Highly Efficient and Practical Syntheses of Lavendamycin Methyl Ester and Related Novel Quinolindiones

The novel 7-(N-formyl-, 7-(N-acetyl-, and 7-(N-isobutyrylamino)-2-methylquinoline-5,8-diones were synthesized in excellent overall yields in three steps via the nitration of the commercially available 8-hydroxy-2-methylquinoline followed by a reduction-acylation step and then oxidation. Acid hydrolysis of 7-(N-acetylamino)-2-methylquinoline-5,8-dione (14a) afforded the novel 7-aminoquinoline-5,8-dione 7 in excellent yields. Due to our efficient preparation of dione 14a, we now report a short and practical method for the total synthesis of the potent antitumor agent lavendamycin methyl ester (1b) with an excellent overall yield.     

New conductivity detection response equation for anions eluted with fully and partially ionised eluents in non-suppressed ion chromatography

A response equation for conductivity detection in ion chromatography has been derived. This equation is applicable to non-suppressed ion chromatography using both fully ionised and partially ionised eluents. A prime assumption of this equation is that when partially ionised eluents are used (such as benzoic acid), both the ionised and neutral components of the eluent species contribute to the detector response of anionic analytes. Experimental evidence is provided to support this assumption in that pH changes accompanying the elution of an analyte have been measured. These pH changes are proportional to the concentration of analyte injected onto the column, in accordance with predictions from the response equation. Furthermore, it is shown that protonated eluents (such as benzoic acid) give more sensitive detection than equivalent ionised eluents (such as potassium benzoate) and the signal enhancement achieved using a protonated eluent species is in accordance with theory.     

Combined cysteine and homocysteine quantitation in plasma by trap and release membrane introduction mass spectrometry

Recently, a new and efficient method for total homocysteine (tHcy) quantitation in plasma using trap and release membrane introduction mass spectrometry (T&R-MIMS) with a versatile removable direct introduction membrane probe (DIMP) was described [R. Haddad, M. A. Mendes, N. F. Hoehr and M. N. Eberlin, Analyst, 2001, 126, 1212]. Herein we report on the use of the DIMP-T&R-MIMS technique for total cysteine (tCys) quantitation; hence combined tCys and tHcy quantitation in plasma or serum can be achieved. The method employs Cys and Hcy derivatization with ethyl chloroformate (after disulfide bond reduction with dithiothreitol and protein precipitation with trichloroacetic acid), preconcentration in a capillary silicone membrane, and their thermal desorption to the gas phase inside the ion source region of a mass spectrometer, at a point exactly between the two ionization filaments. Thermal desorption uses the uniform heat radiation provided by the two ionization filaments. The analytes are then ionized by electron ionization and both Cys and Hcy are quantitated by mass spectrometry using selected ion monitoring. For tCys quantitation, good linearity and reproducibility was observed for concentrations ranging from 5 to 350 microM, recovery was near 95%, and the limit of detection (LOD) was of 2 microM. This LOD is well below the mean Cys concentration in plasma, and serum samples from a large group of healthy people showed a mean tCys concentration of 132 +/- 45 microM.     

Prediction of retention times for anions in linear gradient elution ion chromatography with hydroxide eluents using artificial neural networks

The feasibility of using an artificial neural network (ANN) to predict the retention times of anions when eluted from a Dionex AS11 column with linear hydroxide gradients of varying slope was investigated. The purpose of this study was to determine whether an ANN could be used as the basis of a computer-assisted optimisation method for the selection of optimal gradient conditions for anion separations. Using an ANN with a (1, 10, 19) architecture and a training set comprising retention data obtained with three gradient slopes (1.67, 2.50 and 4.00 mM/min) between starting and finishing conditions of 0.5 and 40.0 mM hydroxide, respectively, retention times for 19 analyte anions were predicted for four different gradient slopes. Predicted and experimental retention times for 133 data points agreed to within 0.08 min and percentage normalised differences between the predicted and experimental data averaged 0.29% with a standard deviation of 0.29%. ANNs appear to be a rapid and accurate method for predicting retention times in ion chromatography using linear hydroxide gradients.     

Spectrophotometric and fluorometric determination of traces of molybdenum in soils and plants

The reaction of the molybdenum oxypentathiocyanate ion with the dyestuff Rhodamine B (RhB) produces the ternary complex. MoO(SCN)(5)(RhB)(2) The formation of this complex is accompanied by a colour change and by extinction of the fluorescence of RhB. A spectrophotometric and fluorometric method for the determination of Mo has been developed from these observations. The method is free from interferences and has detection limits of 0.1 mug and 0.05 mug of Mo for absorption and fluorescence measurements, respectively. The spectrophotometric method is applicable to the determination of Mo in soils and the fluorometric method is suited to the determination of Mo in plants.     

Contactless conductivity detection of synthetic polymers in non-aqueous size-exclusion electrokinetic chromatography

A capacitively coupled contactless conductivity detection (CCD) system has been applied for the detection of neutral synthetic polymers in capillary size-exclusion electrokinetic chromatography (SEEC). Polystyrene standards, that were used as a model compounds, were separated on a capillary column packed with porous 10 microm silica particles with an electrokinetically driven mobile phase, and detected by CCD and UV detection simultaneously. Mass-calibration curves for polystyrene were constructed. Satisfactory results were obtained for the linearity, the run-to-run repeatability (<0.2% for the relative retention and <4% for the peak area) and the robustness of the detector. One of the major issues in this preliminary study was to investigate the origin of the peaks observed for the polystyrene standards. The effect of the molar mass of the polystyrenes on the sensitivity was small. Therefore, the signals obtained could not be explained as the result of an increased viscosity and a decreased solution conductivity of the solute zone. An alternative hypothesis is suggested, and recommendations for further research are given.     

Vacancy ion-exclusion chromatography of aromatic carboxylic acids on a weakly acidic cation-exchange resin

Determination of aromatic carboxylic acids by conventional ion-exclusion chromatography is relatively difficult and methods generally rely on hydrophobic interaction between the solute and the resin. To overcome the difficulties in determining aromatic carboxylic acids a new approach is presented, termed vacancy ion-exclusion chromatography, which is based on use of the sample as mobile phase and an injection of aqueous 10% methanol onto a weakly acidic cation-exchange column (TSKgel OApak-A). Highly sensitive conductivity detection occurred with sharp and well-shaped peaks, leading to very efficient separations. The effects of sulfuric acid concentration added to the mobile phase, flow-rate, and column temperature on the retention volume of tested aromatic carboxylic acids was investigated. Retention times were found to be affected by the concentration of the analytes in the mobile phase and to some extent also by the addition of an organic modifier such as methanol to the injected water sample. Separation of sulfuric acid (SA), naphthalenetetracarboxylic acid (NTCA), phthalic acid (PA) and benzoic acid (BA) was satisfactory using this new approach. Detection limits were 0.66, 0.67, 0.42 and 0.86 microM and detector responses were linear in the range 1-100, 1-80, 2.5-100 and 10-40 microM, for SA, NTCA, PA and BA, respectively. Precision for retention times was 0.36% and for peak areas was 1.5%.     

Preparation and characterization of p-tert-butylcalix[8]arene bonded capillaries for open-tubular capillary electrochromatography

p-tert-Butylcalix[8]arene bonded capillaries for open-tubular capillary electrochromatography were prepared with γ-glycidoxypropyltrimethoxysilane as a bridge. The bonded capillary displayed low and steady electroosmotic flow (EOF) values over the pH range from 4 to 9. Detection limits for direct spectrophotometric detection at 277 nm for benzenediols (at a signal to noise ratio of 2) were 0.96 mg l⁻¹ for the unbonded capillary and 1.48 mg l⁻¹ for the bonded capillary, showing that the bonded layer did not show significant absorbance and hence decreased sensitivity. The bonded capillaries showed good separation selectivity for o-, m- and p-benzenediols, α- and β-naphthols, and α- and β-naphthylamines. This selectivity was attributed to significant interactions between the analytes and the bonded p-tert-butylcalix[8]arene, which contributed to the electrochromatographic separation mechanism. The bonded capillaries gave high stability and reproducibility.     

Investigations on the behaviour of acidic, basic and neutral compounds in capillary electrochromatography on a mixed-mode stationary phase

This work describes the separation of acidic, basic and neutral organic compounds as well as inorganic anions in a single run by capillary electrochromatography employing a stationary phase which exhibits both strong anion-exchange and reversed-phase chromatographic characteristics. The positive surface charge of this stationary phase provided a substantial anodic electroosmotic flow. The analytes were separated by a mixed-mode mechanism which comprised chromatographic interactions (hydrophobic interactions, ion-exchange) as well as electrophoretic migration. The influence of ion-exchange and hydrophobic interactions on the retention/migration of the analytes could be manipulated by varying the concentration of a competing ion and/or the amount of organic modifier present in the background electrolyte. Additionally the effects of pH changes on both the chromatographic interactions as well as the electrophoretic migration of the analytes were investigated.     

Advances in ion chromatography: speciation of μ 1−1 levels of metallo-cyanides using ion-interaction chromatography

Fe(CN)^4?₆, Cu(CN)^3?₄, Co(CN)^3?₆, Fe(CN)^3?₆, Ni(CN)^2?₄ and Cr(CN)^3?₆ are determined by ion-interaction chromatography using a C₁₈ column and methanol-tetrahydrofuran-10 mM phosphate buffer (pH 7.9) (25 + 1 + 74, v/v/v) containing 5 mM tetrabutylammonium hydroxide as mobile phase, with spectrophotometric detection at 214 nm. Detection limits are in the range 0.01–0.5 mg 1^?1. In an alternative approach, an automated on-line sample preconcentration technique is used wherein a 2-ml volume of sample containing metallo-cyanides is loaded onto a C₁₈ precolumn which has been equilibrated with the above mobile phase. The bound solutes are then eluted from the precolumn to a C₁₈ analytical column where they are separated using the same mobile phase as employed to equilibrate the precolumn. Detection limits are in the rate 0.08–1.58 μg 1^?1 and calibration graphs are linear up to 200 μg 1^?1. The preconcentration step is shown to give quantitative recoveries for all species except Fe(CN)^4?₆ and (CN)^3?₄. The iron(II) complex does not bind quantitatively to the precolumn, and extensive studies with the copper complex suggested that low recoveries were due to dissociation and ligand-exchange reactions occurring during the chromatographic separation process. Negative interference effects were observed for Cl^? and SO^2?₄ when present at a level of 250 mg 1^1?, and UV-absorbing anions such as Br^?, SCN^?, NO^?₂ and NO^?₃ caused positive interference when present at concentrations as low as 1 mg 1^?1. The negative interferences could be reduced by diluting the sample and the positive interferences could be eliminated by incorporating an additional step in the preconcentration process, in which UV-absorbing anions bound to the precolumn after sample loading were eluted selectively using an eluent consisting of 10 mM NaCl in phosphate buffer (pH 6.7).