线状锗等离子体X射线线谱的时间分辨测量

用自行研制的X射线条纹晶体谱仪首次测量了线状锗等离子体的X射线时间分辨谱。给出了类Ne-锗L线共振线的时间演化过程,并用类Ne-锗L线共振线与其双电子俘获伴线的相对强度比粗估了锗等离子体的电子温度及其随时间的变化,实验给出了X光激光增益区介质的电子温度为400～760eV,同时给出了电子温度保持相对恒定的时间不小于90ps(电子温度变化小于2％)。     

高折射率芯Bragg光纤的色散特性研究

应用超格子模型分析了高折射率芯Bragg光纤的色散特性，讨论了Bragg光纤的色散的比例性质以及光纤的芯径、包层周期、填充率与波导色散的关系，并利用这些关系举例实现了Bragg光纤在1.55μm附近的宽带色散平坦. 关键词： Bragg光纤 模式 色散 波导色散     

Champ de vitesse dans un échangeur à vortex en régime turbulentHeat exchanger velocity field with turbulent inlet condition

We consider the isothermal flow through a cylindrical flat chamber, a model of some particular heat exchanger, for which LDV measurements and a numerical simulation have been performed. Experimental results show the establishment of an important vortex zone, the secondary flow extending all along the chamber radius. This observation leads to an expected significant increase of the fluid mixing. Results issued from the numerical simulation appear to be in close agreement with experimental data. Nevertheless, the k–ε model used here must be improved to obtain a better approach near the vortex centre. To cite this article: S. Petitot et al., C. R. Mecanique 330 (2002) 593–599.     

Cardy-Verlinde Formula and Thermodynamics of Black Hole in Higher Dimensional Space-Time

In this paper we discuss thermodynamics parameters of black hole horizon and cosmological horizon in general high-dimensional space-time. We obtain that the entropy of a cosmological horizon can be described by the Cardy-Verlinde formula. However, the entropy of black hole horizon will be expressed in a form of the Cardy-Verlinde formula, if one adopts the methods given by Abbott and Deser to compute the mass of a black hole in general high-dimensional space-time. Through discussion, relation among various thermodynamics parameters of the black hole in general high-dimensional space-time is given. That is, differential formula of the first law of thermodynamics is obtained. Because we discuss the general high-dimensional space-time, our result has universality. PACS: 04.20.Dw, 97.60.Lf     

Adhesion measurement of thin films by a modified laser spallation technique: theoretical analysis and experimental investigation

Laser driven shocks can lead to a dynamic failure, called film spallation. Here, we use a modified laser spallation set-up to measure the dynamic adhesion of thin films and we propose a novel diagnostic technology. Based on correlation theory, new spallation criteria for characterizing the progressive damage at the interface between the film and the substrate are established, such as interface delamination, film spallation and film expulsion. With the help of the theory, the degree of damage and the dimension of damage (i.e. fracture), such as the minimum width of delamination radius, the thickness of the film etc., are estimated. Experiments are carried out on epoxy/stainless steel and epoxy/Al, and the experimental results show that their dynamic bonding strengths are about 25 MPa and 20 MPa, respectively. The detailed results, analyses and discussions are presented in this paper. Received: 6 February 2001 / Accepted: 3 December 2001 / Published online: 11 February 2002     

Monte Carlo方法研究低能电子束曝光沉积能分布规律

建立一个描述低能电子在多元多层介质中散射的物理模型,运用MonteCarlo方法模拟低能电子在靶体胶衬底中的复杂散射过程,在此基础上通过大量计算研究入射束能、胶层厚度、衬底材料等不同曝光条件对抗蚀剂沉积能密度分布的影响,获得沉积能分布规律:适量的低束能、薄胶层、低原子序数衬底可以使前散射电子对胶中沉积能密度分布的贡献增大、背散射电子的贡献减小,从而提高曝光分辨率. 关键词： 电子束曝光 MonteCarlo方法 低能电子散射 能量沉积     

ICP-AES测定饮用水源中的Cu、Mn、Pb、Cd、Zn

用ICP－AES法同时测定饮用水源中的Cu、Mn、Pb、Cd、Zn等重金属元素，具有基体效应小、测量范围宽等优点。检出限为0．2－4．0μg/L，回收率为91．5％－103．9％，相对标准偏差为0．29％－1．5％，测定密码样与实际样品，结果令人满意。     

In situ hybridization to chitosan/magnetite nanocomposite induced by the magnetic field

Chitosan/magnetite nanocomposite was synthesized induced by magnetic field via in situ hybridization in ambient condition. Results of XRD patterns and TEM micrographs indicated that magnetite particles with 10–20 nm were dispersed in chitosan homogeneously. An interesting result is that magnetite nanoparticles were assembled to form chain-like structures under the influence of the external magnetic field, which mimics the magnetite chains inside of magnetotatic bacteria. The saturated magnetization (Ms) of nano-magnetite in chitosan was 50.54 emu/g, which is as high as 54% of bulk magnetite. The remanence (Mr) and coercivity (Hc) were 4 emu/g and14.8 Oe, respectively, which indicated that magnetite nanoparticles were superparamagnetic. The key of route is that a pre-precipitated chitosan hydrogel membrane, used as chemical reactor, which controlled the precipitation of chitosan precipitation and in situ transformation of magnetite from the precursor simultaneously in the magnetic field environment.     

Molecular dynamics simulation of thermodynamic properties of NaCl at high pressures and temperatures

The expansivity, constant-pressure heat capacity, and isothermal bulk modulus of sodium chloride (NaCl) have been obtained by using molecular dynamics method. The calculated thermodynamic parameters are found to be in agreement with the available experimental data. At an extended temperature and pressure ranges, these parameters have also been predicted. The thermodynamic properties of NaCl are summarized in the pressure 0-500 kbar ranges and the temperature up to 1000 K.     

Vibration analysis of a beam with PCLD Patch

An analytical approach for vibration response analysis of a beam with single passive constrained layer damping (PCLD) patch is presented. The governing equation of motion of the beam is firstly derived on the basis of an energy approach and the Lagrange equation. The noval contribution is that a third admissible function is introduced to represent the longitudinal displacements of the constraining layer in the PCLD patch when the assumed-modes method is applied for discretizing the governing equation. In conventional analytical approaches, only two admissible functions are used together with a longitudinal static equilibrium equation of a section of base beam or constraining layer. Comparison of the computational results from the proposed analytical approach and the conventional analytical approach as well as a commercial FEM code reveals that the proposed analytical approach can describe the vibration responses of the damped beam more accurately for commonly used viscoelastic material (VEM) layer in the PCLD patch while the conventional analytical approach, in general, overestimates the damping effects of the PCLD patch. The advantages and disadvantages of the proposed analytical approach and conventional analytical approach are discussed through some case studies.