Preliminary design of high-power wave-guide/transmission system for multimegawatt CW requirements of 100 MeV proton LINAC

Development of a 100 MeV CW proton LINAC has been planned at CAT. This LINAC will be needing CW rf power in the frequency ranges of 350 MHz and 700 MHz for its RFQ and DTL/CCDTL/SFDTL structures respectively. The power to the accelerating structures will be produced by either 1 MW CW or 250 kW CW klystrons/inductive output tubes (HOM IOTs). The power needed by respective feed points in the structure is max. 250 kW which will be powered by splitting the power from 1 MW klystron/klystrode into four channels by using a wave-guide system. In case of using 250 kW tubes the power to the structures will be provided directly from each tube. Two types of wave-guide transmission system have been considered, viz, WR 2300 for 350 MHz rf needs and WR 1500 for 700 MHz rf needs. The typical wave-guide system has been designed using the 1 MW CW klystron followed by wave-guide filter, dual directional coupler, high-power circulator, three 3 dB magic TEE power dividers to split the main channel into four equal channels of 250 kW each. Each individual channel has dual directional couplers, flexible wave-guide sections and high power ceramic vacuum window. The circulator and each power divider is terminated into the isolated ports by high power CW loads. Out of the four channels three channels have phase shifters. Present paper describes the technological aspects and design specifications-considerations for these stringent requirements.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Si衬底上ZnSe外延膜的低压MOCVD生长

以硒化氢（H2Se）和二甲基锌为源材料，生长温度是300℃时，用低压金属有机化学气相沉积（LP－MOCVD）系统在Si(111)衬底上外延生长了ZnSe薄膜。通过X射线衍射（XRD）、扫描电子显微镜的能量色散（EDS）以及光致发光（PL）实验验证ZnSe外延膜的质量，在X射线衍射谱中只有一个强的ZnSe(111)面衍射峰，这说明外延膜是（111）取向的单晶薄膜，在能量色散谱中除了Si,Zn和Se原子外，没有观测到其他原子，说明ZnSe外延膜中杂质含量较少。ZnSe外延膜中Zn/Se原子比接近1，有较好的化学配比。在ZnSe外延膜的77K光致发光谱中没有观测到与深中心发射相关的发光峰，表明ZnSe外延膜的晶格缺陷密度较小。77K时的近带边发射峰447nm在室温时移至465nm附近。     

Potential for micromachined actuation of ultra-wide continuously tunable optoelectronic devices

Tailored scaling represents a principle of success that, both in nature and in technology, allows the effectiveness of physical effects to be enhanced. Mutation and selection in nature are imitated in technology, e.g. by model calculation and design. Proper scaling of dimensions in natural photonic crystals and our fabricated artificial 1D photonic crystals (DBRs, distributed Bragg reflectors) enable efficient diffractive interaction in a specific spectral range. For our optical microsystems we illustrate that tailored miniaturization may also increase the mechanical stability and the effectiveness of spectral tuning by thermal and electrostatic actuation, since the relative significance of the fundamental physical forces involved considerably changes with scaling. These basic physical principles are rigorously applied in micromachined 1.55-μm vertical-resonator-based devices. We modeled, implemented and characterized 1.55-μm micromachined optical filters and vertical-cavity surface-emitting laser devices capable of wide, monotonic and kink-free tuning by a single control parameter. Tuning is achieved by mechanical actuation of one or several air-gaps that are part of the vertical resonator including two ultra-highly reflective DBR mirrors of strong refractive index contrast: (i) Δn=2.17 for InP/air-gap DBRs (3.5 periods) using GaInAs sacrificial layers and (ii) Δn=0.5 for Si₃N₄/SiO₂ DBRs (12 periods) with a polymer sacrificial layer to implement the air-cavity. In semiconductor multiple air-gap filters, a continuous tuning of >8% of the absolute wavelength is obtained. Varying the reverse voltage (U=0–5 V) between the membranes (electrostatic actuation), a tuning range of >110 nm was obtained for a large number of devices. The correlation of the wavelength and the applied voltage is accurately reproducible without any hysteresis. In two filters, tuning of 127 and 130 nm was observed for about ΔU=7 V. The extremely wide tuning range and the very small voltage required are record values to the best of our knowledge. For thermally actuated dielectric filters based on polymer sacrificial layers, Δλ/ΔU=-7 nm/V is found. Received: 10 May 2002 / Published online: 8 August 2002     

Vibrational Dynamics Studies by Nuclear Resonant Inelastic X-Ray Scattering

Nuclear resonant inelastic X-ray scattering of synchrotron radiation is being applied to ever widening areas ranging from geophysics to biophysics and materials science. Since its first demonstration in 1995 using the ⁵⁷Fe resonance, the technique has now been applied to materials containing ⁸³Kr, ¹⁵¹Eu, ¹¹⁹Sn, and ¹⁶¹Dy isotopes. The energy resolution has been reduced to under a millielectronvolt. This, in turn, has enabled new types of measurements like Debye velocity of sound, as well as the study of origins of non-Debye behavior in presence of other low-energy excitations. The effect of atomic disorder on phonon density of states has been studied in detail. The flux increase due to the improved X-ray sources, crystal monochromators, and time-resolved detectors has been exploited for reducing sample sizes to nano-gram levels, or using samples with dilute resonant nuclei like myoglobin, or even monolayers. Incorporation of micro-focusing optics to the existing experimental setup enables experiments under high pressure using diamond-anvil cells. In this article, we will review these developments. This revised version was published online in August 2006 with corrections to the Cover Date.     

Magnetic anisotropy of textured CrO2 thin films investigated by X-ray magnetic circular dichroism

Highly a-axis-textured CrO₂ films have been deposited on Al₂O₃ (0001) substrates by chemical vapor deposition. CrO₂ has been found to have highly a-axis (010)-oriented columnar growth on a Cr₂O₃ (0001) initial layer. The six-fold surface symmetry of the Cr₂O₃ initial layer leads to three equivalent in-plane orientations of the a-axis-oriented CrO₂ unit cell. We report Cr L_2,3 X-ray magnetic circular dichroism data along the surface normal and at 60° off-normal sample orientation. For a 60° sample alignment, a strong increase of the projected orbital moment could be observed for unoccupied majority t_2g states using moment analysis. Therefore, the c axis is identified as the intrinsic magnetic easy axis of CrO₂. In addition, a small spin moment and a very strong magnetic dipole term T_z have been found. Received: 8 January 2002 / Accepted: 8 January 2002     

宽带Ⅱ-Ⅵ族半导体及其低维结构的生长和光学性质研究进展

本文系自1979年以来，宽带Ⅱ-Ⅵ族半导体研究组取得的主要研究成果的简要介绍。取得的主要研究成果可分为如下六个方面：第一，系统地研究了宽带Ⅱ-Ⅵ族半导体在电场激发下的自由激子发射；第二，创造性地提出并实 利用宽带Ⅱ-Ⅵ族超晶格的室温激子效应来实现在蓝绿区快响应的光学双稳的物理思想；第三，深入研究了宽带Ⅱ-Ⅵ族超晶格中的激子行为以及激子与元激发态的相互作用，为利用激子获得有效蓝色自发和受激发射提供物理基础和实验途径；第四，研究了ZnSe基非对称双量子阱和组合超晶格中激子的隧穿以及激子的自发和受激发射；第五，CdSe和ZnSeS自组装量子点的生长及其形成机理；第六，ZnO薄膜的生长及其紫外发射特性。     

The time recovery of the spectroscopic properties of heavily irradiated CdZnTe and CdTe detectors

The time recovery of the spectroscopic capabilities of CdZnTe and CdTe detectors, irradiated with increasing doses of high- and low-energy neutrons, as well as electrons, has been investigated by studying their spectroscopic behavior at different photon energies using leakage current measurements and PICTS (photo-induced current transient spectroscopy) analysis. The detectors were stored at room temperature for up to one year to study the time evolution of their spectroscopic performance and to correlate it with the presence of defective states in the material. We have observed a clear improvement in the material’s detection properties with time, though only in those detectors which have not been severely degraded by the irradiation. The recovery can be associated with a decrease in the concentration of some defective states, thus allowing the assessment of the crucial role these play in determining the charge collection processes in the material and its spectroscopic capabilities. Received: 1 August 2001 / Accepted: 3 August 2001 / Published online: 20 December 2001     

Antimagnons in ferrimagnets

Purely antiferromagnetic intrinsic oscillations of magnetic ions in a tetragonal ferrimagnet are considered. The magnetic ions occupy two double positions (forming four magnetic sublattices) so that the center of symmetry for each position is not a closed element. Not involving the total magnetization vector, the oscillations are not excited by the magnetic field; however, the oscillations can be excited by an alternating electric field or by a combination of a constant electric field and the alternating magnetic field of a certain frequency. This phenomenon is a dynamic manifestation of the magnetoelectric interaction. These oscillations, representing a new special type of spin waves (magnons), were called antimagnons. The intrinsic frequencies of antimagnons, as well as the corresponding susceptibilities, were determined. Quantitative estimates were obtained for a Mn₂Sb-based ferrimagnetic phase in both easy-axis and easy-plane orientation states.