Cross sections and transverse single-spin asymmetries in forward neutral-pion production from proton collisions at sqrt[s]=200 GeV

Measurements of the production of forward high-energy pi(0) mesons from transversely polarized proton collisions at sqrt[s]=200 GeV are reported. The cross section is generally consistent with next-to-leading order perturbative QCD calculations. The analyzing power is small at x(F) below about 0.3, and becomes positive and large at higher x(F), similar to the trend in data at sqrt[s]< or =20 GeV. The analyzing power is in qualitative agreement with perturbative QCD model expectations. This is the first significant spin result seen for particles produced with p(T)>1 GeV/c at a polarized proton collider.     

Azimuthal anisotropy and correlations at large transverse momenta in p + p and Au + Au collisions at square root sNN=200 GeV

Results on high transverse momentum charged particle emission with respect to the reaction plane are presented for Au + Au collisions at square root s(NN)=200 GeV. Two- and four-particle correlations results are presented as well as a comparison of azimuthal correlations in Au + Au collisions to those in p + p at the same energy. The elliptic anisotropy v(2) is found to reach its maximum at p(t) approximately 3 GeV/c, then decrease slowly and remain significant up to p(t) approximately 7-10 GeV/c. Stronger suppression is found in the back-to-back high-p(t) particle correlations for particles emitted out of plane compared to those emitted in plane. The centrality dependence of v(2) at intermediate p(t) is compared to simple models based on jet quenching.     

Small-core As-Se fiber for Raman amplification

We have demonstrated Raman small-core As-Se fiber. More than 20-dB of gain was observed in a 1.1-m length of fiber pumped by a nanosecond pulse of approximately 10.8-W peak power at 1.50 microm. The peak of the Raman gain occurred at a shift of approximately 240 cm(-1). The Raman gain coefficient is estimated to be approximately 2.3 x 10(-11) m/W, which is more than 300 times greater than that of silica. The large Raman gain coefficient coupled with the large IR transparency window of these fibers shows promise for development of As-Se Raman fiber lasers and amplifiers in the near-, mid-, and long-IR spectral regions.     

Wavelength beam combining of ytterbium fiber lasers

Wavelength beam combining of five ytterbium fiber lasers is demonstrated in a master-oscillator power-amplifier configuration at combined powers up to 6 W. The combined beam profile has an M2 value of 1.14, which is equal to that of an individual fiber. Beam steering in one dimension over 140 resolvable spots is also demonstrated.     

Palladium catalysed cyclisation-carbonylation of enynes to give cyclic gamma,delta-unsaturated acids

In the presence of acetic acid, trifurylphosphine and CO (2 atm), palladium catalyses the conversion of a range of enynes to cyclic delta,gamma-unsaturated carboxylic acids in good yield.     

Highly diastereoselective Simmons-Smith cyclopropanation of allylic amines

[reaction: see text] Cyclopropanation of allylic tertiary amines using the Simmons-Smith reagent has been achieved by employing chelating groups in close proximity to the amine. The chelating groups promote cyclopropanation at the expense of N-ylide formation. Using pseudoephedrine as the chelating group, high diastereoselectivity is observed.     

Measurement of internal stresses via the polarization in epitaxial ferroelectric films

The relations between electrical and mechanical properties of constrained ferroelectric films are analyzed. It is shown that the internal stresses and the elastic constants can be determined through the measurement of the electrical response. The change in the polarization is proportional to internal stresses due to film-substrate misfit, whereas the linear electrical and electromechanical responses to external field do not depend on the misfit and are determined by the film constraint. The theoretical results are successfully applied to PbZr 0.2Ti 0.8O (3) films on (001) LaAlO (3) substrate which exhibit a considerable increase in the saturation polarization due to epitaxial stresses. Significant recovery in the piezoelectric constant and susceptibility is theoretically predicted and experimentally verified for specific film configurations which reduce the degree of constraint. The concept presented in this Letter can be expanded to constrained ferromagnetic and superconductor films.     

Interferometric key readable security holograms with secrete-codes

A new method is described to create secrete-codes in the security holograms for enhancing their anti-counterfeiting characteristics. To imitate these codes is difficult as pure phase objects having complex phase distribution function are used to modulate the object beam that is recorded in conjunction with an encoded interferometric reference beam derived from a key hologram. Lloyd’s folding mirror interferometer is used to convert phase variations of the reconstructed wave-front into an intensity pattern for hologram authenticity verification. Creating the secrete-codes through an interferometric reference beam from the key hologram facilitates a multi-stage authenticity verification as well as easy repositioning of the security hologram through a specific Moiré pattern generated during the verification process.      

Silicon detector technology development in India for the participation in international experiments

A specific research and development program has been carried out by BARC in India to develop the technology for large area silicon strip detectors for application in nuclear and high energy physics experiments. These strip detectors will be used as pre-shower detector in the CMS experiment at LHC, CERN for π ⁰/λ rejection. The fabrication technology to produce silicon strip detectors with very good uniformity over a large area of ∼40 cm², low leakage currents of the order of 10 nA/cm² per strip and high breakdown voltage of >500 V has been developed by BARC. The production of detectors is already under way to deliver 1000 detector modules for the CMS and 90% production is completed. In this paper, research and development work carried out to develop the detector fabrication technology is briefly described. The performance of the silicon strip detectors produced in India is presented. The present status of the detector technology is discussed.