Effect of the Solvent Flow Rate on the Ionization Efficiency in Atmospheric Pressure Photoionization-Mass Spectrometry

In the novel atmospheric pressure photoionization-mass spectrometry the ionization efficiency has been observed to decrease when the solvent flow rate is increased. The effect of the flow rate on the ionization efficiency was studied by comparing the behavior of two analytes, one of which is ionized through charge exchange, the other through proton transfer. Additional information about the ion loss mechanisms was obtained by comparing results obtained with two different APPI ion sources: a Sciex prototype and the Agilent/Syagen APPI source. In addition to the measurements done by using the mass analyzer, the total ion current in the ion source was obtained by measuring the currents of the ions arriving at curtain/end plate and orifice/capillary of the two mass spectrometers. The total ion current measurements showed a significant decrease at high solvent flow rates. Loss of dopant radical cations was thought to be the reason for the signal decrease of the analytes formed through charge exchange. Analytes formed through proton transfer were not as seriously ected by the high solvent flow rates, but some saturation of their signal was nevertheless observed. Loss of photons through absorption by solvent vapor is another mechanism that can be held responsible for a reduction of the total number of ions produced by the APPI source.     

Ruthenium-Assisted Tellurium Abstraction in Bis(thiophen-2-yl) Ditelluride

The reaction of [RuCl₂(CO)₃]₂ and Te₂Tpn₂ (Tpn=thiophen-2-yl, C₄H₃S) in the absence of light resulted in the formation of cct-[RuCl₂(CO)₂(TeTpn₂)₂] ( 1 ) [cis(Cl)-cis(CO)-trans(TeTpn₂)] and TeTpn₂ ( 2 ) together with the precipitation of tellurium. The complex 1 and the monotelluride 2 were characterized by NMR spectroscopy and single-crystal X-ray diffraction. The decomposition of Te₂Tpn₂ to TeTpn₂ has been monitored by ¹²⁵Te NMR spectroscopy and seemed to be faster than the ligand substitution in [RuCl₂(CO)₃]₂ by TeTpn₂. A catalytic cycle is proposed for the decomposition of Te₂Tpn₂ to TeTpn₂ based on the PBE0-D3/def2-TZVP calculations.     

Optical coherence tomography as a method of quality inspection for printed electronics products

Application of time domain, ultra high resolution optical coherence tomography (UHR-OCT) in printed electronics products’ quality inspection is demonstrated. Presented study was done using experimental UHR-OCT device based on a Kerr-lens mode locked Ti:sapphire femtosecond laser, photonic crystal fibre and modified, free-space Michelson interferometer. Possibilities of the technique are demonstrated by analysis of an RF antenna—example of printed electronics products. Measurements were done with submicron axial resolution, offered by UHR-OCT system developed in our laboratory. Such high resolution is necessary due to the thickness of material layers used in printed electronics. In addition to tomography imaging, numerical results were compared with data provided by two commercially available measurement devices: Wyko NT3300 optical profiler and Dektak 8 stylus profiler (both Veeco). Comparison of profile heights and their spatial correlation is presented. Ability for full volumetric reconstruction and accuracy justified with reference measurements prove OCT to be a reliable tool in printed electronics product testing.     

Experimental and theoretical investigations of tellurium(IV) diimides and imidotelluroxanes: X-ray structures of B(C6F5)3 adducts of OTe(mu-NtBu)2TeNtBu, [OTe(mu-NtBu)2Te(mu-O)]2 and tBuNH2

The hydrolysis of (t)BuNTe(mu-N(t)Bu)(2)TeN(t)Bu (1) with 1 or 2 equiv of (C(6)F(5))(3)B.H(2)O results in the successive replacement of terminal imido groups by oxo ligands to give the telluroxane-Lewis acid adducts (C(6)F(5))(3)B.OTe(mu-N(t)Bu)(2)TeN(t)Bu (2) and [(C(6)F(5))(3)B.OTe(mu-N(t)Bu)(2)Te(mu-O)](2) (3), which were characterized by multinuclear NMR spectroscopy and X-ray crystallography. The Te=O distance in 2 is 1.870(2) A. The di-adduct 3 involves the association of four (t)()BuNTeO monomers to give a tetramer in which both terminal Te=O groups [d(TeO) = 1.866(3) A] are coordinated to B(C(6)F(5))(3). The central Te(2)O(2) ring in 3 is distinctly unsymmetrical [d(TeO) = 1.912(3) and 2.088(2) A]. The X-ray structure of (C(6)F(5))(3)B.NH(2)(t)()Bu (4), the byproduct of these hydrolysis reactions, is also reported. The geometries and energies of tellurium(IV) diimides and imido telluroxanes were determined using quantum chemical calculations. The calculated energies for the reactions E(NR)(2) + Te(NR)(2) (E = S, Se, Te; R = H, Me, (t)Bu, SiMe(3)) confirm that cyclodimerization of tellurium(IV) diimides is strongly exothermic. In the mixed-chalcogen systems, the cycloaddition is energetically favorable for the Se/Te combination. The calculated energies for the further oligomerization of the dimers XE(mu-NMe)(2)EX (E = Se, Te; X = NMe, O) indicate that the formation of tetramers is strongly exothermic for the tellurium systems but endothermic (X = NMe) or thermoneutral (X = O) for the selenium systems, consistent with experimental observations.     

Fabrication of enclosed SU-8 tips for electrospray ionization-mass spectrometry

We describe a novel electrospray tip design for MS which is fabricated completely out of SU-8 photoepoxy. A three-layer SU-8 fabrication process provides fully enclosed channels and tips. The tip shape and alignment of all SU-8 layers is done lithographically and is therefore very accurate. Fabrication process enables easy integration of additional fluidic functions on the same chip. Separation channels can be made with exactly the same process. Fluidic inlets are made in SU-8 during the fabrication process and no drilling or other postprocessing is needed. Channels have been fabricated and tested in the size range of 10 microm x 10 microm-50 microm x 200 microm. Mass spectrometric performance of the tips has been demonstrated with both pressure-driven flow and EOF. SU-8 microtips have been shown to produce stable electrospray with EOF in a timescale of tens of minutes. With pressure driven flow stable spray is maintained for hours. Taylor cone was shown to be small in volume and well defined even with the largest channel cross section. The spray was also shown to be well directed with our tip design.     

High-performance liquid chromatographic determination of oligomeric procyanidins from dimers up to the hexamer in hawthorn

An HPLC method using UV diode array detection was developed for analysing procyanidins qualitatively and quantitatively up to the hexameric level in hawthorn samples. The analysed compounds included procyanidin dimers B-2, B-4 and B-5, procyanidin trimers C-1, epicatechin-(4beta-->8)-epicatechin-(4beta-->6)-epicatechin and epicatechin-(4beta-->6)-epicatechin-(4beta-->8)-epicatechin, a tetramer D-1 and a pentamer E-1 both consisting of (-)-epicatechin units linked through C-4beta/C-8 bonds. The concentrations of two unknown tetramers and a hexamer F were also quantified. The oligomeric procyanidins (OPs) were specifically determined due to the development of a method for isolating them from hawthorn during sample preparation. The pattern of oligomeric procyanidins in the leaves, flowers and fruits was similar, but the concentrations varied depending on the part of the plant. The concentration in leaves was 1.6%, in flowers 1.2% and in fruits 0.2% of the dry mass. The method was validated with respect to repeatability, recovery, linearity, and sensitivity. The repeatability for the quantitative analytical method of all the OPs in leaves was 7.7%, in flowers 8.8%, and in fruits 12.3%. The recovery of the main OPs ranged from 91 to 97%. The correlation coefficients of calibration curves were between 0.997 and 1.000. The limits of quantitation for different procyanidin standards were 0.05-0.12 mg/ml, when 10 microl of each standard solution was injected into the HPLC.     

Experimental and theoretical investigations of structural trends for selenium(IV) imides and oxides: X-ray structure of Se3(NAd)2

The thermal decomposition of Se(NAd)(2) (Ad = 1-adamantyl) in THF was monitored by (77)Se NMR and shown to give the novel cyclic selenium imide Se(3)(NAd)(2) as one of the products. An X-ray structural determination showed that Se(3)(NAd)(2) is a puckered five-membered ring with d(Se-Se) = 2.404(1) A and |d(Se-N)| = 1.873(4) A. On the basis of (77)Se NMR data, other decomposition products include the six-membered ring Se(3)(NAd)(3), and the four-membered rings AdNSe(micro-NAd)(2)SeO and OSe(micro-NAd)(2)SeO. The energies for the cyclodimerization of E(NR)(2) and RNEO (E = S, Se; R = H, Me, (t)Bu, SiMe(3)), and the cycloaddition reactions of RNSeO with E(NR)(2), RNSO(2) with Se(NR)(2), and S(NR)(2) with Se(NR)(2) have been calculated at MP2, CCSD, and CCSD(T) levels of theory using the cc-pVDZ basis sets and B3PW91/6-31G* optimized geometries. Sulfur(IV) and selenium(IV) diimide monomers are predicted to be stable, the sole exception being Se(NSiMe(3))(2) that shows a tendency toward cyclodimerization. The cyclodimerization energy for RNSeO and the cycloaddition reaction energies of RNSeO with Se(NR)(2) as well as that of RNSO(2) with Se(NR)(2) are negative, consistent with the observed formation of OSe(micro-N(t)Bu)(2)SeO, OSe(micro-N(t)Bu)(2)SeN(t)Bu, and O(2)S(micro-N(t)Bu)(2)SeN(t)Bu, respectively. Cycloaddition is unlikely when one of the reactants is a sulfur(IV) diimide.     

Feasibility of gas chromatography-microchip atmospheric pressure photoionization-mass spectrometry in analysis of anabolic steroids

Mass spectrometers equipped with atmospheric pressure ion sources (API-MS) have been designed to be interfaced with liquid chromatographs (LC) and have rarely been connected to gas chromatographs (GC). Recently, we introduced a heated nebulizer microchip and showed its potential to interface liquid microseparation techniques and GC with API-MS. This study demonstrates the feasibility of GC-microchip atmospheric pressure photoionization-tandem mass spectrometry (GC-μAPPI-MS/MS) in the analysis of underivatized anabolic steroids in urine. The APPI microchip provides high ionization efficiency and produces abundant protonated molecules or molecular ions with minimal fragmentation. The feasibility of GC-μAPPI-MS/MS in the analysis of six selected anabolic steroids in urine samples was studied with respect to intra-batch repeatability, linearity, linear range, and limit of detection (LOD). The method showed good sensitivity (LODs 0.2-1 ng/mL), repeatability (relative standard deviation<10%), and linearity (regression coefficient≥0.9995) and, therefore, high potential for the analysis of anabolic steroids. Quantitative performance of the method was tested with two authentic urine samples, and the results were in good agreement with those obtained with conventional GC-electron ionization-MS after derivatization.     

High-performance anion-exchange chromatography–mass spectrometry method for determination of levoglucosan, mannosan, and galactosan in atmospheric fine particulate matter

Biomass burning has a strong influence on the atmospheric aerosol composition through particulate organic, inorganic, and soot emissions. When biomass burns, cellulose and hemicelluloses degrade, producing monosaccharide anhydrides (MAs) such as levoglucosan, mannosan, and galactosan. Therefore, these compounds have been commonly used as tracers for biomass burning. In this study, a fast water-based method was developed for the routine analysis of MAs, based on high-performance anion-exchange chromatography with electrospray ionization mass spectrometry detection. This method combines simple sample preparation, fast separation, and the advantages of the selective detection with MS. Analysis run was optimized to the maximum separation of levoglucosan, mannosan, and galactosan with 15-min analysis. The validation results indicated that the method showed good applicability for determination of MA isomer concentrations in ambient samples. The limit of detection was 100 pg for levoglucosan and 50 pg for mannosan and galactosan. Wide determination ranges enabled the analysis of samples of different concentration levels. The method showed good precision, both for standard solutions (3.9–5.9% RSD) and for fine particle samples (4.3–8.5% RSD). Co-elution of internal standard (carbon-13-labeled levoglucosan) and sugar alcohols with levoglucosan decreased the sensitivity of levoglucosan determination. The method was used to determine the MA concentrations in ambient fine particle samples from urban background (Helsinki) and rural background (Hyytiälä) in Finland. The average levoglucosan, mannosan, and galactosan concentrations were 77, 8.8, and 4.2 ng?m^?3 in Helsinki (winter 2008–2009) and 17, 2.3, and 1.4 ng?m^?3 in Hyytiälä (spring 2007), respectively. The interrelation of the three MA isomers was fairly constant in the ambient fine particle samples.