Microwave-assisted synthesis of novel 2,3-dihydro-4-pyridinones

Novel 2,3-dihydro-4-pyridinones were synthesized via the reaction of curcumin and primary amines or amine acetates under microwave irradiation. Montmorillonite K-10 was used as a catalyst. Reaction times did not exceed 120 s. The structures of the compounds were established by elemental analysis and from their mass, 1H- and 13C-NMR spectra.     

Dissolved oxygen amperometric sensor based on layer-by-layer assembly using host-guest supramolecular interactions

The development of a simple, efficient and sensitive sensor for dissolved oxygen is proposed using the host-guest binding of a supramolecular complex at a host surface by combining a self-assembled monolayer (SAM) of mono-(6-deoxy-6-mercapto)-β-cyclodextrin (βCDSH), iron (III) tetra-(N-methyl-4-pyridyl)-porphyrin (FeTMPyP) and cyclodextrin-functionalized gold nanoparticles (CDAuNP). The supramolecular modified electrode showed excellent catalytic activity for oxygen reduction. The reduction potential of oxygen was shifted about 200 mV toward less negative values with this modified electrode, presenting a peak current much higher than those observed on a bare gold electrode. Cyclic voltammetry and rotating disk electrode (RDE) experiments indicated that the oxygen reduction reaction involves probably 4-electrons with a rate constant (k_obs) of 7 × 10⁴ mol⁻¹ L s⁻¹. A linear response range from 0.2 up to 6.5 mg L⁻¹, with a sensitivity of 5.5 μA L mg⁻¹ (or 77.5 μA cm⁻² L mg⁻¹) and a detection limit of 0.02 mg L⁻¹ was obtained with this sensor. The repeatability of the proposed sensor, evaluated in terms of relative standard deviation was 3.0% for 10 measurements of a solution of 6.5 mg L⁻¹ oxygen.     

Comparison of the molecular structures of five benzene derivatives as determined independently by gas-phase electron diffraction in two different laboratories: a perspective

The merits and limitations of gas-phase electron diffraction as a technique for determining accurately the structures of small organic molecules are demonstrated by comparing the molecular structures of five benzene derivatives studied in two different laboratories. The existence of many possible representations of the structure of a molecule (r _a, r _g, r _α, r _α⁰, r _e, …), implying differences in the physical meaning of geometrical parameters, is discussed in some detail as it may cause difficulties in a comparison. Also illustrated are different ways of estimating and expressing uncertainties in the geometrical parameters from a gas-phase electron diffraction study.     

Interactions between gemini surfactants and polymers: thermodynamic studies

Aqueous mixtures containing a homopolymer, poly(vinylpyrrolidone) (PVP), or a hydrophobically modified graft copolymer, HM-pullulan, (PULAU9, where 9 stands for the nominal substitution degree), and different Gemini surfactants have been investigated at 25.0 degrees C. A wide variety of experimental conditions were addressed by changing the amount of polymer and of surfactant. The Gemini surfactants were synthesized, purified, and characterized by routine methods. They differ from each other in polar head groups (two sulfonate-, two quaternary ammonium-, or two arginine-based groups), in alkyl chain length (11 or 12 carbon atoms), and in the distance between the polar head groups. The spacers consist of 2, 3, and 6 methylene units or 3 oxyethylene units. Surface activity and solution calorimetry measurements yield some physicochemical features inherent to micelle formation and polymer-surfactant interactions. The data are supported by ionic conductivity, detecting the critical thresholds and quantifying the modifications in binding associated with critical association (CAC) and micelle formation (CMC*). The Gibbs energy of transfer from the micelles to a polymer-binding site, DeltaGtrans, was evaluated from the CAC/CMC* ratios versus the amount of added polymer. A similar procedure determined the enthalpy of transfer, DeltaHtrans. DeltaGtrans decreases with added polymer, whereas DeltaHtrans becomes more negative on increasing the amount of polymer in the medium. According to the selected data presented here, cationic Geminis do not interact with PVP, while significant interactions have been observed in other surfactants. In mixtures with PULAU9, the interaction is significant for all Geminis. This effect is due to interactions between the surfactants and the hydrophobic alkyl groups on the main polymer chain. The pendent groups facing away from the polysaccharide chain act as binding sites for aggregates onto such polymers.     

Characterization and determination of 28 elements in fly ashes collected in a thermal power plant in Argentina using different instrumental techniques

Different techniques were selected for comprehensive characterization of seven samples of fly ashes collected from the electrostatic precipitator of the San Nicolás thermal power plant (Buenos Aires, Argentina). Particle size was measured using laser based particle size analyzer. X-ray diffraction powder (XRD) analysis and scanning electron microscopy (SEM) were used to characterize the mineral phase present in the matrix consisting basically of aluminosilicates and large amounts of amorphous material. The predominant crystalline phases were mullite and quartz. Major and minors elements (Al, Ca, Cl, Fe, K, Mg, Na, S, Si and Ti) were detected by energy dispersive X-ray analysis (EDAX). Trace elements (As, Cd, Co, Cr, Cu, Mn, Ni, Pb, Se, V and Zn) content was quantified by inductively coupled plasma optical emission spectrometry (ICP OES). Different acid mixtures and digestion procedures were compared for subsequent ICP OES measurements of the dissolved samples. The digestion procedures used were: i) a mixture of FH + HNO₃ + HClO₄ (open system digestion); ii) a mixture of FH + HNO₃ (MW-assisted digestion); iii) a mixture of HF and aqua regia (MW-assisted digestion). Instrumental neutron activation analysis (INAA) was employed for the determination of As, Ba, Co, Cr, Ce, Cs, Eu, Fe, Gd, Hf, La, Lu, Rb, Sb, Sc, Sm, Ta, Tb, Th, U and Yb. The validation of the procedure was performed by the analysis of two certified materials namely, i) NIST 1633b, coal fly ash and ii) GBW07105, rock. Mean elements content spanned from 41870 μg g^− 1 for Fe to 1.14 μg g^− 1 for Lu. The study showed that Fe (41870 μg g^− 1) ? V (1137 μg g^− 1) > Ni (269 μg g^− 1) > Mn (169 μg g^− 1) are the main components. An enrichment, with respect to crustal average, in many elements was observed especially for As, V and Sb that deserve particular interest from the environmental and human health point of view.     

Changes of the solution pH due to exposure by high-voltage electric pulses

The change of the pH of a NaCl solution (139-149 mM NaCl) buffered with 5-15 mM sodium phosphates (pH 7.4) during electromanipulation was studied. It has been determined that an increase in the pH value of electroporation solution of a whole chamber volume, caused by the application of electric field pulses, commonly used in cell electromanipulation procedures, can exceed 1-2 pH units. Several materials for the cathode were tested. In all cases a stainless steel anode was utilized. The aluminum cathode gave a two-fold greater DeltapH in comparison with platinum, copper or stainless steel cathodes. In addition, a substantial release of aluminum (up to 1 mg/l) from the cathode was observed. It has also been found that the shift in pH depended on the medium conductivity: DeltapH of the solution, in which sucrose was substituted for NaCl, was about 5 times less. On the basis of the results obtained here, to avoid the plausible undesirable consequences of the cathodic electrolysis processes, in particular under the conditions of strong electric treatment, it could be recommended that chambers with aluminum electrodes not be utilized and one should use strongly buffered solutions of low conductivity and alternating current (sine or square wave) bipolar electric pulses.     

Determination of thickness, dielectric constant of thiol films, and kinetics of adsorption using surface plasmon resonance

This paper describes the formation of a self-assembled monolayer of 11-mercaptoundecanoic acid (MUA) under different concentrations on a gold sensor disk, monitoring in situ and in real time using surface plasmon resonance spectroscopy (SPR). The film thickness and dielectric constant were determined for a fully formed monolayer using one-color approach SPR. The kinetic studies of the film formation in ethanol solution indicated that the self-assembled monolayer is formed in a two-step adsorption process. In this sense, this unpublished route was applied on the basis of a model where many molecules are adsorbed at an initial step and then can be desorbed and/or rearranged to form a perfect monolayer.     

Chromium‐Mediated Dearomatization: Application to the Synthesis of Racemic 15‐Acetoxytubipofuran and Asymmetric Synthesis of Both Enantiomers

An efficient dearomatization process of [Cr(arene)(CO)₃] complexes initiated by a nucleophilic acetaldehyde equivalent is detailed. It generates in a one‐pot reaction three C? C bonds and two stereogenic centers. This process allowed a rapid assembly of a cis‐decalin ring system incorporating a homoannular diene unit in just two steps starting from aromatic precursors (Scheme 2). The method was applied to the total synthesis of the eudesmane‐type marine furanosesquiterpene (±)‐15‐acetoxytubipofuran ( 2 ). Two routes were successfully used to synthesize the γ‐lactone precursor of the furan ring. The key step in the first approach was a Pd‐catalyzed allylic substitution (Scheme 3), while in the second approach, an Eschenmoser–Claisen rearrangement was highly successful (Scheme 4). The Pd‐catalyzed allylic substitution could be directed to give either the (normal) product with overall retention as major diastereoisomer or the unusual product with inversion of configuration (see Table). For the synthesis of the (?)‐enantiomer (R,R)‐ 2 of 15‐acetoxytubipofuran, an enantioselective dearomatization in the presence of a chiral diether ligand was implemented (Scheme 7), while the (+)‐enantiomer (S,S)‐ 2 was obtained via a diastereoselective dearomatization of an arene‐bound chiral imine auxiliary (Scheme 8). Chiroptical data suggest that a revision of the previously assigned absolute configuration of the natural product is required.     

Theoretical study of unimolecular rearrangements of vinylidenes to acetylenes

The rearrangement of vinylidene to acetylene has been studied in detail by the density functional method, using Becke's three‐parameter exchange functional and the gradient‐corrected functional of Lee, Yang, and Parr. The rearrangement of the anion, as well as that of fluoro‐substituted systems, has also been investigated, in order to determine the effect of fluorine substitution on the activation barrier to the 1,2‐hydrogen shift, as well as the relative migratory aptitudes of hydrogen and fluorine. Natural bond orbital analysis is invoked to gain insight into the mechanisms of the rearrangements. Basis size effects are also discussed, particularly in relation to anionic systems. The need to include diffuse functions in geometry optimizations of anionic systems is reinforced by the present calculations. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2005