Transparent conducting oxides: texture and microstructure effects on charge carrier mobility in MOCVD-derived CdO thin films grown with a thermally stable, low-melting precursor

A series of low-melting, thermally stable cadmium metal-organic chemical vapor deposition (MOCVD) precursors have been synthesized, structurally and spectroscopically characterized, and implemented in growth of highly conductive and transparent CdO thin films. One member of the series, bis(1,1,1,5,5,5-hexafluoro-2,4-pentanedionato)(N,N-diethyl-N',N'-dimethyl-ethylenediamine)cadmium(II), Cd(hfa)(2)()(N,N-DE-N',N'-DMEDA), represents a particularly significant improvement over previously available Cd precursors, owing to the low melting point and robust thermal stability. High-quality CdO films were grown by MOCVD on glass and single-crystal MgO(100) between 300 and 412 degrees C. Film growth parameters and substrate surface have large effects on microstructure and electron carrier transport properties. Enhanced mobilities observed for highly biaxially textured films grown on MgO(100) vs glass are attributed, on the basis of DC charge transport and microstructure analysis, to a reduction in neutral impurity scattering and/or to a more densely packed grain microstructure. Although single-grained films grown on MgO(100) exhibit greater mobilities than analogues with discrete approximately 100 nm grains and similar texture, this effect is attributed, on the basis of charge transport and Hall effect measurements as well as optical reflectivity analysis, to differences in carrier concentration rather than to reduced grain boundary scattering. Unprecedented conductivities and mobilities as high as 11,000 S/cm and 307 cm(2)/V.s, respectively, are obtained for epitaxial single-grained films (X-ray diffraction parameters: fwhm(omega) = 0.30 degrees, fwhm(phi) = 0.27 degrees ) grown in situ on MgO(100) at a relatively low temperature (400 degrees C).     

Flow-injection spectrofluorimetric determination of ethylenethiourea

A flow-injection configuration is proposed for the fluorimetric determination of ethylenethiourea. The procedure is based on the inhibitory effect of ethylenethiourea on the oxidation of thiamine to thiochrome by mercury(II). A linear calibration graph was obtained between 0.1 and 2.0 μg mL^–1, with a sampling rate of 40 samples per hour and a relative standard deviation of about 1.11%. The usefulness of the method was tested for the determination of ethylenethiourea residues in water, milk, potatoes, pear, grape and apple. Received: 26 January 1998 / Revised: 6 April 1998 / Accepted: 9 April 1998     

Application to routine analysis of a method to determine multiclass pesticide residues in fresh vegetables by gas chromatography/tandem mass spectrometry

The use of gas chromatography/tandem mass spectrometry (GC/MS/MS) applied to determine multiple pesticide residues in fresh vegetables has been thoroughly studied. A single injection method to detect, confirm and quantify 54 multiclass pesticides has been developed and applied in a routine analysis laboratory. The proposed method consists of a rapid extraction of 15 g of vegetable sample with dichloromethane. An additional clean-up step is not necessary even when injecting 10 microL of extract. Instead the gas chromatograph was fitted with a carbofrit inserted into the glass liner and a guard column. In addition, the detection mode chosen (MS/MS) provides additional selectivity. The method has been validated and applied to 1300 samples in a routine laboratory following specified quality criteria. The recovery efficiencies obtained for all the pesticides ranged between 70.2 and 110.8% at two different fortification levels. The relative standard deviation for quantification (RSD) was lower than 16.7% for all the compounds. Important experimental parameters, such as the conditioning of carbofrit, overload of the analytical column, and cleanliness of the ion trap, were evaluated for their influence on the performance of the method.     

Selection of thermotolerant yeasts for simultaneous saccharification and fermentation (SSF) of cellulose to ethanol

A total of 27 yeast strains belonging to the groupsCandida, Saccharomyces, andKluyveromyces were screened for their ability to grow and ferment glucose at temperatures ranging 32-45°C. K. marxianus andK. fragilis were found to be the best ethanol producing organisms at the higher temperature tested and, so, were selected for subsequent simultaneous saccharification and fermentation (SSF) studies.     

Reaction of methyl 4-nitrobenzenesulfonate with Br- in water-formamide tetradecyltrimethylammonium bromide micellar solutions

Summary The reaction methyl 4-nitrobenzenesulfonate + Br^- was studied in water-formamide tetradecyltrimethylammonium bromide micellar solutions. A pseudophase kinetic model was used to quantitatively rationalize the kinetic micellar effects observed     

A new method for obtaining adsorption isotherms on colloidal suspensions via electrokinetic sonic amplitude measurement

The standard methods for obtaining adsorption isotherms on colloidal suspensions are usually very time consuming and involve a large number of steps and assumptions that increase the experimental errors. In this work, an alternative method is proposed to evaluate the adsorption behavior of electrosteric-stabilized systems based on electrokinetic sonic amplitude signal measurements. The new method, entitled "zeta-sorption", is noticeably less time-consuming when compared to conventional procedures but showed great precision and reliability confirmed by comparison with data obtained from conventional routes on alumina-polyacrylate and alumina-citric acid aqueous suspensions. The experimental conditions that restrict the applicability of the new method were identified and justified by discussing the possible ion exchanges.     

UV index experimental values during the years 2000 and 2001 from the Spanish broadband UV-B radiometric network

An analysis is made of experimental ultraviolet erythemal solar radiation data measured during the years 2000 and 2001 by the Spanish UV-B radiation evaluation and prediction network. This network consists of 16 Robertson-Berger type pyranometers for evaluating solar erythemal radiation and five Brewer spectroradiometers for evaluating the stratospheric ozone. On the basis of these data the Ultraviolet Index (UVI) was evaluated for the measuring stations that are located either in coastal regions or in the more densely populated regions inland on the Iberian Peninsula. It has been checked that in most cases the maximum irradiance values corresponded to solar noon, although there were exceptions that could be explained by cloudiness. The maximum experimental values of the UVI were around 9 during the summer, though frequently passing this value at the inland measurement stations. The annual accumulated dose of irradiation on a horizontal plane has also been studied, as well as the evolution through the year in units of energy, standard erythemal doses and minimum erythemal doses, according to different phototypes.     

Synthesis and characterization of oligosalicylaldehyde-based epoxy resins

The synthesis of a new epoxy resin of oligosalicylaldehyde by the reaction with epichlorohydrin is reported. New resin’s epoxy value and chlorine content were determined and found to be 25% and 1%, respectively. The characterization of the new resin was instrumented by FTIR, ¹H NMR, scanning electron microscopy, and thermal gravimetric analyses. TGA results showed that the cured epoxy resin has a good resistance to thermal decomposition. The mass losses of cured epoxy resin were found to be 5%, 10%, 50% at 175°C, 240°C, and 400°C, respectively. On the curing procedure the resin was cured with polyethylenepolyamine at 25 °C for 8 h and 100°C for 1.5 h. The FTIR spectrum of new epoxy resin gave the peak of oxirane ring at ṽ = 918 cm⁻¹. In memory of Professor Dr. Adalet R. Vilayetoğlu     

An ultrasensitive method for the determination of thiouracil and phenylthiouracil using capillary zone electrophoresis and laser-induced fluorescence detection

This paper reports the development of a method based on capillary electrophoresis with laser-induced fluorescence detection for the simultaneous determination of thiouracil (TU) and phenylthiouracil (PhTU) with high sensitivity (nanomolar range, i.e., attomoles detected). After derivatization with 5-iodoacetamidofluorescein, the analytes were separated by capillary zone electrophoresis using 20 mM phosphate buffer (pH 10.0) and quantified by fluorescence detection. The linearity range, precision, recovery, and detection limits were determined, and the method was shown to be applicable for the determination of TU and PhTU in spiked feed samples and urine.