Non-Euler–Lagrangian Pareto-optimality Conditions for Dynamic Multiple Criterion Decision Problems

In this paper the problem of verifying the Pareto-optimality of a given solution to a dynamic multiple-criterion decision (DMCD) problem is investigated. For this purpose, some new conditions are derived for Pareto-optimality of DMCD problems. In the literature, Pareto-optimality is characterized by means of Euler-Lagrangian differential equations. There exist problems in production and inventory control to which these conditions cannot be applied directly (Song 1997). Thus, it is necessary to explore new conditions for Pareto-optimality of DMCD problems. With some mild assumptions on the objective functionals, we develop necessary and/or sufficient conditions for Pareto-optimality in the sprit of optimization theory. Both linear and non-linear cases are considered.     

纳米颗粒悬浮液池内泡状沸腾的实验研究

本文对纳米颗粒悬浮液在平壁面上池内沸腾进行了实验研究。实验用的纳米粒子为26 nm的铁粉和13 nm的三氧化二铝纳米粉末,基液为去离子水。分别配成体积浓度为0．1％, 1％和2％的悬浮液。实验结果表明,纳米悬浮颗粒对液体沸腾换热过程的影响会随着纳米颗粒性质,颗粒浓度及热流密度大小的不同而出现不同的效果;加入纳米颗粒后, 对基液沸腾换热的影响存在着两个相反的作用机制,它们分别为:纳米颗粒增强了液体内部的热量迁移能力(热物性的影响)和改变了加热面的表面结构特性(加热面特性的影响)。     

Property changes of electroplated Cu/Co alloys and multilayers by organic additives

We investigated the change of magnetic properties of the electroplated Cu/Co alloys and multilayers caused by organic additives and high temperature annealing. When plated with a pure Cu/Co electrolyte, the alloy contained ∼25% of Cu and ∼75% of Co. The alloy was made of hcp-Co, fcc-Co and Cu(1 1 1) and was super-paramagnetic at room temperature. As we add a few organic additives in the plating electrolyte, the hcp-Co of the films disappeared. The organic additives contained in the electrolytes changed paramagnetic Cu/Co multilayers to ferromagnets. High-temperature thermal annealing increased coercivity due to the growth of the Co grains.     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

D-N交替法与Schwartz交替法的收敛关系分析

This paper has demonstrated that the Schwartz alternating process must converge if D-N alternating process has converged. Its technique is that the overlapping regions in Schwartz alternating process are considered as independent domains, then Schwartz alternating process could be transformed into D-N alter-nating process. Finally the convergence estimation of Schwartz alternating process could be obtained. The results show that its convergence rate is same as that of D-N alternating process.     

病毒感染群体动力学模型分析

本文构建并讨论了一类病毒感染的群体动力学模型,得到了模型存在轨道稳定周 期解的充分条件,较好地解释了在病毒持续感染者体内观察到的病毒载量波动现象.     

双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

稀土配合物Eu(asprin)_3phen发光特性的研究

将稀土配合物Eu(asprin)_3phen掺杂到导电聚合物PVK中,制成结构分别为ITO/PVK:RE配合物/LiF/AI(1),ITO/PVK:RE配合物/PBD/LiF/AI(2)的电致发光(EL)器件。发现二者的电致发光谱存在着较大的差别:在器件(1)中,来自Eu~(3 )的位于594nm(~5D_0→~7F_1)和614nm(~5D_0→~7F_2)处的发光强度大致相当,而在器件(2)中,EL主要来自Eu~(3 )位于614nm的发光,594nm处的发光很弱,与薄膜状态下的光致发光谱(PL)一致。并针对此现象进行了初步讨论。     

Lame Function and Its Application to Some Nonlinear Evolution Equations

In this paper, based on the Lame function and Jacobi elliptic function, the perturbation method is appliedto some nonlinear evolution equations to derive their multi-order solutions.     

Algorithm for Optimal Triangulations in Scattered Data Representation and Implementation

Scattered data collected at sample points may be used to determine simple functions to best fit the data. An ideal choice for these simple functions is bivariate splines. Triangulation of the sample points creates partitions over which the bivariate splines may be defined. But the optimality of the approximation is dependent on the choice of triangulation. An algorithm, referred to as an Edge Swapping Algorithm, has been developed to transform an arbitrary triangulation of the sample points into an optimal triangulation for representation of the scattered data. A Matlab package has been completed that implements this algorithm for any triangulation on a given set of sample points.