Influence of the cathodic polarization on the stability of Ti surface in concentrated KOH solutions

The stability of spontaneous thin layers and thin layers formed upon cathodical polarization of Ti in KOH solutions have been studied by potentiostatic and ellipsometric methods. At open circuit potential (OCP) the strongly adherent films, whose thickness depends on the concentration of the KOH solution, were formed. During the cathodic polarization the transformation of these films to weakly adsorbed precipitated layers on the electrode surface was observed. Comparing the theoretically computed curves with the experimental Ψ vs Δ loci measured ellipsometrically, the complex indices of refraction and the thickness of the generated films, from 3.6 to 60 nm in 1 M KOH and from 36 to 105 nm in 5 M KOH (adherent to the electrode surface), were determined. At OCP the rate of film growth increases with increasing the concentration of KOH solution. Cathodic polarizations change the chemical composition and retard the rate of film growth. Based on the ellipsometric and electrochemical data the chemical compositions of the formed films consisted of TiO₂, Ti₂O₃, TiO₂·H₂O, Ti(OH)₃ and TiOOH·nH₂O.     

Fuzzy Symmetries for Linear Molecules and their Molecular Orbitals

In this paper, the fuzzy symmetry of some prototypical linear molecules has been analyzed. The results show that some molecular orbitals (MOs) are less symmetrical but some others are more symmetrical than the molecular skeleton, which the MOs correspond to. The membership functions of space inversion for MOs are closely related to the chemical characteristics of the MOs. Sometimes, although the symmetry of a molecular skeleton is not obvious, however that of some MO is quite obvious. The membership functions of the fuzzy inversion symmetry depend on the choice of the position of the center of inversion. As compared to those of diatomic molecules and linear tri-atomic molecules, the linear polyatomic molecules in which a distinctive fuzzy symmetry of space translation may exist, and thus a significant effect on their properties can be expected.     

Synthesis and characterization of microencapsulated dicyclopentadiene with melamine–formaldehyde resins

Microcapsules containing healing agents have been used to develop the self-healing polymeric composites. These microcapsules must possess special properties such as appropriate strength and stability in surrounding medium. A new series of microcapsules containing dicyclopentadiene (DCPD) with melamine–formaldehyde (MF) resin as shell material were synthesized by in situ polymerization technology. These microcapsules may satisfy the requirements for self-healing polymeric composites. The chemical structure of microcapsule was identified by using Fourier transform infrared (FTIR) spectrometer. The morphology of microcapsule was observed by using optical microscope (OM) and scanning electron microscope. Size distribution and mean diameter of microcapsules were determined with OM. The thermal properties of microcapsules were investigated by using thermogravimetric analysis and differential scanning calorimetry. Additionally, the self-healing efficiency was evaluated. The results indicate that the poly(melamine–formaldehyde) (PMF) microcapsules containing DCPD have been synthesized successfully, and their mean diameters fall in the range of 65.2∼202.0 μm when the adjusting agitation rate varies from 150 to 500 rpm. Increasing the surfactant concentration can decrease the diameters of microcapsules. The prepared microcapsules are thermally stable up to 69 °C. The PMF microcapsules containing DCPD can be applied to polymeric composites to fabricate the self-healing composites.     

Synthesis,crystal structure,electrochemical properties and large optical limiting effect of a novel 3-(E)-ferrocenyl-vinyl-<Emphasis Type="BoldItalic">N</Emphasis>-hexyl carbazole

The novel compound, 3-(E)-ferrocenyl-vinyl-N-hexylcarbazole (FVHC) was first synthesized and fully characterized by elemental analysis, IR, ¹H-NMR, single-crystal X-ray diffraction, ultraviolet (UV) absorption, cyclic voltammograms (CV) and optical limiting (OL) measurements. The result of single crystal X-ray diffraction for the compound reveals that the ferrocenyl and carbazole groups are approximately coplanar, and bridged by double-bond with E configuration, showing that there is a well-delocalized π-electron system in the molecule. The electrochemical investigation indicated that the electron in the FVHC may partially be delocalized over the π-conjugated system and CT process in functionalized carbazole systems. Besides, the compound exhibited strong UV absorption and large optical limiting effect, indicating promising potential applications as useful OL materials.     

Carbon nanotube array-based biosensor

Aligned multi-wall carbon nanotubes (MWNT) grown on platinum substrate are used for the development of an amperometric biosensor. The opening and functionalization by oxidation of the nanotube array allows for the efficient immobilization of the model enzyme, glucose oxidase. The carboxylated open-ends of nanotubes are used for the immobilization of the enzymes, while the platinum substrate provides the direct transduction platform for signal monitoring. It is also shown that carbon nanotubes can play a dual role, both as immobilization matrices and as mediators, allowing for the development of a third generation of biosensor systems, with good overall analytical characteristics.     

壳聚糖-盐酸溶液中温度敏感的相分离行为

研究了壳聚糖 盐酸溶液温度敏感的相分离行为.通过对壳聚糖-盐酸溶液浊度变化的考察以确定相分离温度.测定不同盐酸浓度、壳聚糖浓度以及不同脱乙酰度的条件下的相分离温度，并用DLVO理论(Deijaguin-Landau and Verwey-Overbeck Theory)进行了解释. FTIR、X-ray以及SEM分别描绘了壳聚糖经相分离过程后官能团、结晶状态、颗粒形态的特点.     

Binary mixtures based on polycaprolactone and cellulose derivatives

Pyrolytic process has a promising potential for the environmentally friendly upgrading of lignocellulosic and plastic waste. Thermogravimetry and pyrolysis-gas chromatography-mass spectrometry (Py-GC/MS) were used to get information about the reactive decomposition of PCL in binary mixtures with microcrystalline cellulose (MC) or sisal fibres (SF). Preliminary thermogravimetric investigation showed that biomass is thermally degraded at lower temperatures than PCL and this process has a predominant influence on the thermal behaviour of the mixtures. Discrepancies between the experimental and predicted TG/DTG profiles were considered as a measurement of the extent of interactions occurring on co-pyrolysis. It was found that reactivity of PCL was slightly increased in PCL-SF binary mixtures. Evolution of acidic products from cellulose and hemicelluloses decomposition may promote PCL degradation in binary mixtures with SF. It seems that the co-pyrolysis process could have potential for the environmentally friendly transformation of biocomposites.     

简法合成甲地孕酮

本文报道了合成甲地孕酮的简便方法,即以17α-乙酰氧基-黄体酮(3)为原料,将其烯醇醚(4)经Mannich反应,或将△~(3,5)-3,17α-二乙酰氧基-黄体酮(2)与二乙氧基甲烷反应,生成6-次甲基-17α-乙酰氧基-黄体酮(5),然后将5用钯/碳酸钙作催化剂转位得目的物甲地孕酮(6b),总收率分别为56%和50%(均以17α-羟基-黄体酮(1)为起始物)。     

Studies on the refolding of the reduced-denatured insulin with size exclusion chromatography

The refolding of the reduced-denatured insulin from bovine pancreas was investigated with the size exclusion chromatography (SEC). It was shown that the reduced-denatured insulin originally denatured with 7.0 mol L^?1 guanidine hydrochloride (GuHCI) or 8.0 mol L^?1 urea could not be refolded with a non-oxidized mobile phase. Although the oxidized and reduced glutathione (GSSG and GSH) were employed in the oxidized mobile phase, the reduced-denatured insulin still could not be renatured. However, in the presence of 2.0 mol L^t-1 urea in the oxidized mobile phase employed, the reduced-denatured insulin can be refolded with SEC, and the aggregation of denatured insulin can be diminished by urea. In addition, the disulfide exchange of reduced-denatured insulin also can be accelerated with GSSG/GSH in the oxidized mobile phase. The three disulfide bridges of insulin were formed correctly and the reduced-unfolded insulin can be renatured completely. The results were further tested with reversed-phase liquid chromatography (RPLC) and hydrophobic interaction chromatography (HIC).     

Competitive adsorption and desorption of a bi-solute mixture: effect of activated carbon type

This study aims to clarify the effects of carbon activation type and physical form on the extent of adsorption capacity and desorption capacity of a bi-solute mixture of phenol and 2-chlorophenol (2-CP). For this purpose, two different PACs; thermally activated Norit SA4 and chemically activated Norit CA1, and their granular countertypes with similar physical characteristics, thermally activated Norit PKDA and chemically activated Norit CAgran, were used. The thermally activated carbons were better adsorbers for phenol and 2-CP compared with chemically activated carbons, but adsorption was more reversible in the latter case. 2-CP was adsorbed preferentially by each type of activated carbon, but adsorption of phenol was strongly suppressed in the presence of 2-CP. The simplified ideal adsorbed solution (SIAS) model underestimated the 2-CP loadings and overestimated the phenol loadings. However, the improved and modified forms of the SIAS model could better predict the competitive adsorption. The type of carbon activation was decisive in the application of these models. For each activated carbon type, phenol was desorbed more readily in the bi-solute case, but desorption of 2-CP was less compared with single-solute. This was attributed to higher energies of 2-CP adsorption.