Interplay between superconductivity and pseudogap state in bilayer cuprate superconductors

The interplay between the superconducting gap and normal-state pseudogap in the bilayer cuprate superconductors is studied based on the kinetic energy driven superconducting mechanism. It is shown that the charge carrier interaction directly from the interlayer coherent hopping in the kinetic energy by exchanging spin excitations does not provide the contribution to the normal-state pseudogap in the particle–hole channel and superconducting gap in the particle–particle channel, while only the charge carrier interaction directly from the intralayer hopping in the kinetic energy by exchanging spin excitations induces the normal-state pseudogap in the particle–hole channel and superconducting gap in the particle–particle channel, and then the two-gap behavior is a universal feature for the single layer and bilayer cuprate superconductors.     

Piezoelectric activities and domain patterns of orthorhombic Ba(Zr,Ti)O3 ceramics

Ba(Zr_xTi_1?x)O₃ (0.025 ≤ x ≤ 0.065) ceramics were prepared by conventional solid-state reaction method. Crystalline structures were analyzed by X-ray diffraction. It was shown that all the Ba(Zr_xTi_1?x)O₃ (0.025 ≤ x ≤ 0.065) ceramics were of orthorhombic phase at room temperature. Piezoelectric activities and domain patterns were investigated and compared with those of BaTiO₃ ceramic. All the Ba(Zr_xTi_1?x)O₃ ceramics showed nearly the same d₃₃ values of about 265 pC/N and the same domain width of about 220 nm. By comparing the grain sizes and domain width of the Ba(Zr_xTi_1?x)O₃ ceramics with those of BaTiO₃ ceramic, it is speculated that the variation of domain width with grain sizes in orthorhombic Ba(Zr_xTi_1?x)O₃ ceramics may be different with that in tetragonal BaTiO₃ ceramic. Besides domain width, the effective inertia mass of domain wall is also considered to be a very important factor that impacts the piezoelectric activities of the Ba(Zr_xTi_1?x)O₃ ceramics.     

考虑Soret和Dufour效应的方腔内双扩散自然对流格子Boltzmann模拟

采用格子Boltzmann方法,考虑Soret和Dufour效应,对内置高浓度发热圆的方腔内部双扩散自然对流现象进行数值模拟.高浓度发热圆位于方腔中心,四周壁面均为低温低浓度.在该模型中,用三个独立的LBGK方程分别模拟速度场、温度场和浓度场,并通过Boussinesq近似将它们耦合起来.分析Soret数和Dufour数对方腔内部双扩散自然对流的影响,得到流线图、等温线图、等浓度线图、发热圆表面平均Nusselt数和平均Sherwood数.结果表明：Soret和Dufour效应对方腔内双扩散自然对流影响明显,不能忽略.     

热阴极径向温度非均匀性对本征发射度的影响

从热发射理论出发,推导了非均匀发射阴极的均方根本征发射度的一般计算形式。针对一种最常见的温度径向分布近似模型,给出了均方根发射度随温度非均匀性变化趋势的理论数值解。基于有限差分法粒子仿真技术统计了热阴极的本征发射度,仿真结果与理论解一致,验证了非均匀发射热阴极本征均方根发射度一般形式的正确性。结果表明,径向温度非均匀性引起均方根发射度显著变化,非均匀系数为10%时引起均方根发射度下降约15%。本文建立的理论形式和仿真方法可以有效评估束流品质控制目标和工程热设计之间的依赖关系,以指导高效费比的工程设计。     

Dynamical behaviour of Liu system with time delayed feedback

This paper investigates the dynamical behaviour of the Liu system with time delayed feedback. Two typical situations are considered and the effect of time-delay parameter on the dynamics of the system is discussed. It is shown that the Liu system with time delayed feedback may exhibit interesting and extremely rich dynamical behaviour. The evolution of the dynamics is shown to be complex with varying time-delay parameter. Moreover, the strange attractor like ‘wormhole＇ is detected via numerical simulations.     

二元混合制冷剂CO2/R600的气液相平衡研究

采用PR状态方程及其混合法则对不同配比的二元混合制冷剂CO2/R600的气液相平衡进行了计算,将计算结果与相关文献数据进行了比对。结果表明,该文的计算结果与文献数据吻合较好,推算方法可用于CO2/R600混合制冷剂的基本热物性预测。     

非下采样小波变换红外光谱数据去噪

为了降低噪声对实测红外光谱信号的影响,引入了一种非下采样小波变换的红外光谱数据去噪方法。采用非下采样小波变换对原始光谱信号进行多尺度分解,提取信号的多尺度细节特征;根据光谱信号和噪声在不同尺度上的差异,通过应用变分偏微分方程方法调整分解后的各子带系数;重构各子带就可以将原始光谱信号中真实信号和噪声分离,从而达到剔除噪声的目的。通过两组实验对比传统小波和该方法针对红外光谱数据的消噪效果,实验结果表明:非下采样小波变换在红外光谱数据去噪方面具有明显的优势,不仅能够有效地去除噪声,很好地保持信号的形状,并且均方误差较小;在实际的红外光谱数据处理中能够获得较好的去噪效果。     

高次柱面反射型太阳能聚光镜的光学设计

提出了一种新型高效太阳能聚光镜, 这种聚光镜用一组特定系数, a₂, a₄, a₆, a₈, a₁₀, a₁₂, a₁₄, a₁₆ 与 C的高次柱面内壁的一部分作为反射镜. 利用高次柱面方程和光反射定律, 推导出了在高次柱面内壁上太阳反射光束的方向矢量与高次柱面系数C, a₂,a₄, a₆, a₈, a₁₀, a₁₂, a₁₄, a₁₆的关系, 通过优化设计这些系数, 可以使入射到高次柱面内壁上的太阳光束反射后全部聚焦在一条与柱面母线平行的宽度很窄的线段上, 形成线聚光. 这组特定系数用粒子群优化算法求得, 并经计算机模拟证明其聚焦效果. 用这组特定系数的高次柱面作为聚光镜, 其对光的压缩比可达148倍, 其线性光斑可作为一种强光源或高温光源. 高次柱面反射镜可由金属或玻璃直接磨制而成, 也可由高次柱面骨架和铺设在骨架上的镀铝聚酯薄膜构成. 关键词： 太阳能聚光镜 高次柱面 多项式系数优化 线性聚焦     

不同表面结构特征圆柱导体的太赫兹散射特性

太赫兹频段下导体表面的细微结构、粗糙度等细节将对目标电磁散射行为产生影响。为衡量这一影响程度,以圆柱导体为例研究了太赫兹频段下目标表面不同结构特征的电磁散射现象及其在图像域的表现规律。利用高频电磁计算方法获得了表面分别为理想光滑、带刻痕和周期粗糙的三种圆柱多姿态角、多频点单站散射场;基于转台成像算法重建了小转角下目标的二维图像。从仿真结果可以看出:m量级的细节特征在太赫兹雷达图像上有着显著的表现,表明太赫兹雷达能够获取更加丰富和精细的目标信息,从而为目标探测识别提供新的特征和技术手段。     

从物理现象着手教好活的物理学——谈2011年国家级精品教材《普通物理学教程热学》第3版和2005年国家级精品课程热学

文章作者主持的国家级精品教材《热学》第3版和国家级精品课程热学的目标和特色是要教好活的物理学.热学教材和教学内容的"实"、"新"、"宽"就是从物理现象着手教好活的物理学的重要体现,而在此基础上进一步强调科学思维方法的训练,特别是强调创新能力的培养,这就是"活".课堂讨论是热学课程又一特色.