类铜离子的电子碰撞参数及其规律

用准相对论扭曲波方法系统地计算了Ｂａ、Ｎｄ、Ｇｄ、Ｙｂ、Ａｕ、Ｐｂ类铜离子组态能级之间的电子碰撞激发强度Ω（ｎｌ－ｎｌ），３≤ｎ≤７，４≤ｎ≤７，同时给出了高能极限的碰撞强度和外推到阈值的碰撞强度，用最小二乘样条方法拟合了全能域碰撞强度及热平均速率系数。对于一个激发过程，用１０个参数可以得到碰撞电子在任意能量下的碰撞强度以及任意温度下的速率系数。     

线状锗等离子体X射线线谱的时间分辨测量

用自行研制的X射线条纹晶体谱仪首次测量了线状锗等离子体的X射线时间分辨谱。给出了类Ne-锗L线共振线的时间演化过程,并用类Ne-锗L线共振线与其双电子俘获伴线的相对强度比粗估了锗等离子体的电子温度及其随时间的变化,实验给出了X光激光增益区介质的电子温度为400～760eV,同时给出了电子温度保持相对恒定的时间不小于90ps(电子温度变化小于2％)。     

裂解气相色谱质谱法研究增塑剂邻苯二甲酸二甲酯的热降解机理

用裂解气相色谱-质谱联用方法研究了橡胶产品中使用的增塑剂邻苯二甲酸二甲酯(DMP)在不同温度条件下的热裂解行为.对不同温度条件下裂解产物的分析表明,在初始阶段DMP的裂解产物主要为二氧化碳、苯、甲苯和苯甲酸甲酯.随着温度的升高苯甲酸甲酯进一步裂解成为分子质量更小的自由基,并发生稠环化反应形成更稳定的菲、蒽、间-联三苯、三亚苯等芳香族多环化合物.根据分析实验提供的裂解产物信息和有机物热裂解化学反应的原理对DMP的热裂解反应机理作了探讨,表明在废旧合成橡胶热裂解回收过程中,增塑剂DMP的高温裂解会产生多环芳烃污染物.应选择合适裂解工艺和裂解温度,以减少对环境的污染.     

倾斜下降管气液两相分层流截面含气率的计算与液层高度的预测

分层流是气液两相流中常见的流动型式，分层流中液层高度是计算的基本数据，由于界面波的存在，对液层的测量和预测都很困难．Ｖｌａｃｈｏｓ提出了预测气液两相分层流液层厚度的关系式，但这一关系式并不适用于倾斜下降管气液两相流．本文提出了计算倾斜下降管气液两相分层流截面含气率的理论模型，在这种模型下得到的截面含气率和实验结果符合良好．在大量实验的基础上，考虑了倾角、管径、气液各相折算速度的影响，根据实验数据提出了预测液层厚度的关系式。     

正电子产生靶上初级电子束半径的最小化研究

为获得尽可能高的正电子(e⁺)产额,严格控制初级电子(e^－)束在e⁺产生靶上的束半径是至关重要的.首先分析了使e^－束半径增大的各因素和对这些因素的制约;然后以北京正负电子对撞机(BEPC)的正电子源为例,给出了束半径的实测值和计算值的比较,以具体说明这些因素的影响;最后讨论了北京正负电子对撞机二期工程(BEPC-Ⅱ)的相应优化设计研究,提出了获得靶上最小束半径的若干途径.     

Adhesion measurement of thin films by a modified laser spallation technique: theoretical analysis and experimental investigation

Laser driven shocks can lead to a dynamic failure, called film spallation. Here, we use a modified laser spallation set-up to measure the dynamic adhesion of thin films and we propose a novel diagnostic technology. Based on correlation theory, new spallation criteria for characterizing the progressive damage at the interface between the film and the substrate are established, such as interface delamination, film spallation and film expulsion. With the help of the theory, the degree of damage and the dimension of damage (i.e. fracture), such as the minimum width of delamination radius, the thickness of the film etc., are estimated. Experiments are carried out on epoxy/stainless steel and epoxy/Al, and the experimental results show that their dynamic bonding strengths are about 25 MPa and 20 MPa, respectively. The detailed results, analyses and discussions are presented in this paper. Received: 6 February 2001 / Accepted: 3 December 2001 / Published online: 11 February 2002     

ICP-AES测定饮用水源中的Cu、Mn、Pb、Cd、Zn

用ICP－AES法同时测定饮用水源中的Cu、Mn、Pb、Cd、Zn等重金属元素，具有基体效应小、测量范围宽等优点。检出限为0．2－4．0μg/L，回收率为91．5％－103．9％，相对标准偏差为0．29％－1．5％，测定密码样与实际样品，结果令人满意。     

Comparison of the boundary theory with the contact rule of phase regions and Gupta’s method

The phase boundary theory and the contact rule of phase regions are compared, and some weaknesses of the latter are manifested. The comparison between the Gupta’s method and the boundary theory method for constructing multicomponent isobaric sections is also presented.     

Non-Euler–Lagrangian Pareto-optimality Conditions for Dynamic Multiple Criterion Decision Problems

In this paper the problem of verifying the Pareto-optimality of a given solution to a dynamic multiple-criterion decision (DMCD) problem is investigated. For this purpose, some new conditions are derived for Pareto-optimality of DMCD problems. In the literature, Pareto-optimality is characterized by means of Euler-Lagrangian differential equations. There exist problems in production and inventory control to which these conditions cannot be applied directly (Song 1997). Thus, it is necessary to explore new conditions for Pareto-optimality of DMCD problems. With some mild assumptions on the objective functionals, we develop necessary and/or sufficient conditions for Pareto-optimality in the sprit of optimization theory. Both linear and non-linear cases are considered.