Inspection of the reversal of enantiomer migration order in ligand exchange micellar electrokinetic capillary chromatography

Enantiometers of D,L-phenylalanine were separated by capillary electrophoresis based on the principle of ligand exchange. Copper (II) complex of 4-hydroxy-L-proline was used as chiral selector. The separation and the migration order of D- and L-phenylalanine were strongly affected by adding an anion surfactant sodium dodecylsulfate (SDS). Without SDS in the electrolyte, the separation was also carried out but the resolution was very small. With SDS added into the electrolyte, the resolution decreased with increasing concentration of SDS until 5.0 mM. When the concentration of SDS in the electrolyte was over 5.0 mM, inversion of the migration order of DL-phenylalanine was observed and the resolution was also increased with increasing concentration up to 20 mM. It was interesting to find that the inversion of the migration order took place not only in the enantioscparation but also in the positional isomers. A family of a fluorinated amino acid, o-, m- and p-fluoro-D,L-phenylalanine was separated and the inversion of the migration order is discussed.     

Instrumental neutron activation analysis of large samples: A pilot experiment

A large sample INAA (LS-INAA) was conducted based on available experimental conditions. Four different materials, e.g., a quartz-sand and three wastes from an incineration plant were analyzed on sample size of 1 kg. The neutron flux spatial distribution was determined by irradiation of flux monitors in the sample. The gamma-ray apparent counting efficiency was evaluated based on the effective-solid angle concept, using linear attenuation coefficients calculated from an iteration process. The k ₀- and the modified monostandard methods were modified for the LS-INAA. To check the LS-INAA performance, a conventional small sample INAA was carried out for the quartz sand and a waste. All detected elements in the LS-INAA are presented and the discussion is conducted to explore the sources of errors in the LS-INAA. As a pilot experiment, the information from this work will be used in constructing irradiation and counting devices for the new FRM-II neutron source in Garching, Germany.     

Development of a new reaction system for the synthesis of highly optically active alpha,gamma-substituted gamma-butyrolactones

A highly useful method for the synthesis of optically active alpha,gamma-substituted gamma-butyrolactones has been developed. The SmI(2)-induced reductive coupling of chiral 2-alkyl acrylates derived from isosorbide with ketones in the presence of (1S)-(-)-2,10-camphorsultam as a proton source give the chiral alpha,gamma-substituted gamma-butyrolactones in good yields and high enantiomeric purities (up to >99% ee for trans and 75% ee for cis). The reaction system has been investigated with various ketones, and it is demonstrated that this system is very effective for trans-alpha,gamma-substituted gamma-butyrolactones. Both the chiral auxiliary and the hindered proton source in this system are necessary for the observed excellent ee values of the products. The absolute configuration of the trans products is assigned on the basis of the X-ray crystal structure.     

Use of the tubulin bound paclitaxel conformation for structure-based rational drug design

A new computational docking protocol has been developed and used in combination with conformational information inferred from REDOR-NMR experiments on microtubule bound 2-(p-fluorobenzoyl)paclitaxel to delineate a unique tubulin binding structure of paclitaxel. A conformationally constrained macrocyclic taxoid bearing a linker between the C-14 and C-3'N positions has been designed and synthesized to enforce this "REDOR-taxol" conformation. The novel taxoid SB-T-2053 inhibits the growth of MCF-7 and LCC-6 human breast cancer cells (wild-type and drug resistant) on the same order of magnitude as paclitaxel. Moreover, SB-T-2053 induces in vitro tubulin polymerization at least as well as paclitaxel, which directly validates our drug design process. These results open a new avenue for drug design of next generation taxoids and other microtubule-stabilizing agents based on the refined structural information of drug-tubulin complexes, in accordance with typical enzyme-inhibitor medicinal chemistry precepts.     

pH-sensitive polyelectrolyte complex gel microspheres composed of chitosan/sodium tripolyphosphate/dextran sulfate: swelling kinetics and drug delivery properties

Porous chitosan (CS) polyelectrolyte complex (PEC) hydrogel microspheres were prepared via either wet phase-inversion or ionotropic crosslinking with sodium tripolyphosphate (Na+ - TPP) and dextran sulfate (DS). The resulting microspheres were characterized using scanning electron microscopy (SEM) and elemental analysis (EA). The controlled release behavior of ibuprofen (IBU) from these microspheres was investigated. The PEC microspheres were about 700-950 microm in diameter with large pores and open porous structure. The CS/TPP/DS microspheres resisted hydrolysis in strong acid and biodegradation in enzymatic surroundings. The swelling kinetics for CS microspheres was close to Fickian diffusion, whereas those for CS/TPP and CS/TPP/DS were non-Fickian. Furthermore, the equilibrium water content (EWC) and water diffusion coefficient (D) increased with the pH of the media. The release profiles of IBU from CS/TPP/DS microspheres were slow in simulated gastric fluid (SGF, pH 1.4) over 3 h, but nearly all of the initial drug content was released in simulated intestinal fluid (SIF, pH 6.8) within 6 h after changing media. Overall the results demonstrated that CS/TPP/DS microspheres could successfully deliver a hydrophobic drug to the intestine without losing the drug in the stomach, and hence could be potential candidates as an orally administered drug delivery system.     

Dispersion state of CuO on CeO2

XRD and XPS are used to study the dispersion state of CuO on ceria surface. The dispersion capacity values of CuO measured by the two methods are consistent, which are of 1.20 mmol CuO/100 m² CeO₂. In addition, the results reveal that highly dispersed Cu²⁺ ions are formed at low CuO loadings and that increasing the CuO content to a value higher than its dispersion capacity produces crystalline CuO after the surface vacant sites on CeO₂ are filled. The atomic composition of the outermost layer of the CuO/CeO₂ samples has been probed by using static secondary ion mass spectroscopy (SSIMS), and the ratim of Cu/Ce are found to be 0.93 and 0.46 for the 1.22 and 0.61 mmol CuO/CeO₂ samples respectively. Temperature-programmed reduction (TPR) profile with two reduction peaks at 156 and 165°C suggests that the reduction of highly dispersed Cu²⁺ ions consists of two steps and is easier than that of CuO crystallites, in which the TPR profile has only one reduction peak at about 249°C. The above experimental results are in good agreement with the prediction of the incorporation model. Project supported by the National Natural Science Foundation of China.     

6β-Acetoxy-7 α-Hydroxyroyleanone,A New Compound from Taiwania Cryptomerioides Hayata

Two crystalline compounds from the bark of Taiwania cryptomerioides Hayata were isolated. One of them was identified as 6,7-dehydroroyleanone and the other was shown to be a new derivative of royleanone having a structure of 6β-acetoxy-7α-hydroxyroyleanone.     

Reactions of hydrazoic acid on TiO2 nanoparticles: an experimental and computational study

This article reports the results of a computational and experimental study on the reaction of hydrazoic acid, HN3, adsorbed on 15-20 nm TiO2 particle films. Experimentally, FTIR spectra of HN3(a) have been measured by varying HN3 dosage, UV irradiation time and surface annealing temperature. Three sharp peaks, related to v(a)(NNN) of HN3(a) and N3(a) with different configurations in the 2000-2200 cm(-1) region, and a broad band absorption, related to associated and isolated HN(a) and HO(a) adsorptions in the 3000-3800 cm(-1) region, have been detected. Computationally, molecular structures, vibrational frequencies and adsorption energies of possible adsorbates including HN3 and its derivatives, N3, N2, NH, and H, have been predicted by first-principles calculations based on the density functional theory (DFT) and the pseudopotential method. On the basis of the experimental and computational results, the peak appeared at 2075 cm(-1), which increases at a faster rate with HN3 exposure time, is attributed to a stable adsorbate, N3-Ti(a), with the predicted adsorption energy, E(ads) = 13 kcal/mol. The peak at 2118 cm(-1), which survives at the highest surface temperature in the heating experiment, is attributable to the most stable adsorbate, Ti-N2N(H)-O(a) with E(ads) = 36 kcal/mol. The peak at 2170 cm(-1), which vanishes most readily in all of the aforementioned experiments, is related to less stable molecular adsorbates, end-on HN3-Ti(a) with E(ads) = 5 kcal/mol and side-on HN(N2)-Ti(a) with E(ads) = 8 kcal/mol. A potential energy diagram for the formation of various absorbates with their transition states has been established for the HN3/TiO2 system. On the basis of the predicted desorption energies, the four most stable products of the HN3 reaction on TiO2 are H-O(a), 118 kcal/mol; HN-O(a), 85 kcal/mol; Ti-N2N(H)-O(a), 36 kcal/mol; and N3-O(a), 19 kcal/mol.     

Study on osmotic pressures for aqueous lysozyme and alpha-chymotrypsin-electrolyte solutions with two Yukawa potentials

The equation of state (EOS) of Duh and Mier-y-Terán for one Yukawa potential is expanded to two Yukawa potentials to describe the nonidealities of the charged lysozyme and alpha-chymotrypsin solutions. Instead of the classical DLVO theory, the attractive dispersion and double-layer repulsion interactions are represented by two Yukawa potentials, respectively. For the aqueous lysozyme solutions, the only adjustable dispersion energy parameter epsilon/k is regressed and the average deviation is 1.76%. For the aqueous alpha-chymotrypsin solutions, two adjustable parameters (the molecular weight and dispersion energy parameter) are regressed and the average deviation is 7.62%. Some correlation and prediction results are discussed.     

An immune algorithm for resolution of multicomponent overlapping chromatograms

A novel immune algorithm for resolution and quantitative determination of the components in overlapping chromatograms was proposed by imitating biological immune systems. The algorithm takes an overlapping chromatogram as its input and subtracts the chromatograms of standard samples from the input by iteration of a network. When the residual does not change, the network will converge and chromatographic information of the components in overlapping chromatogram will be obtained. Both simulated and experimental data sets were investigated by the method. Results showed that both resolved results and recoveries of quantitative determination are satisfactory. Comparing with conventional least-square method, the immune algorithm is fast in calculation.