A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Effective thermal conductivity of water-saturated sintered powder-metal plates

An experimental apparatus and related procedures for the determination of the effective thermal conductivity of sintered powder-metal plates saturated with distilled water at temperatures in the range 20–150°C are discussed. The apparatus and procedures are applied to two samples of sintered powder-metal plates, one made of nickel 200 and the other of stainless steel 316, with porosities of 28.10 and 46.45%, respectively, and each of nominal dimensions 127 mm × 127 mm × 6.35 mm. The experimental results are compared with corresponding predictions yielded by several correlations available in the literature. The correlations based on experimental data for packed beds of spherical particles and also porous plates made of cold-pressed (but not sintered) particles of angular shapes do not apply well to sintered powder-metal plates. A new correlation, which is based on extensions of ideas contained in earlier works and provides improved predictions, is proposed.     

Inverse problems for a mathematical model of redox sorption

We consider a mathematical model of sorption that allows for external diffusion kinetics and a redox reaction. Two inverse problems are considered for this model, uniqueness is proved, and numerical solution methods are proposed. The efficiency of the numerical methods is investigated by computer experiments. __________ Translated from Prikladnaya Matematika i Informatika, No. 23, pp. 15–23, 2006.     

Interpretation of the polyelectrolyte and antipolyelectrolyte effects of poly(N‐vinylimidazole‐co‐sodium styrenesulfonate) hydrogels

Hydrogels of N‐vinylimidazole (VI) and sodium styrenesulfonate (SSS) were synthesized in aqueous solution by radical crosslinking copolymerization with N,N′‐methylene‐bis(acrylamide) as crosslinker. Swelling in several saline solutions was measured for hydrogel samples synthesized with different comonomer concentrations (C_T = 10, 25, or 40%) and with SSS mole fractions covering a broad range (f_SSS = 0–0.7), while the crosslinker ratio was 2 wt % in all cases. The degree of swelling in aqueous solution with a specific ionic strength (μ), plotted versus the SSS composition of the feed, shows a minimum for any set of samples synthesized with a fixed C_T. The dependence of swelling on μ shows both polyelectrolyte (f_SSS beyond the minimum) and antipolyelectrolyte behaviors (in the low f_SSS limit). It was found that the nonGaussian factor of the crosslinking density and the polymer‐solvent interaction parameter increase with f_SSS for any C_T. Moreover, in the low f_SSS limit, the osmotic swelling pressure is governed not only by the ionic contribution, but also by the polymer‐solvent mixing and, the concentration of mobile counterions inside the gel is not proportional to the net fixed charge but to the addition of cationic and anionic side groups, what discards the formation of ionic pairs. The antipolyelectrolyte effect is interpreted as due to the increasing protonation of VI as μ goes up. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1683–1693, 2007     

Ultrashort pulse laser osteotomy

Laser treatment of bone tissue has already been the subject of many studies to find substitutes for mechanical instruments that are nowadays used in implantology and orthopaedics. Mainly lasers with pulse durations in the μs region have been tested leaving surface features that are not always satisfactory. Therefore, in the present study laser osteotomy has been performed with a 330 fs Yb:glass laser, λ = 1040 nm, at a pulse repetition rate of 1 kHz. For bovine spongiosa, compacta, and cartilage, the ablation thresholds as well as the ablation rates for various pulse energies have been determined. Additionally, quadratic areas have been ablated in bone tissue. The remaining morphology has been analyzed via scanning electron microscopy. Laser ablation has also been performed with an Er, Cr:YSGG laser, λ = 2780 nm, PRR = 20 Hz, τ ～ 50 μs. The results of USPL and Erbium laser ablation are compared.     

Diffusion,solubility, and electrical properties of scandium and praseodymium in silicon

An integrated study of diffusion, solubility, and electrical properties of scandium and praseodymium in silicon annealed in various media and temperature ranges (1100–1280 °C) was performed for the first time. The tracer technique, autoradiography, measurements of isothermic capacity and current relaxation, conductivity, and the Hall effect were used for the investigations. The diffusion parameters, solubility, and an acceptor character of scandium and praseodymium impurities in silicon were determined. __________ Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 1, pp. 75–77, January, 2007.     

Vortex ring generation due to the coalescence of a water drop at a free surface

 Results are presented of an experimental investigation of vortex ring formation by a fluid drop contacting a free surface with negligible velocity. The pool fluid is mixed with fluorescein dye, and a laser sheet is used to illuminate a plane of the flow. A series of representative images is recorded by a CCD camera and speculation is made regarding specific sources of vorticity flux through the free surface. Two scaling analyses previously presented by other investigators are demonstrated to be equivalent under the assumptions of this experiment, and they provide the motivation for a series of test runs in which the duration of the coalescence process, τ_*, is related to variations in drop diameter L and fluid surface tension σ. Experimental results are in agreement with the analyses, showing τ_*∼σ^-1/2 and τ_*∼L ^3/2. Received: 22 December 1995 / Accepted: 15 October 1996