Computer simulation of selective absorption of radiation by the components of a light-scattering layer

A method of calculating the partial characteristics of radiation absorption by the components of light-scattering disperse layers is proposed. This method is based on statistical modeling (the Monte Carlo method). The absorptivities of photographic gelatin and silver bromide microcrystals and the corresponding distributions of the absorbed energy over the layer thickness are calculated using the example of an interaction between actinic radiation and silver halide photographic layers in the wavelength range λ=200–440 nm. The following structural parameters of the photographic layer are used in the calculation: the mean size of emulsion crystals d=0.5 μm; the polydispersity C _V =25%; the volume concentrations C _V =10, 20, and 30%; and the thickness of the emulsion layer H=10 μm.     

A comprehensive study of the long pulse Nd:YAG laser drilling of multi-layer carbon fibre composites

The results of an extensive experimental study of the free running Nd:YAG laser drilling of a multi-layer carbon fibre composite, where adjacent layers have differently orientated fibres, are reported. For holes drilled with the laser operating in fixed-Q mode at 1064 nm, parallel sections of blind holes illustrating discontinuities in the hole size along a given section direction will be shown to occur at the interface between adjacent layers. An explanation for this effect is proposed. Detailed single pulse drilling characteristics will be presented illustrating the exit hole diameter as a function of pulse energy and material thickness. These characteristics illustrate a ‘stable' drilling regime in which the exit hole diameters are least sensitive to changes in pulse energy or material thickness and a less ‘stable' regime in which they are more strongly dependent on these parameters. Drilling characteristics will be given for two different beam qualities, illustrating the greater drilling depth and reduced hole size achievable with an improved beam quality. Finally holes drilled through a 2 mm thick sample of material with multiple pulses are considered. Size distribution curves for entrance and exit holes will be presented. The total energy required (number of pulses × pulse energy) to drill through 2 mm thick material will be reported as a function of pulse energy in stationary air and argon atmospheres and in a partial vacuum, illustrating a threshold energy which is dependent upon the drilling atmosphere. The threshold energies will be discussed with reference to plasma formation and the reactivity of the drilling atmosphere.     

The cardinality of manifold atlases

It is shown that any finite dimensionalC ⁰ manifold (connected and Hausdorff but otherwise unrestricted) has an atlas of cardinality not greater than that of the continuum; while if it has a Hölder continuous pseudo-Riemannian metric then there is a countable atlas.     

Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

Rb saturation spectroscopy with an optically narrowed FM diode laser

A fast-frequency modulated (FM) diode laser has been optically narrowed using the technique of resonant optical feedback, to provide linewidths in each FM mode of ≈ 200 kHz peak-to-peak. With a drive frequency of 50 MHz and modulation index of 0.2, the FM laser has been used for the first time to obtain Doppler-free FM spectra of the Rb D₁ line at 795 nm. The potential use of this system for laser frequency stabilisation is discussed.     

Evaluation of integrals and the mellin transform

Translated from Itogi Nauki i Tekhniki, Seriya Matematicheskii Analiz, Vol. 27, pp. 3–146, 1989.     

Diffraction in a nonlinear defocusing medium

Diffraction by a semitransparent screen is considered in the framework of the nonlinear Schrödinger equation. The case of a defocusing medium is investigated. The method used represents a synthesis of the method of Riemann's matrix problem and the technique of Whitham's deformations of spectral curves.Translated from Zapiski Nauchnykh Seminarov Leningradskogo Otdeleniya Matematicheskogo Instituta im. V. A. Steklova, Vol. 179, pp. 23–31, 1989.     

Large fault-tolerant interconnection networks

This paper deals with reliability and fault-tolerant properties of networks. We first survey general reliability properties of networks, in particular those concerning diameter vulnerability. Then we study in details reliability properties of some families of networks in particular de Bruijn and Kautz networks and their generalizations which appear as very good fault-tolerant networks.     

Buchbesprechungen

Ohne Zusammenfassung

---

Book reviews

     

Electron traps and positive DLTS signals in VPE GaAs MESFETs

Capacitance DLTS measurements have been performed in VPE GaAs MESFETs prepared on Bridgman Cr-doped and LEC undoped semi-insulating substrates. A band of electron traps not intrinsically related to the VPE growth process and accumulating near the metal (gate) — semiconductor interface was detected in all the samples. Deeper regions into the channel were free from any detectable trap. Near pinch-off conditions, a positive capacitance signal was found to dominate the DLTS spectra only in the case of samples prepared on Cr-doped substrates. The hypothesis of this positive transient being related to changes in the occupation of surface states in the ungated surface access regions has been checked by comparing experimental and calculated dependencies of the signal amplitude on reverse gate voltage. Unexplained discrepancies, together with the absence of positive signal in MESFETs prepared on LEC undoped substrates, suggest the possibility of hole emission from hole traps within the bulk of the device.