Volumetric Properties of Binary Mixtures of Isomeric Butanols and C8 Solvents at 298.15 K

Excess molar volumes, V _m ^E, over the whole composition range for binary mixtures of 1-butanol, 2-butanol, and 2-methyl-2-propanol + 1-octanol, or 2-octanol, or di-n-butyl ether, or n-hexylacetate were determined at 298.15 K from density measurements carried out with a vibrating-tube densimeter. Small V _m ^E values, both positive and negative, are displayed by mixtures containing 1- or 2-octanol, whereas positive and larger values are always found for mixtures containing dibutyl ether and hexylacetate. These results can be justified in terms of H-bonding interactions and/or steric hindrance due to the branched alkyl chains. Partial molar volumes at infinite dilution of the isomeric butanols in the C8 compounds were also calculated from the apparent molar volumes in dilute solution. The solute-solvent interactions and the effects of the local organisation of the solvent around the butanol molecules were discussed using the void and cavity volumes as different estimates of the intrinsic volume of the molecules. The volumetric behavior of butanols seems to be determined by the solute-solvent interactions rather than packaging effects.     

Analysis of proteins from a glioma cell line by using micro-scale solution isoelectric focusing in combination with liquid chromatography/tandem mass spectrometry

In this study we have investigated whether micro-solution isoelectric focusing (microsol-IEF) can be used as a pre-fractionation step prior to liquid chromatography/tandem mass spectrometry (LC/MS/MS) and if extensive sample purification of the different fractions is required. We found that, in spite of the high concentrations of buffer and detergents, no clean up of the digested microsol-IEF fractions was necessary before analysis by LC/MS/MS. We also concluded that it is possible to identify at least twice as many proteins in a glioma cell lysate with the combination of microsol-IEF and LC/MS/MS than with LC/MS/MS alone. Furthermore, most of the proteins that were identified from one microsol-IEF fraction by using analytical narrow-range two-dimensional polyacrylamide gel electrophoresis (2D-PAGE) and peptide mass fingerprinting with matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS) were also identified by LC/MS/MS. Finally, we used the combination of microsol-IEF and LC/MS/MS to compare two sample preparation methods for glioma cells and found that several nuclear, mitochondria, and endoplasmic reticulum proteins were only present in the sample that had been subjected to lipid extraction by incubating the homogenized cells in chloroform/methanol/water.     

Huang diffuse scattering from interstitials in a general orthorhombic and tetragonal lattice

Using the continuum theory of linear elasticity, Huang diffuse scattering (HDS) has been calculated from self-interstitials in a general orthorhombic and tetragonal lattice. Various defect configurations are represented according to the point group symmetry of the defect site. The contribution toHDS from all possible equivalent orientations (assumed to be equally populated) of the defect configuration is averaged. The limitations ofHDS in discriminating between defect configurations having the same long-range symmetry are discussed, considering some special cases.     

Metal complexes of sulphur-nitrogen chelating agents. Part 14. Nickel(II), palladium(II), copper(II), cobalt(II), and cobalt(III) complexes of the tetradentate schiff bases having ONNS donor sites

Summary Complexes of nickel(II), palladium(II), copper(II), cobalt(II), and cobalt(III) with methyl-2-(-salicylaldiminoethyl)-cyclopent-1-en-dithiocarboxylate (H₂L¹) and methyl-2-(-salicylaldiminoisopropyl)cyclopent-1-en-dithiocarboxylate (H₂L²) have been prepared. They contain the donor sites ONNS. The metal(II) ions from neutral, monomeric square planar chelate complexes. The cobalt(III) complexes [CoL¹-(H₂O)₂]X (X=Cl or ClO₄) appear to betrans-diaqua-species. All compounds have been characterized by a number of physico-chemical methods.     

Persistent bissilylated arenium ions

A series of bissilylated arenium ions 1 with different substitution patterns on the aryl ring have been synthesized by hydride abstraction from 2-aryl-substituted 2,6-dimethyl-2,6-disilaheptanes (2) via transient silylium ions. The arenium ions have been identified by their characteristic NMR chemical shifts, (delta(29)Si=19.1-25.6, delta(13)C(ipso) =89.0-102.4, delta(13)C(ortho)=160.9-182.0, delta(13)C(meta)=132.5-146.9, delta(13)C(para)=150.2-169.9) supported by quantum mechanical calculations of structures, energies, and magnetic properties at the B3LYP/6-311G(d,p)//B3LYP/6-31G(d) + DeltaZPVE level of theory. The calculations clearly reveal the charge dispersing and stabilizing effect of the silyl substituents in arenium ions 1. The bissilylated benzenium ion 1a is more stable than the parent benzenium ion (C(6)H(7)(+)) by 37.6 kcalmol(-1). The synthesized arenium ions 1 are stable in solution at room temperature for periods ranging from a few hours to days. This unusual stability is attributed to: 1) the thermodynamic stabilization of the arenium ion by two beta-silyl substituents and 2) the essentially non-nucleophilic reaction conditions (the use of the weakly coordinating [B(C(6)F(5))(4)](-) anion and aromatic hydrocarbons as solvents). Addition of stronger nucleophiles than aromatic hydrocarbons (for example, acetonitrile) results in desilylation of the arenium ion 1 and recovery of the 2-aryl-2,6-disilaheptane moiety.     

Comparative study of separation and determination of triazines by micellar electrokinetic capillary chromatography and nonaqueous capillary electrophoresis: application to residue analysis in natural waters

The separation and determination of a mixture of chloro- and methylthiotriazines in water samples by both micellar electrokinetic capillary chromatography (MEKC) and nonaqueous capillary zone electrophoresis (NA-CZE) were compared. The characteristics of both methods proved to be very similar in terms of separation efficiency and analysis times, but application of these methods for the analysis of triazines in natural waters, with a prior preconcentration step, revealed significant differences. A preconcentration step by solid-phase extraction (SPE) with Oasis HLB cartridges was accomplished for the determination of triazines at sub-ppb levels in drinking and river waters; when NA-CZE was used after this SPE step, electropherograms with fewer interferences and more stable baselines were obtained than when separation was carried out using MEKC. Another aspect related to the application to real samples was the lack of precision encountered upon evaluating the electrophoretic signals generated when using SPE coupled with NA-CZE. Here, we demonstrate the importance of choosing an appropriate internal standard for analyte quantification. It is recommended that a triazine belonging to the same family as that of the triazine to be determined should be used as internal standard.     

Changes of the solution pH due to exposure by high-voltage electric pulses

The change of the pH of a NaCl solution (139-149 mM NaCl) buffered with 5-15 mM sodium phosphates (pH 7.4) during electromanipulation was studied. It has been determined that an increase in the pH value of electroporation solution of a whole chamber volume, caused by the application of electric field pulses, commonly used in cell electromanipulation procedures, can exceed 1-2 pH units. Several materials for the cathode were tested. In all cases a stainless steel anode was utilized. The aluminum cathode gave a two-fold greater DeltapH in comparison with platinum, copper or stainless steel cathodes. In addition, a substantial release of aluminum (up to 1 mg/l) from the cathode was observed. It has also been found that the shift in pH depended on the medium conductivity: DeltapH of the solution, in which sucrose was substituted for NaCl, was about 5 times less. On the basis of the results obtained here, to avoid the plausible undesirable consequences of the cathodic electrolysis processes, in particular under the conditions of strong electric treatment, it could be recommended that chambers with aluminum electrodes not be utilized and one should use strongly buffered solutions of low conductivity and alternating current (sine or square wave) bipolar electric pulses.     

Characterization and determination of 28 elements in fly ashes collected in a thermal power plant in Argentina using different instrumental techniques

Different techniques were selected for comprehensive characterization of seven samples of fly ashes collected from the electrostatic precipitator of the San Nicolás thermal power plant (Buenos Aires, Argentina). Particle size was measured using laser based particle size analyzer. X-ray diffraction powder (XRD) analysis and scanning electron microscopy (SEM) were used to characterize the mineral phase present in the matrix consisting basically of aluminosilicates and large amounts of amorphous material. The predominant crystalline phases were mullite and quartz. Major and minors elements (Al, Ca, Cl, Fe, K, Mg, Na, S, Si and Ti) were detected by energy dispersive X-ray analysis (EDAX). Trace elements (As, Cd, Co, Cr, Cu, Mn, Ni, Pb, Se, V and Zn) content was quantified by inductively coupled plasma optical emission spectrometry (ICP OES). Different acid mixtures and digestion procedures were compared for subsequent ICP OES measurements of the dissolved samples. The digestion procedures used were: i) a mixture of FH + HNO₃ + HClO₄ (open system digestion); ii) a mixture of FH + HNO₃ (MW-assisted digestion); iii) a mixture of HF and aqua regia (MW-assisted digestion). Instrumental neutron activation analysis (INAA) was employed for the determination of As, Ba, Co, Cr, Ce, Cs, Eu, Fe, Gd, Hf, La, Lu, Rb, Sb, Sc, Sm, Ta, Tb, Th, U and Yb. The validation of the procedure was performed by the analysis of two certified materials namely, i) NIST 1633b, coal fly ash and ii) GBW07105, rock. Mean elements content spanned from 41870 μg g^− 1 for Fe to 1.14 μg g^− 1 for Lu. The study showed that Fe (41870 μg g^− 1) ? V (1137 μg g^− 1) > Ni (269 μg g^− 1) > Mn (169 μg g^− 1) are the main components. An enrichment, with respect to crustal average, in many elements was observed especially for As, V and Sb that deserve particular interest from the environmental and human health point of view.     

Water concentration profiles in membranes measured by ESEEM of spin-labeled lipids

Electron spin-echo envelope modulation (ESEEM) spectroscopy of phospholipids spin-labeled systematically down the sn-2 chain was used to detect the penetration of water (D2O) into bilayer membranes of dipalmitoyl phosphatidylcholine with and without 50 mol % cholesterol. Three-pulse stimulated echoes allow the resolution of two superimposed 2H-ESEEM spectral components of different widths, for spin labels located in the upper part of the lipid chains. Quantum chemical calculations (DFT) and ESEEM simulations assign the broad spectral component to one or two D2O molecules that are directly hydrogen bonded to the N-O group of the spin label. Classical ESEEM simulations establish that the narrow spectral component arises from nonbonded water (D2O) molecules that are free in the hydrocarbon chain region of the bilayer membrane. The amplitudes of the broad 2H-ESEEM spectral component correlate directly with those of the narrow component for spin labels at different positions down the lipid chain, reflecting the local H-bonding equilibria. The D2O-ESEEM amplitudes decrease with position down the chain toward the bilayer center, displaying a sigmoidal dependence on position that is characteristic of transmembrane polarity profiles established by other less direct spin-labeling methods. The midpoint of the sigmoidal profile is shifted toward the membrane center for membranes without cholesterol, relative to those with cholesterol, and the D2O-ESEEM amplitude in the outer regions of the chain is greater in the presence of cholesterol than in its absence. For both membrane types, the D2O amplitude is almost vanishingly small at the bilayer center. The water-penetration profiles reverse correlate with the lipid-chain packing density, as reflected by 1H-ESEEM intensities from protons of the membrane matrix. An analysis of the H-bonding equilibria provides essential information on the binding of water molecules to H-bond acceptors within the hydrophobic interior of membranes. For membranes containing cholesterol, approximately 40% of the nitroxides in the region adjacent to the lipid headgroups are H bonded to water, of which ca. 15% are doubly H bonded. Corresponding H-bonded populations in membranes without cholesterol are ca. 20%, of which ca. 6% are doubly bonded.     

Chemical preparation of conductive elastomeric blends: Polypyrrole/EPDM. I. Oxidant particle-size effect

This work describes the preparation of polypyrrole and EPDM rubber blends, PPy/EPDM, by the sorption of pyrrole (vapor phase) in an EPDM matrix containing CuCl₂. We investigated the effect of the oxidant particle-size on the sorption and polymerization equilibrium, electrical conductivity, and mechanical properties of the blends. Independently of the CuCl₂ concentration and polymerization time, the polypyrrole weight fraction in the blend, X_ppy, increases when the oxidant particle-size in changed from 150–250 μm to smaller than 106 μm. For blends containing 50 phr of CuCl₂, obtained following 72 h of exposure to pyrrole, an increase in the Young's Modulus (from 2.2 ± 0.2 to 3.9 ± 0.6 MPa) and an increase in the electrical conductivity (from 10^?9 to 10^?7 S cm^?1) was observed when the oxidant particle-size was decreased. Infrared spectroscopy, thermogravimetric analysis, scanning differential calorimetry, and scanning electron microscopy were used in sample characterization. © 1994 John Wiley & Sons, Inc.