Search for the rare leptonic decay B--->tau-nutau

We present a search for the decay B(-)--> tau(-)nu(tau) in a sample of 88.9 x 10(6) BB pairs recorded with the BABAR detector at the Stanford Linear Accelerator Center B factory. One of the two B mesons from the Gamma(4S) is reconstructed in a hadronic or a semileptonic final state, and the decay products of the other B in the event are analyzed for consistency with a B(-) --> tau(-)nu(tau) decay. We find no evidence of a signal and set an upper limit on the branching fraction of B(B(-) --> tau(-) nu(tau)) < 4.2 x 10(-4) at the 90% confidence level.     

Solitons and intrinsic localized modes in a one-dimensional antiferromagnetic chain

By use of the Hartree approximation and the method of multiple scales, we investigate quantum solitons and intrinsic localized modes in a one-dimensional antiferromagnetic chain. It is shown that there exist solitons of two different quantum frequency bands: i.e., magnetic optical solitons and acoustic solitons. At the boundary of the Brillouin zone, these solitons become quantum intrinsic localized modes: their quantum eigenfrequencies are below the bottom of the harmonic optical frequency band and above the top of the harmonic acoustic frequency band.     

Controllable synthesis of high aspect ratio Mg_2B_2O_5 nanowires and their applications in reinforced polyhydroxyalkanoate composites

Highly pure magnesium borate （Mg2B2O5） nanowires with an average diameter of - 30 nm, an average length of 15 μm, and a high aspect ratio of - 500 have been synthesized on a large scale via a two-step method. MgBO2（OH） nanowires with high aspect ratios were first prepared via a PVP-assisted hydrothermal technique. Using these nanowires as precursors, single crystalline Mg2B205 nanowires were synthesized by post-annealing treatment at a relatively low temperature of 700 ℃. The important effect of the MgBO2（OH）-Mg2B2O5 conversion process on the morphology of the Mg2B2O5 nanowires was investigated and it was indicated that the recrystallization process plays an important role in the protection of the one-dimensional （1D） nanostructure. Moreover, the rigidity and the toughness of the Mg2B2O5 nanowire- reinforced PHA composites were tremendously improved compared to those of the pure PHA. Our results demonstrate the effectiveness of Mg2B2O5 nanowires for reinforcement applications in polymer composites.     

外电场下二氧化锆的分子结构及其特性

对O原子采用6-311++G*基组,Zr原子采用aug-cc-pVTZ-PP基组,利用密度泛函(B3P86)方法优化得到了ZrO2分子的稳定构型,并研究了不同外电场(0—0.025 a.u.)作用下ZrO2基态分子键长、能量、电荷分布、偶极矩和能级的变化规律.在优化构型的基础上,利用含时密度泛函(TD-B3P86)方法研究了ZrO2分子在外电场作用下前6个激发态的激发能、跃迁波长和振子强度的激发特性.研究结果表明:随着电场强度的增大,Zr—2O的键长增大,而Zr—3O的键长均匀减少,总能量降低,偶极矩增大;最高占据轨道能量基本保持不变,最低未占据轨道和能隙均减小.电场的增大使得激发能减小,各个激发态跃迁波长均发生不同程度的红移现象,因而,利用外电场可以控制ZrO2的发光光谱范围在可见-红外区域扩展.     

Q波段回旋行波管宽带高平均功率输出窗设计与热分析

利用场匹配理论建立传输级联矩阵的方法对多层窗片结构输出窗进行研究,通过大量的数值计算给出Q波段回旋行波管一种新型中间风冷结构输出窗的参数,然后通过数值计算和HFSS仿真验证,该新型输出窗在46~50 GHz范围内,S11反射系数小于-20 dB。在此基础上进一步对该输出窗进行热分析,热分析表明：新型输出窗窗片中心与边缘温差与传统输出窗相比大幅下降,热应力大大减小,提高了输出窗的功率容量。回旋行波管工作在TE01模式时,新型输出窗获得的最大饱和功率容量达到90 kW,与传统输出窗相比,功率容量提高了21.8 kW。     

离线测量钍快中子裂变反应率方法

钍快中子裂变反应率是钍铀燃料循环中的重要数据.为了测量基于聚变-裂变混合能源堆包层概念设计的钍样品在宏观中子学装置中的钍快中子裂变数据,发展了钍快中子裂变率的离线活化γ测量方法.通过测量232Th裂变碎片85mKr的β衰变产物85Rb发射的151.16 keV特征γ射线,并结合钍裂变产额数据,获得了钍样品装置中232Th裂变反应率的分布.详细介绍了此方法的原理和影响因素,并利用14 MeV的D-T中子源在贫铀球壳中开展了校验实验,实验不确定度为5.3%—5.5%.采用MCNP5程序和ENDF/B-VI及ENDF/B-VII数据库模拟计算的结果与实验结果在实验不确定度内基本符合,这证明该方法能够有效地模拟装置中232Th裂变反应率.     

Expected thermal deformation and wavefront preservation of a cryogenic Si monochromator for Cornell ERL beamlines

Cornell energy‐recovery linac (ERL) beamlines will have higher power density and higher fractional coherence than those available at third‐generation sources; therefore the capability of a monochromator for ERL beamlines has to be studied. A cryogenic Si monochromator is considered in this paper because the perfect atomic structure of Si crystal is needed to deliver highly coherent radiation. Since neither the total heat load nor the power density alone can determine the severity of crystal deformation, a metric called modified linear power density is used to gauge the thermal deformation. For all ERL undulator beamlines, crystal thermal deformation profiles are simulated using the finite‐element analysis tool ANSYS, and wavefront propagations are simulated using Synchrotron Radiation Workshop. It is concluded that cryogenic Si monochromators will be suitable for ERL beamlines in general.     

电力机车用高温超导变压器电流引线导热路径延伸方法的研究

按照车用高温超导变压器对电流引线的要求,以有限元体传热学为分析基础,对电流引线进行了传热计算,给出了初步设计方案。针对车载变压器的有限空间,提出了通过将引线绕制成螺线管状的方法来解决引线的导热路径长度较长与空间可用高度不够的矛盾,并通过热损耗分析得出下端绕制方式优于上端绕制方式的结论。     

偶极子在径向非均匀介质中的电磁场分布

提出了柱状多层介质中的磁偶极子在任意介质层中的电磁场的递推算法，给出了磁偶极子产生的电磁波在柱状多层介质中的反射、透射系数和广义反射系数，从而得到了任意介质层中满足各层界面边界条件的电磁场解析表达式．     

黑腔靶中超热电子特性研究

近几年来,在“神光”装置上进行了1.053μm激光与平面靶及一系列柱形黑腔靶相互作用实验。用一台多道滤波—荧光X光能谱仪(FFS)测得各种靶发射的超热X射线谱,由谱推导超热电子温度T_h和超热电子总能量E_h当照射靶单束激光能量E_(tar)为400～670J、脉宽τ=650～1150ps时,发现黑腔内明显存在两群服从Maxwell分布高能电子(T_h=35～45keV;T_(hh)=150～350kev),而且E_(he)占E_(tar)的份额为10％～12％。实验还表明:腔内的E_(he)与非线性过程特征量(SRS)有较好的线性关系,因此推断出腔内超热电子产生的主要机制是受激Raman散射。在相同照射条件下,黑腔靶产生的超热电子比平面靶严重。