carbanion

A new photoacid that reversibly changes from a weak to a strong acid under visible light was designed and synthesized. Irradiation generated a metastable state with high C?H acidity due to high stability of a trifluoromethyl‐phenyl‐tricyano‐furan (CF₃PhTCF) carbanion. This long‐lived metastable state allows a large proton concentration to be reversibly produced with moderate light intensity. Reversible pH change of about one unit was demonstrated by using a 0.1 mM solution of the photoacid in 95 % ethanol. The quantum yield was calculated to be as high as 0.24. Kinetics of the reverse process can be fitted well to a second‐order‐rate equation with k=9.78×10² M ^?1 s^?1. Response to visible light, high quantum yield, good reversibility, large photoinduced proton concentration under moderate light intensity, and good compatibility with organic media make this photoacid a promising material for macroscopic control of proton‐transfer processes in organic systems.     

Kinetic Resolution of Racemic Mandelic Acid Esters by N,N′‐Dioxide–Scandium‐Complex‐Catalyzed Enantiomer‐Selective Acylation

A simple and efficient acylative kinetic resolution of racemic mandelic acid esters was accomplished with a chiral N,N’‐dioxide–scandium(III) complex under mild and base‐free reaction conditions. A variety of mandelic acid esters performed well in the reaction, obtaining both acylated products (up to 49% yield, 97% ee) and recovered substrates (up to 49% yield, 95% ee) in high enantioselectivities with perfect selectivity factors (up to 247). The enantioselective recognition and catalytic models were also proposed for the catalytic KR reaction.     

Silver‐Catalyzed Cross‐Coupling of Propargylic Alcohols with Isocyanides: An Atom‐Economical Synthesis of 2,3‐Allenamides

Cross‐coupling reactions between propargylic alcohols and isocyanides, by means of silver catalysis, have been described. This new reaction is both atom and step efficient and is applicable to a broad scope of substrates, allowing the synthesis of a range of synthetically valuable 2,3‐allenamides in moderate to excellent yields.