Preparation and Eh--pH diagrams of Fe(II)--Fe(III) green rust compounds; hyperfine interaction characteristics and stoichiometry of hydroxy-chloride, -sulphate and -carbonate

Fe(II)--Fe(III) hydroxy-chloride, -sulphate and -carbonate were prepared by oxidation of a ferrous hydroxide precipitate in anion-containing aqueous solutions. The compounds are characterized by monitoring the redox potential E_h and the pH of stochiometric suspension vs time with the appropriate concentration ratios. X-ray diffraction allows us to characterize the crystal structure by distinguishing “green rust one” (GR1) from “green rust two” (GR2). Since green rusts (GRs) are of a pyroaurite-sjögrenite-like structure, i.e., consisting of intercalated foreign anions and water molecules in the interlayers between the brucite-like layers of Fe(OH)₂, their chemical formulae can be determined from the Mössbauer spectra. Three quadrupole doublets are observed: D₁ and D₂ correspond to a ferrous state with isomershift IS of about 1.27 mm s^-1 and quadrupole splittings QS of about 2.85 and 2.60 mm s^-1, respectively, whereas D₃ corresponds to a ferric state with IS and QS of about 0.4 mm s^-1. The hyperfine parameters of these doublets are similar from one green rust to another but their intensity ratios vary considerably. Finally, E_h and pH equilibrium diagrams of the Fe species in the presence of chloride, sulphate and carbonate anions contained within the water solution are drawn and the thermodynamic conditions of existence and degrees of oxidation of green rusts are discussed.     

Small angle neutron scattering from oxygen precipitates in silicon

The formation of silicon oxide precipitates from Czochralski grown silicon depends on the time and temperature of the heat treatment as well as on the initial content of interstitially dissolved oxygen. Samples containing between 5×10¹⁷ O_i/cm³ and 13×10¹⁷ O_i/cm³ have been heated at 750° C for 96 h. SiO₂ precipitates of various shape and size have been obtained and investigated by means of small angle neutron scattering (SANS) in the Q-range 0.05 Å^–1<Q<0.2 Å^–1. The obtained SANS patterns reveal a typical anisotropy of their intensity distribution, which splits into a central peak at Q<0.1 Å^–1 due to the shape of the individual particles and a number of weak intensities for large Q-values, originating from a correlation between defects, possibly between the precipitates. While these correlation peaks in the SANS patterns are seen best for rather low values of about (5–7)×10¹⁷ O_i/cm³ oxygen content, the central peak anisotropy is most pronounced for higher values of ca 10×10¹⁷ O_i/cm³. The integrated intensity of the central peak increases with increasing initial oxygen content. For comparison, untreated samples of the same initial oxygen content do not reveal any anisotropic SAN scattering or a broadened central peak beam.     

Spin-trapped hydroxyl free radicals studied at low field by Field-Cycled Dynamic Nuclear Polarization

The technique of Field-Cycled Dynamic Nuclear Polarization (FC-DNP) involves the EPR irradiation of a free radical solution and the subsequent observation of the NMR signal, the experiment being carried out at a range of magnetic field strengths in order to measure the free radical’s EPR spectrum. In this work FC-DNP has been used to study the EPR spectrum of DMPO spin-trapped hydroxyl free radicals at magnetic field strengths between 0.5 mT and 13.0 mT (5–130 Gauss). The low-field EPR spectrum contains six separate EPR lines, in contrast to the well-known X-band spectrum where only four are seen. Knowledge of the spin-adduct’s EPR spectrum will be of use to workers involved in low-field EPR, especially those conducting biological or in-vivo spin-trapping experiments.     

Experimental modelling of high frequency circuits at low audio frequencies part I

At microwave frequencies, frequent use is made in circuit design of the electrical properties of short lengths of resistively terminated transmission line. It will be shown in the following contribution that circuits based on high frequency distributed lines can usefully be modelled at low audio frequencies using lumped element lines.     

Selective saturation and inversion of multiple resonances in high-resolution solid-state 13C experiments using slow spinning CP/MAS and tailored DANTE pulse sequences.

Taking advantage of the long 13C T1 values generally encountered in solids, selective saturation and inversion of more than one resonance in 13C CP/MAS experiments can be achieved by sequentially applying several DANTE pulse sequences centered at different transmitter frequency offsets. A new selective saturation pulse sequence is introduced composed of a series of 90 degrees DANTE sequences separated by interrupted decoupling periods during which the selected resonance is destroyed. Applications of this method, including the simplification of the measurement of the principal values of the 13C chemical shift tensor under slow MAS conditions, are described. The determination of the aromaticity of coal using a relatively slow MAS rate is also described.     

A correspondence principle connecting IBVPs of wave propagation and heat conduction

A wave-heat correspondence principle is established by utilizing previous operational relations of van der Pol and Bremmer. By the suggested procedure, heat conduction problems can be solved by using an auxiliary wave-propagation problem in conjunction with the correspondence principle. A check on this procedure was provided by solving a mixed BVP of transient heat flow. The present correspondence principle is particularly useful in dealing with IBVPs involving wedge-shaped domains, and characteristic lengths.     

Optical switching between bistable soliton states: a theoretical review

In this paper we summarize what is currently known about optical switching between bright bistable soliton states in one and higher dimensions. A guideline to selecting media with appropriate intensity-dependent refractive indices to support bistable solitary waves is presented. The stability criterion for robustness of the solitary waves is discussed. Finally, some methods and numerical examples of optical switching are presented.