Light-induced defect creation in hydrogenated polymorphous silicon during repeated cycles of illumination and annealing

We have examined how the intensity of the ESR signal associated with dangling bonds in hydrogenated polymorphous silicon is affected by repeating light-soaking (LS) and 100°C annealing cycles. It was found that the light-induced degradation efficiency decreases with repeated LS–100°C annealing cycles. This result is accounted for in terms of the termination of dangling bonds by mobile hydrogen, i.e. the termination is enhanced by more mobile hydrogen as a result of modification of the amorphous network by the LS–annealing cycles, and consequently the net light-induced defect creation rate is reduced. This is in contrast with previous models in which the decrease in the light-induced degradation efficiency on repeated LS–annealing cycles is attributed to an increase in the amount of hydrogen being ineffective for light-induced defect creation.     

On the noise limit of stress and temperature measurements with micro‐Raman spectroscopy

We report for the first time on the thorough experimental and theoretical assessment of the noise limit of mechanical stress and temperature measurements with micro‐Raman spectroscopy. A comprehensive study has been performed in which, for different incident laser light intensities and acquisition times, 1000 Raman spectra of mono‐crystalline silicon were acquired per setting. Curve fitting was employed to obtain the peak positions of all the spectra, from which the standard deviations of the measured peak positions were obtained versus the total accumulated amount of laser light incident on the sample during one measurement. It has been found that the noise in the obtained peak position decreases as 1/sqrt(n) over more than three decades of the incident amount of laser light. At very low light conditions, the noise decreases as 1/n. By comparing the experimental results obtained to recent theoretical work, we show that the acquisition is limited by photon shot noise over most of the range and is limited by electronic detector noise at very low light conditions only. Pixelation errors do not play a role. It is concluded that the low electronic noise of typical Raman spectroscope detectors is overkill for the investigation of mechanical stress and temperature in silicon and other materials with comparable peaks, as it has absolutely no influence on the noise level of such an experiment. Maximum Raman signal intensity on the detector and high quantum efficiency detection are more important. Copyright © 2013 John Wiley & Sons, Ltd.     

There and Back Again—The Journey of LiNiO2 as a Cathode Active Material

This Review provides a comprehensive overview of LiNiO₂ (LNO), almost 30 years after its introduction as a cathode active material. We aim to highlight the physicochemical peculiarities that make LNO a complex material in every aspect. We specifically stress the effect of the Li off‐stoichiometry (Li_1?zNi_1+zO₂) on every property of LNO, especially the electrochemical ones. The key instability issues that plague the compound and the strategies that have been implemented so far to overcome them are discussed in detail. Finally, the open questions that remain to be addressed by the scientific community are summarized, and the research directions that seem the most promising to enable LNO to be fully exploited are elucidated.     

On the nature of the and from their behavior in chiral dynamics

We study the behavior with the number of colors (N_c) of the Λ(1405) and Λ(1670) resonances obtained dynamically within the chiral unitary approach. The leading order meson–baryon interaction, used as the kernel of the unitarization procedure, manifests a nontrivial N_c dependence of the flavor SU(3) representation for baryons. As a consequence, the SU(3) singlet (or ) component of the Λ(1405) states remains bound in the large N_c limit, while the other components dissolve into the continuum. Introducing explicit SU(3) breaking, we obtain the N_c dependence of the excitation energy, masses and widths of the physical Λ(1405) and Λ(1670) resonances. The N_c behavior of the decay widths is found to be different from the general counting rule for a qqq state, indicating the dynamical origin of these resonances.     

Analytical methods for human biomonitoring of pesticides. A review

Biomonitoring of both currently-used and banned-persistent pesticides is a very useful tool for assessing human exposure to these chemicals. In this review, we present current approaches and recent advances in the analytical methods for determining the biomarkers of exposure to pesticides in the most commonly used specimens, such as blood, urine, and breast milk, and in emerging non-invasive matrices such as hair and meconium. We critically discuss the main applications for sample treatment, and the instrumental techniques currently used to determine the most relevant pesticide biomarkers. We finally look at the future trends in this field.     

Polysulfonylamine. CLXXXIV. Kristallstrukturen molekularer Triphenylphosphangold(I)‐di(4‐X‐benzolsulfonyl)‐amide: Isomorphie und dichte Packung (X = Me,F, Cl,NO2) vs. struktursteuernde Halogenbrücken C–X···Au/O (X = Br,I)

Polysulfonylamines. CLXXXIV. Crystal Structures of Molecular Triphenylphosphanegold(I) Di(4‐X‐benzenesulfonyl)amides: Isomorphism and Close Packing (X = Me, F, Cl, NO₂) vs. Structure‐Determining C–X···Au/O Halogen Bonds (X = Br, I) In order to study the structure‐determining influence that halogen bonding can exert during the course of crystallization, solid‐state structures are compared for two previously reported and four new molecular gold(I) complexes of the type Ph₃P–Au–N(SO₂–C₆H₄–4‐X)₂, each featuring linear P,N coordination at gold and two phenyl rings with varying p‐substituents X = Me, F, Cl, NO₂, Br or I. The compounds were synthesized by reactions of Ph₃PAuX (X = Cl or I) with the corresponding silver di(arenesulfonyl)amides, crystallized from dichloromethane, and characterized by low‐temperature X‐ray diffraction. The Me, F, Cl and NO₂ congeners are isomorphic and crystallize without solvent inclusion in the chiral orthorhombic space group P2₁2₁2₁ (Z′ = 1). These structures are governed by isotropic close packing via three‐dimensional 2₁ symmetry, incidentally supported by an invariant set of C–H···O=S hydrogen bonds, CH/π interactions and π/π stackings of aromatic rings; in particular, the hard halogen atoms of the fluoro and the chloro homologues are not involved in X···Au, X···O or X···X interactions. The higher homologues, with soft halogen atoms, were obtained as a dichloromethane hemisolvate for X = Br and a corresponding monosolvate for X = I, each triclinic in the centrosymmetric space group (Z′ = 1). Here, the primary structural effect is implemented by infinite chains in which translation‐related molecules are connected for the bromo compound by a bifurcated Au···Br(2)···O=S interaction, for the iodo congener by an equivalent Au···I(2)···O=S interaction and a short halogen bond C–I(1)···O=S. The latter bond is stronger than a similar C–Br···O=S interaction and induces a conformational adjustment of the (CSO₂)₂N group from the normal twofold symmetry in the bromo compound to an energetically unfavourable asymmetric form in the iodo homologue. In both cases, pairs of antiparallel molecular catemers are associated into strands via sixfold phenyl embraces, the strands are stacked to form layers, the solvent molecules are intercalated between adjacent layers, and the crystal packings are reinforced by a number of C–H···O=S hydrogen bonds and interactions of aromatic rings.     

Dynamic effects on reaction rates in a Michael addition catalyzed by chalcone isomerase. Beyond the frozen environment approach

We present a detailed microscopic study of the dynamics of the Michael addition reaction leading from 6'-deoxychalcone to the corresponding flavanone. The reaction dynamics are analyzed for both the uncatalyzed reaction in aqueous solution and the reaction catalyzed by Chalcone Isomerase. By means of rare event simulations of trajectories started at the transition state, we have computed the transmission coefficients, obtaining 0.76 +/- 0.04 and 0.87 +/- 0.03, in water and in the enzyme, respectively. According to these simulations, the Michael addition can be seen as a formation of a new intramolecular carbon-oxygen bond accompanied by a charge transfer essentially taking place from the nucleophilic oxygen to the carbon atom adjacent to the carbonyl group (C (alpha)). As for intermolecular interactions, we find a very significant difference in the evolving solvation pattern of the nucleophilic oxygen in water and in the enzyme. While in the former medium this atom suffers an important desolvation, the enzyme provides, through variations in the distances with some residues and water molecules, an essentially constant electric field on this atom along the reaction progress. Grote-Hynes (GH) theory provides a useful framework to systematically analyze all the couplings between the reaction coordinate and the remaining degrees of freedom. This theory provides transmission coefficients in excellent agreement with the Molecular Dynamics estimations. In contrast, neither the frozen environment approach nor Kramers theory gives results of similar quality, especially in the latter case, where the transmission coefficients are severely underestimated. The (unusual) failure of the frozen environment approach signals the importance of some dynamical motions. Within the context of GH theory, analysis of the friction spectrum obtained in the enzymatic environment, together with normal-mode analysis, is used to identify those motions, of both the substrate and the environment, strongly coupled to the reaction coordinate and to classify them as dynamically active or inactive.     

SmI(2)-promoted radical addition reactions with N-(2-Indolylacyl)oxazolidinones: synthesis of bisindole compounds

The treatment of N-acyl oxazolidinones of N-benzyl 2-indolecarboxylic acids varying in the substitution pattern of the indole ring with samarium diiodide at -78 degrees C led to the formation of two indole dimer products. The major product isolated in yields from 55 to 59% represents an unsymmetrical dimer arising from 1,4-addition to the 2-indolecarboxylic acid derivative of a possible ketyl-type radical anion intermediate originating from the reduction of the exocyclic carbonyl group of the N-acyl oxazolidinone. The minor dimer, represented by a symmetrical diketone, was produced in yields ranging from 11 to 23%. Even in the presence of an alpha,beta-unsaturated amide, dimerization was the preferred pathway rather than the formation of a gamma-keto amide. Upon treatment with acid, the unsymmetrical indole dimer cyclized to form a diindolequinone. Finally, the N-acyl oxazolidinones of pyrrole-2-carboxylic acid and 3-indolecarboxylic acid preferred in both cases to undergo C-C bond formation with an acrylamide in the presence of SmI2 rather than dimerization.     

Novel 7- and 8-endo 2-indolylacyl radical cyclizations: efficient construction of azepino- and azocinoindoles

Regioselective 7- and 8-endo cyclizations of selenoester derived 2-indolylacyl radicals upon amino tethered alkenes have been used to synthesize azepino[3,2-b]- and azocino[4,3-b]indoles, which are tricyclic subunits present in the indole alkaloids mersicarpine and apparicine, respectively.