Batch versus Flow Photochemistry: A Revealing Comparison of Yield and Productivity

The use of flow photochemistry and its apparent superiority over batch has been reported by a number of groups in recent years. To rigorously determine whether flow does indeed have an advantage over batch, a broad range of synthetic photochemical transformations were optimized in both reactor modes and their yields and productivities compared. Surprisingly, yields were essentially identical in all comparative cases. Even more revealing was the observation that the productivity of flow reactors varied very little to that of their batch counterparts when the key reaction parameters were matched. Those with a single layer of fluorinated ethylene propylene (FEP) had an average productivity 20 % lower than that of batch, whereas three‐layer reactors were 20 % more productive. Finally, the utility of flow chemistry was demonstrated in the scale‐up of the ring‐opening reaction of a potentially explosive [1.1.1] propellane with butane‐2,3‐dione.     

Longitudinal 3D Blood Flow Distribution Provided by Diffuse Correlation Tomography during Bone Healing in a Murine Fracture Model

Noninvasive monitoring of vascularization can potentially diagnose impaired bone healing earlier than current radiographic methods. In this study, a noncontact diffuse correlation tomography (DCT) technique was employed to measure longitudinal blood flow changes during bone healing in a murine femoral fracture model. The three-dimensional distribution of the relative blood flow was quantified from one day pre-fracture to 48 days post-fracture. For three mice, frequent DCT measurements were performed every other day for one week after fracture, and then weekly thereafter. A decrease in blood flow was observed in the bone fracture region at one day post-fracture, followed by a monotonic increase in blood flow beyond the pre-injury baseline until five to seven days post-fracture. For the remaining 12 mice, only weekly DCT measurements were performed. Data collected on a weekly basis show the blood flow for most mice was elevated above baseline during the first two post-fracture weeks, followed by a subsequent decrease. Torsional strength of the excised femurs was measured for all 15 mice after 7 weeks of healing. A metric based on the early blood flow changes shows a statistically significant difference between the high strength group and the low strength group.     

Annealing of electron irradiated GaP studied by positron lifetime technique

GaP single crystals were irradiated by 3 MeV electrons at 20 K to a dose of 4 × 10¹⁸ e/cm². An isochronal annealing in temperature region 77 ÷ 650 K followed the irradiation. Positron lifetime measurement indicated the presence of irradiation-induced vacancies in Ga sublattice. The vacancies disappeared at two stages observed at temperatures 200 ÷ 300 K and 450 ÷ 550 K.     

Spin torque, tunnel-current spin polarization, and magnetoresistance in MgO magnetic tunnel junctions

We employ the spin-torque response of magnetic tunnel junctions with ultrathin MgO tunnel barrier layers to investigate the relationship between spin transfer and tunnel magnetoresistance (TMR) under finite bias, and find that the spin torque per unit current exerted on the free layer decreases by < 10% over a bias range where the TMR decreases by > 40%. This is inconsistent with free-electron-like spin-polarized tunneling and reduced-surface-magnetism models of the TMR bias dependence, but is consistent with magnetic-state-dependent decay lengths in the tunnel barrier.     

MRI of hepatic lymphoma

Thirteen patients with biopsy proven hepatic lymphoma (2 Hodgkin, 11 Non-Hodgkin) and a control group of 15 patients with hepatic metastases were analyzed quantitatively and qualitatively by MRI. Focal hepatic lymphoma was most reliably detected (eight of eight patients) and appeared hypointense relative to liver on T₁ weighted (CNR − 7.4 ± 2.3) and hyperintense on T₂ weighted (CNR + 8.4 ± 2.9) images. The mean T₁ and T₂ relaxation times of focal hepatic lymphoma (T₁ = 832 ± 234 msec, T₂ = 84 ± 16 ms) differed significantly from adjacent non-tumorous liver (T₁ = 420 ± 121 ms, T₂ = 51 ± 9 ms; p < 0.05), however CNR values and relaxation times were similar to those of hepatic metastases. Diffuse hepatic lymphoma (microscopic periportal infiltration) was undetectable by MRI in three patients by either morphologic features or quantitative criteria. A mixed pattern of hepatic lymphoma (focal lesions and diffuse infiltration) showed focal areas of slightly decreased signal intensity on T₁ weighted images (CNR = −1.7 ± 0.4) while T₂ weighted images revealed multiple regions of focal hyperintensity (CNR = +13.3 ± 8.4) superimposed on a diffusely hyperintense liver. Our experience demonstrates that either T₁ or T₂ weighted techniques are useful in detecting focal and that T₂ weighted techniques are useful in detecting mixed hepatic lymphoma. Conventional image derived relaxation time measurements and quantitative parameters were of no additional diagnostic value.     

Solvation dynamics in methanol: Experimental and molecular dynamics simulation studies

We have investigated the ultrafast dynamics of methanol by time dependent fluorescent shift experiments and molecular dynamic simulations. The experiments were performed with two different probe molecules, 1-aminonaphthalene and coumarin 153. The molecular dynamic simulations employed these probes as well as small atomic and diatomic solutes. We find a previously unobserved fast decay component in the solvation response of methanol. The molecular dynamics results are in good agreement with this experimental result. The origin of this fast response and the linearity of the solvent response are discussed.     

A comparative study of myo-inositol quantification using LCmodel at 1.5 T and 3.0 T with 3 D 1H proton spectroscopic imaging of the human brain

Myo-inositol is a strongly coupled system and resonates at four chemical shift positions. At 1.5 T, only the singlet component at 3.57 ppm is detected. However, at 3 T this resonance is resolved into its components at 3.55 ppm and 3.61 ppm. Due to the increased spectral resolution and signal-to-noise ratio, it is anticipated that the quantification of myo-inositol should improve at 3 T. Using data from normal controls and the LCmodel quantification procedure, we found that the quantification precision, reproducibility and detection sensitivity of myo-inositol is significantly better at 3 T relative to 1.5 T.     

Self‐assembled polyurea macromer nanodispersion and resulting hybrid polyurea‐acrylic emulsions and films

A polyurea macromer (PUM) was synthesized and dispersed in basic conditions to form self‐assembled nanoparticles (<20 nm dispersions, up to 30 wt % aq. soln.). These nanoparticles enabled surfactant‐free emulsion polymerization to form hybrid polyurea‐acrylic particles despite the absence of a measureable water‐soluble fraction. The T_g of the starting PUM material was a strong function of the PUM's extent of neutralization and hydration (varying between 100 °C and >175 °C) due to changes in hydrogen and ionic bonding. Two separate hybrid polyurea‐acrylic emulsion systems were prepared: one by direct polymerization of (meth)acrylic monomers in the presence of the nanodispersion and a second by a physical blend of PUM nanodispersion with an acrylic latex control. The direct polymerization method resulted in a hybrid emulsion particle size that developed by a mechanism resembling conventional emulsion polymerization and was unlike that described for seeded polyurethane dispersion systems. Film hardness was shown to increase with increasing coating thickness for the hybrid film prepared by direct polymerization. The resulting mechanical properties could be explained by applying mechanical models for a composite foam structure. These results were unprecedented for normal elastomer films. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019, 57, 1373–1388     

Interpolation of nonlinear positive or order preserving operators on Banach lattices

Positivity - We study the relationship between exact interpolation spaces for positive, linear operators, for order preserving, Lipschitz continuous operators, and for positive...     

A novel editing technique for F MRI: Molecule-specific imaging

A novel technique is proposed to facilitate the selective imaging of specific molecules from a mixture. The application of the technique presented here demonstrates the ability to selectively produce ¹⁹F MR images of either trifluoroacetic acid or the perfluorocarbon emulsion Oxypherol-ET (perfluorotributylamine), when both molecules are present simultaneously. Selective detection is based on the presence of homonuclear J-modulation in one molecule and differential spin-spin relaxation time (T₂). Perfluorotributylamine, an A₃B₂ system, is subject to homonuclear J-modulation, which produces a null signal from the antiphase components of the triplet (A₃) when an echo time is used in a spin-echo image. At this echo time the second molecule, in this example trifluoroacetic acid, a non-coupled spin system, is selectively imaged. At longer echo times, e.g., TE = 1/J there is substantial recovery of the J-modulated signal, which may be solely observed due to T₂ decay of the trifluoroacetic acid signal. The method is demonstrated both using phantoms and in vivo.