Transparent conducting oxides: texture and microstructure effects on charge carrier mobility in MOCVD-derived CdO thin films grown with a thermally stable, low-melting precursor

A series of low-melting, thermally stable cadmium metal-organic chemical vapor deposition (MOCVD) precursors have been synthesized, structurally and spectroscopically characterized, and implemented in growth of highly conductive and transparent CdO thin films. One member of the series, bis(1,1,1,5,5,5-hexafluoro-2,4-pentanedionato)(N,N-diethyl-N',N'-dimethyl-ethylenediamine)cadmium(II), Cd(hfa)(2)()(N,N-DE-N',N'-DMEDA), represents a particularly significant improvement over previously available Cd precursors, owing to the low melting point and robust thermal stability. High-quality CdO films were grown by MOCVD on glass and single-crystal MgO(100) between 300 and 412 degrees C. Film growth parameters and substrate surface have large effects on microstructure and electron carrier transport properties. Enhanced mobilities observed for highly biaxially textured films grown on MgO(100) vs glass are attributed, on the basis of DC charge transport and microstructure analysis, to a reduction in neutral impurity scattering and/or to a more densely packed grain microstructure. Although single-grained films grown on MgO(100) exhibit greater mobilities than analogues with discrete approximately 100 nm grains and similar texture, this effect is attributed, on the basis of charge transport and Hall effect measurements as well as optical reflectivity analysis, to differences in carrier concentration rather than to reduced grain boundary scattering. Unprecedented conductivities and mobilities as high as 11,000 S/cm and 307 cm(2)/V.s, respectively, are obtained for epitaxial single-grained films (X-ray diffraction parameters: fwhm(omega) = 0.30 degrees, fwhm(phi) = 0.27 degrees ) grown in situ on MgO(100) at a relatively low temperature (400 degrees C).     

Application of low-pressure gas chromatography-ion-trap mass spectrometry to the analysis of the essential oil of Turnera diffusa (Ward.) Urb

Turnera diffusa Willd. var. afrodisiaca (Ward) Urb. (syn. T. aphrodisiaca) belongs to the family of Turneraceae and is an aromatic plant growing wild in the subtropical regions of America and Africa. It is widely used in the traditional medicine as e.g. anti-cough, diuretic, and aphrodisiac agent. This work presents a 3 min chromatographic analysis using low-pressure (LP) gas chromatography (GC)-ion-trap (IT) mass spectrometry (MS). The combination of a deactivated 0.6 m x 0.10 mm i.d., restrictor with a wide-bore CP-Wax 52 capillary column (10 m x 0.53 mm i.d., 1 microm) reduces the analysis time by a factor of 3-7 in comparison to the use of a conventional narrow bore column. Chromatographic conditions have been optimized to achieve the fastest separation with the highest signal/noise ratio in MS detection. These results allow fast and reliable quality control of the essential oil to be achieved.     

Chromatographic and column stability at pH 7 of a C18 dimethylurea polar stationary phase

Chromatographic evaluations of a C18 dimethylurea phase in 150 mm x 3.9 mm HPLC columns were performed using the Tanaka and Engelhardt test mixtures. The applicability of the new C18 dimethylurea phase was also evaluated with a mixture of some herbicides and their metabolites. An artificial aging procedure was also performed by passing a potassium phosphate mobile phase buffered at pH 7.0 through C18 50 mm x 3.9 mm dimethylurea columns. The column stability was evaluated by means of the chromatographic parameters obtained for the separation of some compounds from the Neue test mixture, using apolar, polar and highly basic analytes.     

Production of antitumoral retamycin during fed-batch fermentations of Streptomyces olindensis

Fed-batch runs were performed in order to correlate the production of retamycin, an anthracycline antibiotic produced by Streptomyces olindensis in submerged cultures, with the specific growth rate. Maximum retamycin production was achieved with an exponential feed rate, controlling the specific growth rate at a low value (0.03 h-1, about 10% of the maximum specific growth rate). Control of the specific growth rate at higher values (0.10 and 0.17 h-1) caused a decrease in antibiotic production. Morphology, assessed by image analysis, was shown to be highly relevant in this process. Cell growth mainly in the form of clumps (90% clumps and 10% free filaments) led to better results than growth as clumps (75%) and free filaments (25%).     

Electrical conductivity of poly(vinylidene fluoride)/polyaniline blends under oscillatory and steady shear conditions

Blends of poly(vinylidene fluoride) (PVDF) and polyaniline (PAni) were prepared through melt blending in a batch mixer. The morphology, rheological behavior and electrical conductivity were investigated through transmission electron microscopy (TEM) and combined electro-rheological measurements. Through TEM analysis, it was possible to observe that all blends showed typical phase separation with the presence of conductive polymer aggregates. Deformations imposed during a strain sweep caused, not only disturbance of the linear viscoelastic behavior, but also changes in electrical conductivity. The oscillatory shear altered the morphology, breaking the PAni domains into smaller ones. This effect increases the distance between them and, consequently, resulted in a decrease of the electrical conductivity. The measurements under quiescent conditions and steady shear proved that the disturbance in morphology for PVDF/PAni system is non-recoverable. Through combined electrical and rheological measurements, it was possible to achieve good correlation between the electrical and flow behavior of PVDF/PAni blends.     

Simultaneous quantification of morphine and cocaine in hair samples from drug addicts by GC-EI/MS

The development of analytical techniques that enable the use of hair as an alternative matrix for the analysis of drugs of abuse is useful for confirming the exposure in a larger time window (weeks to months, depending on the length of the hair shaft). In the present study a methodology aimed at the simultaneous quantification of cocaine and morphine in human hair was developed and validated. After decontamination, hair samples (20?mg) were incubated with a mixture of methanol/hydrochloric acid (2:1) at 65?°C overnight (~16?h) in order to extract the drugs of the matrix. Purification was performed by solid-phase extraction using mixed-mode extraction cartridges. After derivatization with N-methyl-N-(trimethylsilyl) trifluoroacetamide, blank, standards and samples were analyzed by gas chromatography/electron impact-mass spectrometry (GC-EI/MS). The method proved to be selective, as there were no interferences of endogenous compounds with the same retention time as cocaine, morphine and ethylmorphine (internal standard). The regression analysis for both analytes showed linearity in the range 0.25-10.00?ng/mg with correlation coefficients ranging from 0.9989 to 0.9991. The coefficients of variation oscillated between 0.83 and 14.60%. The limits of detection were 0.01 and 0.02?ng/mg, and the limits of quantification were 0.03 and 0.06?ng/mg for cocaine and morphine, respectively. The proposed GC-EI/MS method provided an accurate and simple assay with adequate precision and recovery for the quantification of cocaine and morphine in hair samples. The proof of applicability was performed in hair samples obtained from drug addicts enrolled in a Regional Detoxification Treatment Center. The importance of hair samples is highlighted, since positives results were obtained when urine immunoassay analyses were negative. Copyright ? 2012 John Wiley & Sons, Ltd.     

Growth kinetic on the optical properties of the Pb(1-x)Mn(x)Se nanocrystals embedded in a glass matrix: thermal annealing and Mn2+ concentration

Semimagnetic Pb(1-x)Mn(x)Se nanocrystals were synthesized by a fusion method in a glass matrix and characterized by optical absorption (OA), atomic/magnetic force microscopy (AFM/MFM), and photoluminescence techniques. MFM images strongly indicated the formation of Pb(1-x)Mn(x)Se magnetic phases in the glass system. Quantum dot size was manipulated by tuning annealing time. It was shown that Mn(2+) impurity affects nucleation, where Mn(2+)-doped samples present a redshift of the OA peak after a short annealing time and a blueshift after long annealing time compared to undoped PbSe NCs. This behavior was linked to the dependence of band-gap energy and the absorption selection rule on Mn(2+) concentration. Photoluminescence in the Pb(1-x)Mn(x)Se nanocrystals increases as the temperature rises up to a point and then decreases at higher temperatures. Anomalous increases in emission efficiency were analyzed by considering temperature induced carrier-transfer in semimagnetic Pb(1-x)Mn(x)Se quantum dots nanocrystals of different sizes.     

Theoretical study of the conformational energy hypersurface of cyclotrisarcosyl

The multidimensional Conformational Potential Energy Hypersurface (PEHS) of cyclotrisarcosyl was comprehensively investigated at the DFT (B3LYP/6-31G(d), B3LYP/6-31G(d,p) and B3LYP/6-311++G(d,p)), levels of theory. The equilibrium structures, their relative stability, and the Transition State (TS) structures involved in the conformational interconversion pathways were analyzed. Aug-cc-pVTZ//B3LYP/6-311++G(d,p) and MP2/6-31G(d)//B3LYP/6-311++G(d,p) single point calculations predict a symmetric cis-cis-cis crown conformation as the energetically preferred form for this compound, which is in agreement with the experimental data. The conformational interconversion between the global minimum and the twist form requires 20.88 kcal mol-1 at the MP2/6-31G(d)//B3LYP/6-311++G(d,p) level of theory. Our results allow us to form a concise idea about the internal intricacies of the PEHSs of this cyclic tripeptide, describing the conformations as well as the conformational interconversion processes in this hypersurface. In addition, a comparative analysis between the conformational behaviors of cyclotrisarcosyl with that previously reported for cyclotriglycine was carried out     

Structural characterization and dielectric properties of the solid solutions AgPb(Sb,Bi)S3

The new solid solutions AgPbSb_1 − x Bi _x S₃ were prepared by solid state reactions. The phases were characterized by powder X-ray diffractions (XRD), scanning electron microscopy, and thermal analysis. The XRD patterns of different members (x = 0.5, 0.7, 0.8, and 1.0) are consistent with pure phases crystallizing in the cubic PbS-type structure. The electrical characterization was carried out using ac impedance spectroscopy and dc methods. The temperature dependence of the dc conductivity shows typical semiconductor Arrhenius behavior. The impedance measurements were performed in the frequency range of 0.1 Hz to 10 MHz and at the temperature range of 15 °C to 350 °C. The ac conductivity conforms to Jonscher’s universal power law. The frequency dependence of the dielectric permittivity follows the normal dielectric material behavior, and the relaxation is thermally activated. The frequency and temperature dependences of the electrical data are found to follow Summerfield scaling formalism.     

Development of metrological models for internal standard single-point and multi-point calibrations for the assessment of tear gas weapons compliance with legislation

Tear gases are the most widely used non-lethal weapons, both by security forces and by the general public. The pepper spray, whose active agent is capsaicin, is the only self-defence aerosol allowed in Portugal, where capsaicin concentration must be below 5 g/100 mL. The cost-effective evaluation of the compliance of self-defence weapons with legislation involves the use of two measurement procedures with increasing quantitative capability. Samples are first assessed by preliminary measurement procedure based on single-point GC–MS calibration. Whenever the measurement uncertainty from this assessment makes evaluation inconclusive, the evaluation of sample compliance using multi-point GC–MS calibration is performed. Metrological models including sound criteria for the evaluation of sample compliance with legislation were developed for both measurement procedures. Such models include the evaluation of the impact of instrumental performance, calibration model, sample dilution and standards preparation on measurement uncertainty. The relative expanded uncertainty, in the studied range (capsaicin 3–7 g/100 mL), of measurements supported in single-point calibrations ranged from 10 to 22% and the ones supported on multi-point calibrations from 8 to 12% depending on capsaicin concentration and daily GC–MS repeatability. Measurements are fit for the intended use since they present a relative expanded uncertainty smaller than a target value of 30, or 15%, for measurements supported in single- or multi-point calibrations, respectively.