Fast Liquid Phase Epitaxial Growth for Perovskite Single Crystals

Semiconductors grown by the solution-processed method have shown low-cost,facile fabrication process and comparable performance.However,there are many reasons why it is difficult to achieve high quality films.For example,lattice constant mismatch is one of the problems when photovoltaic devices made of organ metallic perovskites.In this work,MAPbBr^{MA=CH3NH3^+}perovskites single crystals grown on the surface of MAPbBr2.5 CI0.5 perovskites single crystals via liquid epitaxial growth method is demonstrated.It is found that when the lattice constants of the two perovskite single crystals are matched,another crystal can be grown on the surface of one crystal by epitaxial growth.The whole epitaxy growth process does not require high heating temperature and long heating time.X-ray diffraction method is used to prove the lattice plane of the substrate and the epitaxial grown layer.A scanning electron microscope is used to measure the thickness of the epitaxial layer.Compared with perovskite-based photodetectors without epitaxial growth layer,perovskite-based photodetectors with epitaxial growth layer have lower dark current density and higher optical responsibility.     

一种双模压缩微波制备的相位锁定方案

相位锁定是双模压缩微波制备的关键问题之一.针对基于超导180°混合环的制备方案相位稳定度不高且信息处理复杂等问题,提出一种相位锁定方案.对约瑟夫森参量放大器的信号输入进行相位调制,输出的单模压缩微波与另一未调制的同频单模压缩微波在超导180°混合环内干涉,实现双模压缩微波的制备与路径分离.将未调制的单模压缩微波与一路双模压缩微波混频,解调出相位调制信号可得到两路单模压缩微波的相对相位及误差,将相位误差反馈于约瑟夫森参量放大器的抽运实现相对相位的锁定,获得稳定的双模压缩输出.本研究对高性能纠缠微波源的设计提供了理论参考.     

基于等效介质原理的宽角超材料吸波体的理论分析

目前,很少有文章就如何实现宽角度吸波材料进行详细的理论分析和设计指导,设计宽角度吸波材料仍然是一件很困难的事情.本文基于等效介质理论对带有反射地板的单层介质超材料吸波体进行较为详细的理论分析.从基础电磁理论出发,推导TE波(横电波,电场方向与入射面垂直的平面电磁波)和TM波(横磁波,磁场方向与入射面垂直的平面电磁波)照射下吸波体的反射系数,分析实现宽角度吸波效果所需的等效电磁参数,为宽角度超材料吸波体的设计提供了理论基础.此外,论文还理论分析了实现宽带宽角吸波等效电磁参数所要满足的条件,并做了计算检验.结果表明,当介质等效电磁参数按照特殊曲线随频率发生变化时,理论上能实现宽带宽角的吸波效果.     

基于非线性光纤环形镜的少模脉冲幅度调制再生器

随着网络带宽需求的快速增加,波分复用系统的容量已接近非线性香农极限.为了适应未来网络的发展,空分复用技术引起了越来越多的关注.本文首次提出基于少模非线性光纤环形镜(FM-NOLM)的脉冲幅度调制(PAM)全光再生器,描述了其工作原理和具体设计过程.采用COMSOL软件对组成FM-NOLM的硫化物高非线性光纤进行了模式特性仿真.以LP01,LP11,LP21三个光纤模式为例,确定了再生器的参数,计算出每个模式的功率转移函数曲线.仿真分析了该少模PAM-4全光再生器的噪声抑制(NRR)性能,并与单模情形进行了比较.研究表明,1)对于每个空间模式的PAM信号,所有再生电平具有一致的功率转移性能;2)当输入信噪比(SNR)约大于20 dB时,三种模式的噪声抑制比均可超过3 dB,并随着输入信噪比线性增加,其斜率约为1.2;3)在相同输入SNR条件下,三种模式的噪声抑制比相差不大,不超过1.1 dB.为了说明再生器的再生性能,当输入SNR为25 dB时,我们还给出了再生前后PAM-4信号的功率分布直方图.与现有的再生方案相比,本文方案的均匀多电平再生转移性能,使其更适合高频谱效率的长距空分复用系统和任意电平数的PAM信号再生.此外,该方案也能够扩展到波长域,有效提高光通信系统的传输容量.     

微波瑞利散射法测定空气电火花激波等离子体射流的时变电子密度

大气压空气电火花激波等离子体射流的电子密度在亚微秒时间尺度上瞬变,其电子密度的测定很难.基于微波瑞利散射原理,本文测量了空气电火花冲击波流注放电等离子体射流的时变电子密度.实验结果表明:测量系统的标定参数A为1.04 × 105 V·Ω·m–2;空气流注放电等离子体射流的电子密度与等离子体射流的半径和长度有关,结合高速放电影像展示的等离子体射流的等效半径和等效长度,测定的电子密度在1020 m–3的量级,且随时间先快速增长至峰值再成指数衰减.此外,本文还探讨了等离子体射流的不同等效尺度对测定结果的影响;分析结果表明,采用时变等效半径和时变等效长度的计算结果最有效,且第1个快速波峰是由光电离的电离波导致的.     

Fission fragment mass yields of Th to Rf even-even nuclei

Fission properties of the actinide nuclei are deduced from theoretical analysis. We investigate potential energy surfaces and fission barriers and predict the fission fragment mass yields of actinide isotopes. The results are compared with experimental data where available. The calculations were performed in the macroscopic-microscopic approximation with the Lublin-Strasbourg Drop (LSD) for the macroscopic part, and the microscopic energy corrections were evaluated in the Yukawa-folded potential. The Fourier nuclear shape parametrization is used to describe the nuclear shape, including the non-axial degree of freedom. The fission fragment mass yields of the nuclei considered are evaluated within a 3D collective model using the Born-Oppenheimer approximation.     

介观电路中量子纠缠的经典对应

从量子力学诞生日起,它的经典对应(或类比)一直是物理学家关心的话题.本文以介观电路量子化的框架中,带有互感的两个介观电容-电感(LC)电路为例,首次讨论了量子纠缠的经典类比(或对应)问题.先用有序算符内的积分理论证明其互感是产生量子纠缠的源头;再推导出求解特征频率的公式,就发现它与一个经典系统的小振动频率的表达式有相似之处,该经典系统组成如下:两个墙壁各连一个相同的弹簧,两个弹簧之间接着一个滑动小车可以在光滑的桌面上运动,小车挂有一根单摆.用分析力学求此系统的小振动频率,发现与上述介观电路的特征频率形式类似,单摆的摆动会造成小车来回振动,摆、小车和弹簧的互相牵制效应反映了小车和摆的纠缠.     

中子诱发232Th裂变初始碎片质量及动能分布Monte-Carlo研究

随着第四代反应堆以及先进核能利用系统的发展,对中子核数据提出了高精度、多核素、宽能区的新要求.目前,中国核数据评价库(CENDL库)中相关核裂变的数据较缺失,不足以满足当前核能发展的需求.因此,建立面向中子核数据需求的可靠计算方法和工具变得极为重要.本文基于Monte-Carlo方法建立了裂变碎片质量动能计算模型,研究了中低能中子诱发²³²Th(n,f)反应发射中子前裂变碎片的分布特性.对于裂变碎片质量分布,本模型计算结果与实验值最大偏差约1%,与GEF, TALYS程序计算结果 (与实验值最大偏差约2%)相比具有一定优势.对于发射中子前裂变碎片动能分布,本模型计算结果与实验数据一致.结果表明,所发展的计算模型能够较好地预测²³²Th(n,f)反应发射中子前裂变碎片数据,为中子诱发锕系核裂变反应计算提供一种新思路.     

Vacuum-gap-based lumped element Josephson parametric amplifier

We propose a lumped element Josephson parametric amplifier with vacuum-gap-based capacitor.The capacitor is made of quasi-floating aluminum pad and on-chip ground.We take a fabrication process compatible with air-bridge technology,which makes our design adaptable for future on-chip integrated quantum computing system.Further engineering the input impedance,we obtain a gain above 20 dB over 162-MHz bandwidth,along with a quasi quantum-limit noise performance.This work should facilitate the development of quantum information processing and integrated superconducting circuit design.