Possible Loss and Recovery of Gibbsianness¶During the Stochastic Evolution of Gibbs Measures

We consider Ising-spin systems starting from an initial Gibbs measure ν and evolving under a spin-flip dynamics towards a reversible Gibbs measure μ≠ν. Both ν and μ are assumed to have a translation-invariant finite-range interaction. We study the Gibbsian character of the measure νS(t) at time t and show the following: (1) For all ν and μ, νS(t) is Gibbs for small t. (2) If both ν and μ have a high or infinite temperature, then νS(t) is Gibbs for all t > 0. (3) If ν has a low non-zero temperature and a zero magnetic field and μ has a high or infinite temperature, then νS(t) is Gibbs for small t and non-Gibbs for large t. (4) If ν has a low non-zero temperature and a non-zero magnetic field and μ has a high or infinite temperature, then νS(t) is Gibbs for small t, non-Gibbs for intermediate t, and Gibbs for large t. The regime where μ has a low or zero temperature and t is not small remains open. This regime presumably allows for many different scenarios. Received: 26 April 2001 / Accepted: 10 October 2001     

Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

Rb saturation spectroscopy with an optically narrowed FM diode laser

A fast-frequency modulated (FM) diode laser has been optically narrowed using the technique of resonant optical feedback, to provide linewidths in each FM mode of ≈ 200 kHz peak-to-peak. With a drive frequency of 50 MHz and modulation index of 0.2, the FM laser has been used for the first time to obtain Doppler-free FM spectra of the Rb D₁ line at 795 nm. The potential use of this system for laser frequency stabilisation is discussed.     

Diffraction in a nonlinear defocusing medium

Diffraction by a semitransparent screen is considered in the framework of the nonlinear Schrödinger equation. The case of a defocusing medium is investigated. The method used represents a synthesis of the method of Riemann's matrix problem and the technique of Whitham's deformations of spectral curves.Translated from Zapiski Nauchnykh Seminarov Leningradskogo Otdeleniya Matematicheskogo Instituta im. V. A. Steklova, Vol. 179, pp. 23–31, 1989.     

Buchbesprechungen

Ohne Zusammenfassung

---

Book reviews

     

Electron traps and positive DLTS signals in VPE GaAs MESFETs

Capacitance DLTS measurements have been performed in VPE GaAs MESFETs prepared on Bridgman Cr-doped and LEC undoped semi-insulating substrates. A band of electron traps not intrinsically related to the VPE growth process and accumulating near the metal (gate) — semiconductor interface was detected in all the samples. Deeper regions into the channel were free from any detectable trap. Near pinch-off conditions, a positive capacitance signal was found to dominate the DLTS spectra only in the case of samples prepared on Cr-doped substrates. The hypothesis of this positive transient being related to changes in the occupation of surface states in the ungated surface access regions has been checked by comparing experimental and calculated dependencies of the signal amplitude on reverse gate voltage. Unexplained discrepancies, together with the absence of positive signal in MESFETs prepared on LEC undoped substrates, suggest the possibility of hole emission from hole traps within the bulk of the device.     

Truncated Newton method for sparse unconstrained optimization using automatic differentiation

When solving large complex optimization problems, the user is faced with three major problems. These are (i) the cost in human time in obtaining accurate expressions for the derivatives involved; (ii) the need to store second derivative information; and (iii), of lessening importance, the time taken to solve the problem on the computer. For many problems, a significant part of the latter can be attributed to solving Newton-like equations. In the algorithm described, the equations are solved using a conjugate direction method that only needs the Hessian at the current point when it is multiplied by a trial vector. In this paper, we present a method that finds this product using automatic differentiation while only requiring vector storage. The method takes advantage of any sparsity in the Hessian matrix and computes exact derivatives. It avoids the complexity of symbolic differentiation, the inaccuracy of numerical differentiation, the labor of finding analytic derivatives, and the need for matrix store. When far from a minimum, an accurate solution to the Newton equations is not justified, so an approximate solution is obtained by using a version of Dembo and Steihaug's truncated Newton algorithm (Ref. 1).This paper was presented at the SIAM National Meeting, Boston, Massachusetts, 1986.     

Dubrovin valuation rings and Henselization

Supported in part by the National Science Foundation     

Some experiences in controlling contamination of environmental materials during sampling and processing for low-level actinide analysis

Selected experiences in the control of contamination and the threat it poses to the quality of analytical date are discussed in the context of the whole analytical process from collection of marine environmental samples, through handling and radiochemical separation, to the final interpretation of results. Examples include a demonstration of the contamination introduced during sediment core sectioning, contamination of sea water by a ship's pumping system, and the effect of filtration on the apparent partitioning of radionuclides between solid and liquid phases of sea water.