Energy transfer between Tm3+ and Er3+ in borate and phosphate glasses

A study of the energy transfer process between thulium and erbium is presented. From our measurements of fluorescence emissions and decay times the energy transfer efficiencies and probabilities were calculated. In this work the energy transfer which occurs between the upper levels in the UV and VIS regions of the two ions was especially studied. In the Tm-Er system, a mutual migration of energy occurs. The energy transfer from thulium to erbium is a multichannel process in which the energy is transferred from all the metastable levels of thulium to the matching energy levels of erbium. In addition, backtransfer of energy from erbium to thulium occurs by crossrelaxation of respective erbium transitions. The efficiency of energy transfer from thulium to erbium is independent of the levels between which the transfer occurs, but is dependent on the matrix. It is concluded that the energy is transferred via the phonons of the host glass.     

Elemental Analysis of Phytotherapeutic Products by Inductively Coupled Plasma–Tandem Mass Spectrometry

A procedure for the determination of As, Cd, Cr, Ni, Pb, and V in phytotherapy medicines by inductively coupled plasma–tandem mass spectrometry is reported. The use of tandem mass spectrometry with oxygen into an octopole reaction system at various gas flow rates and the combination of on-mass and mass-shift modes was evaluated. Cadmium, Cr, Ni, and Pb were determined as free atomic ions while As and V were determined as the oxides AsO⁺ and VO⁺ in the same run. Samples were prepared by microwave-assisted digestion with dilute nitric acid and hydrogen peroxide. Two plant-certified reference materials (apple leaves and tomato leaves) were used to check the accuracy. For tandem mass spectrometry with 0.5?mL min^?1 O₂, recoveries in the 85–113% were typically obtained and no statistical differences were observed at the 95% confidence level (t-test) in comparison with the certified values. Using these conditions, the limits of detection for the method were 0.01, 0.0002, 0.008, 0.008, 0.003, and 0.002?µg g^?1 for As, Cd, Cr, Ni, Pb, and V, respectively. The procedure was used for the analysis of four phytotherapic drugs and the determined concentrations were up to 0.168?µg g^?1 As, 0.03?µg g^?1 Cd, 0.82?µg g^?1 Cr, 1.18?µg g^?1 Ni, 0.52?µg g^?1 Pb, and 2.4?µg g^?1 V with average precision values of 8% as the relative standard deviation. The found concentrations were compared with limits proposed in official guidelines and, in most cases, the values were below the maximum limits allowed.     

Soil stress and compaction effects for four tractor tyres

Compaction effects and soil stresses were examined for four tractor tyres under three inflation pressures: 67, 100 and 150% of the recommended pressure. The four tyres were 18.4 R 38, 520/70 R 38, 600/65 R 38 and 650/60-38 and they carried a wheel load of 2590 kg. The 650/60-38 was a bias-ply tyre while the other three were radial tyres. Increased inflation pressure significantly increased all measured parameters: rut depth, penetration resistance and soil stress at 20 and 40 cm depth. The 18.4 R 38 caused a greater rut depth and penetration resistance than the other tyres, which did not differ significantly from each other. The soil stress was highest for the 18.4 R 38, followed by the 650/60-38. The low-profile tyres decreased compaction compared with the 18.4–38 tyre, mainly by allowing a lower inflation pressure. The use of low-profile tyres did not reduce compaction if not used at a lower inflation pressure. The bias-ply tyre caused a higher stress in the soil than the radial tyres when used with the same inflation pressure, but the compaction effects in terms of rut depth and penetration resistance were not greater for this tyre than for the radial low-profile tyres.     

Direct analysis of biodiesel microemulsions using an inductively coupled plasma mass spectrometry

An analytical procedure for direct introduction of biodiesel samples into an inductively coupled plasma mass spectrometer (ICP-MS) by using microemulsion for sample preparation was developed here. Cadmium, Co, Cu, Mn, Ni, Pb, Ti, and Zn were determined in biodiesel microemulsified samples prepared from different oleaginous sources (African palm, castor beans, palm, soybeans and an unknown oleaginous). Microemulsions were prepared using 0.25 mL Triton X-100, 0.25 mL 20% v v^− 1 HNO₃, 0.50 mL biodiesel sample and 4.0 mL n-propanol. Argon-oxygen mixture was added to the plasma as auxiliary gas for correcting matrix effects caused by the high carbon load due to biodiesel microemulsions. The oxygen gas flow rate was set in 37.5 mL min^− 1. The accuracy of the developed procedure was evaluated by applying addition-recovery experiments for biodiesel samples from different sources. Recoveries varied from 76.5 to 116.2% for all analytes but Zn in castor beans biodiesel sample (65.0 to 76.2%). Recoveries lower than 86.6% were obtained for palm biodiesel sample, probably due to matrix effects. Detection limits calculated by using oxygen in the composition of the auxiliary gas added to the plasma were higher than those calculated without using it, probably due to the highest formation of oxides. Despite oxides formation, best analytical performance was reached by using oxygen as auxiliary gas and by proper correction of transport interferences. The developed procedure based on microemulsion formation was suitable for direct introduction of biodiesel samples in ICP-MS.     

Sequential Injection Kinetic Flow Assay for Monitoring Glycerol in a Sugar Fermentation Process by <Emphasis Type="Italic">Saccharomyces cerevisiae</Emphasis>

A sequential injection system to monitor glycerol in a Saccharomyces cerevisiae fermentation process was developed. The method relies on the rate of formation of nicotinamide adenine dinucleotide in its reduced form (NADH, measured spectrophotometrically at 340 nm) from the reaction of glycerol with NAD⁺ cofactor, catalysed by the enzyme glycerol dehydrogenase present in solution. This procedure enables the determination of glycerol between 0.046 and 0.46 g/l, (corresponding to yeast fermentation samples with concentrations up to 50 g/l) with good repeatability (relative standard deviation for n = 10 lower than 2.2% for three different samples) at a sampling frequency of 25/h. The detection and quantification limits using a miniaturised spectrophotometer were 0.13 and 0.44 mM, respectively. Reagent consumption was of 0.45 μmol NAD⁺ and 1.8 μg enzyme per assay, and the waste production was 2.8 ml per determination. Results obtained for samples were in agreement with those obtained with a high-performance liquid chromatography method.     

Chemical constituents of the bark of Dipteryx alata vogel, an active species against Bothrops jararacussu venom

The effect of four sub-extracts prepared from the lyophilized hydroalcoholic bark of Dipteryx alata (Leguminosae-Papilionoideae) dissolved in a methanol-water (80:20) mixture through a liquid-liquid partition procedure has been investigated against the neuromuscular blockade of the venom of the snake Bothrops jararacussu. The active CH?Cl? sub-extract has been extensively analyzed for its chemical constituents, resulting in the isolation of four lupane-type triterpenoids: lupeol, lupenone, 28-hydroxylup-20(29)-en-3-one, betulin, nine isoflavonoids: 8-O-methylretusin, 7-hydroxy-5,6,4'-trimethoxyisoflavone, afrormosin, 7-hydroxy-8,3',4'-trimethoxyisoflavone, 7,3'-dihydroxy-8,4'-dimethoxyisoflavone, odoratin, 7,8,3'-trihydroxy-4'-methoxyisoflavone, 7,8,3'-trihydroxy-6,4'-dimethoxyisoflavone, dipteryxin, one chalcone: isoliquiritigenin, one aurone: sulfuretin and three phenolic compounds: vanillic acid, vanillin, and protocatechuic acid. Their chemical structures were elucidated on the basis of spectroscopic analysis, including HRMS, 1D- and 2D-NMR techniques.     

NMR studies into colloidal stability and magnetic order in fatty acid stabilised aqueous magnetic fluids

We report the physico-chemical characterisation of fatty acid stabilised aqueous magnetic fluids, which are ideal systems for studying the influence of nanoparticle aggregation on the emergent magnetic resonance properties of the suspensions. Stable colloids of superparamagnetic magnetite, Fe(3)O(4), nanoparticle clusters in the 80 to 100 nm size range were produced by in situ nanoparticle growth and stabilisation, and by suspending pre-formed nanoparticles. NMR relaxation analysis shows that the magnetic resonance properties of the two types of suspension differ substantially and provides new insights into how the relaxation mechanisms are determined by the organisation of the nanoparticles within the clusters.     

Fast numerical solution of nonlinear nonlocal cochlear models

A fast full second order time-step algorithm for some recently proposed nonlinear, nonlocal active models for the inner ear is analyzed here. In particular, we emphasize the properties of discretized systems and the convergence of a hybrid direct-iterative solver for its approximate solution in view of the parameters of the continuous model. We found that the proposed solver is faster than standard sparse direct solvers for all the considered discrete models.Numerical tests confirm that the proposed techniques are crucial in order to get fast and reliable simulations.