Dynamic programming in cricket: optimizing batting order for a sticky wicket

In cricket, a rain-affected pitch can make batting more difficult than normal. Several other conditions such as poor light or an initially lively pitch, may also result in difficulties for the batsmen. In this note, we refer to all of them as ‘sticky wickets’. On sticky wickets, lower order batsmen are often sent into ‘hold the fort’ until conditions improve. In this paper, a stochastic dynamic programming model is used to examine the appropriateness of this policy. The model suggests that the tactic is often optimal when the sticky wicket persists until the end of the day's play, but not often when the sticky wicket is transitory. In some circumstances, it is worthwhile, on a normal wicket near the end of the day, to send in a lower order batsman to hold the fort (a night watchman): when the wicket is sticky, this tactic is even more worthwhile.     

A few points on omnidirectional band gaps in one-dimensional photonic crystals

The universal condition for the formation of omnidirectional band gaps (OBG) in photonic crystal (PC) was derived with consideration of permeability of the materials. And it was found that there are four kinds of PCs: one of them has no OBG, and one always possesses OBG. For the other two kinds of PCs, there are OBG for only TM or TE waves respectively. Moreover, in all PCs, the OBG can be broadened by decreasing the refractive index of the ambient medium or/and increasing the contrast between the wave impedances of the component materials of the PC. PACS 42.70.Qs; 71.20.Tx     

光电倍增管脉冲性能研究

采用外腔式电光开光,调制主动照相探测光源,使光电倍增管处于脉冲工作状态下,以提高光电倍增管的输出幅度和动态范围,改善信号的信噪比,同时避免样品和探测器受长时间强激光照射.对滨松H6780光电倍增管进行了调试,使其线性输出电流由静态的0.1mA提升到脉冲状态的4.4mA,信噪比提高4.5倍.该技术对其他光敏探测有借鉴意义.     

Giant shot-like voltage noise in high current density Nb–AlOx–Nb superconducting tunnel junctions

The flat voltage noise component of current biased, high-transparency Nb/AlO_x/Nb superconducting tunnel junctions has been investigated at frequencies up to 70 kHz. Several aspects of the analyzed phenomena suggest the presence of current noise effects induced by the discreteness of the charge carriers. At subgap voltages, where excess currents occur, a behavior coherent with a multiple Andreev reflection-assisted transport through the tunnel barrier has been found. However, the measured charge values exceed any theoretical prediction.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Potential for micromachined actuation of ultra-wide continuously tunable optoelectronic devices

Tailored scaling represents a principle of success that, both in nature and in technology, allows the effectiveness of physical effects to be enhanced. Mutation and selection in nature are imitated in technology, e.g. by model calculation and design. Proper scaling of dimensions in natural photonic crystals and our fabricated artificial 1D photonic crystals (DBRs, distributed Bragg reflectors) enable efficient diffractive interaction in a specific spectral range. For our optical microsystems we illustrate that tailored miniaturization may also increase the mechanical stability and the effectiveness of spectral tuning by thermal and electrostatic actuation, since the relative significance of the fundamental physical forces involved considerably changes with scaling. These basic physical principles are rigorously applied in micromachined 1.55-μm vertical-resonator-based devices. We modeled, implemented and characterized 1.55-μm micromachined optical filters and vertical-cavity surface-emitting laser devices capable of wide, monotonic and kink-free tuning by a single control parameter. Tuning is achieved by mechanical actuation of one or several air-gaps that are part of the vertical resonator including two ultra-highly reflective DBR mirrors of strong refractive index contrast: (i) Δn=2.17 for InP/air-gap DBRs (3.5 periods) using GaInAs sacrificial layers and (ii) Δn=0.5 for Si₃N₄/SiO₂ DBRs (12 periods) with a polymer sacrificial layer to implement the air-cavity. In semiconductor multiple air-gap filters, a continuous tuning of >8% of the absolute wavelength is obtained. Varying the reverse voltage (U=0–5 V) between the membranes (electrostatic actuation), a tuning range of >110 nm was obtained for a large number of devices. The correlation of the wavelength and the applied voltage is accurately reproducible without any hysteresis. In two filters, tuning of 127 and 130 nm was observed for about ΔU=7 V. The extremely wide tuning range and the very small voltage required are record values to the best of our knowledge. For thermally actuated dielectric filters based on polymer sacrificial layers, Δλ/ΔU=-7 nm/V is found. Received: 10 May 2002 / Published online: 8 August 2002     

Low-lying states of trinuclear mixed-valence cluster: [Fe3S4]0

Low-lying energy states of the [Fe₃S₄]⁰ cluster have been calculated by taking into account the double exchange, superexchange and vibronic interaction. It was found that the adiabatic potential of the excited state withS=0 corresponds to the full delocalization of the “excess” charge. From the analysis of experimental data of Mössbauer spectroscopy and the temperature dependence of the magnetic susceptibility the double exchange parametert≥4000 cm^?1 and the vibronic interaction parameter λ₂/2k cm^?1 have been estimated.     

Magnetic anisotropy of textured CrO2 thin films investigated by X-ray magnetic circular dichroism

Highly a-axis-textured CrO₂ films have been deposited on Al₂O₃ (0001) substrates by chemical vapor deposition. CrO₂ has been found to have highly a-axis (010)-oriented columnar growth on a Cr₂O₃ (0001) initial layer. The six-fold surface symmetry of the Cr₂O₃ initial layer leads to three equivalent in-plane orientations of the a-axis-oriented CrO₂ unit cell. We report Cr L_2,3 X-ray magnetic circular dichroism data along the surface normal and at 60° off-normal sample orientation. For a 60° sample alignment, a strong increase of the projected orbital moment could be observed for unoccupied majority t_2g states using moment analysis. Therefore, the c axis is identified as the intrinsic magnetic easy axis of CrO₂. In addition, a small spin moment and a very strong magnetic dipole term T_z have been found. Received: 8 January 2002 / Accepted: 8 January 2002