硝基酚类化合物在海水中的光化学氧化研究

酚类化合物尤其是硝基苯酚属于国家严格控制排放的有毒物质 .由于工业排污等原因 ,在近岸水体中能检测到许多酚类化合物 .我国胶州湾和杭州湾表层海水中酚的含量分别高达 3和 9mg/L[1] .酚的毒性会影响海水生物的生长和繁殖 ,危及人类健康 .由于硝基苯酚难于生化降解 ,因此研究其在水体中的光降解十分重要 [2～ 6 ] .文献中关于有机污染物的光化学研究大多侧重于废水处理 ,且降解方法也多采用 Ti O2 催化降解 [7,8] .对于硝基苯酚在天然水体中的光降解则知之甚少 .本文通过模拟海水条件下硝基苯酚的光化学反应及其影响因素 ,更加深入地了…     

适用于高维数据的正交信号校正预处理方法

建立了一种高维正交信号校正方法,基于二维PLS到高维PLS的发展思想,把适用于二维数据预处理的正交信号校正方法发展成适用于高维数据预处理的方法.不仅在理论上扩展了正交信号校正方法,而且在实际应用中也能通过与高维PLS的联用产生更有效的高维数据校正方法.     

四氢键二聚体和分子组装

介绍了最近几年新的四氢键有机二聚体研究的进展及其在分子自组装和分子聚 集体化学研究中的应用。     

Evaluation of an on-line coupled continuous flow liquid membrane extraction and precolumn system as trace enrichment technique by liquid chromatographic determination of bisphenol A

An on-line coupled continuous flow liquid membrane extraction (CFLME) and C₁₈ precolumn system was developed for sample preconcentration in liquid chromatography determination. After preconcentration by CFLME, which is based on the combination of continuous flow liquid–liquid extraction and supported liquid membrane, bisphenol A (BPA) was enriched in 960 μl of 1 mol l⁻¹ NaOH used as acceptor. This acceptor was on-line neutralized and transported onto the C₁₈ precolumn where analytes were absorbed and focused. Then the focused analytes were injected onto a C₁₈ analytical column for separation and detected at 220 nm with a diode array detector. CFLME related parameters such as flow rates, pH of donor and acceptor, and enrichment time were optimized. The proposed method presents a detection limit of 0.03 μg l⁻¹ (S/N=3) when 60 ml samples was enriched with an enrichment time of 30 min. Compared with C₁₈ based column-switching procedure, this proposed procedure presents similar sample throughput and lower detection limits. The proposed method was successfully applied to determine BPA in tap water, river water, and municipal sewage effluent samples.     

钒钨酸盐-CdS纳米粒子复合膜的制备与电致变色性能

通过层-层自组装方法制备了由Dawson结构三钒取代型钨酸盐1-K₉P₂W₁₅V₃O₆₂·18H₂O(P₂W₁₅V₃)与CdS纳米粒子构筑的复合膜材料, 研究了CdS纳米粒子添加和复合膜层数对P₂W₁₅V₃多酸复合膜材料电致变色性能的影响. 采用UV, XRD, SEM和循环伏安等测试手段对复合材料的结构和性能进行了表征; 将电化学工作站和紫外-可见吸收光谱联用, 在-1.0~+1.0 V的电压范围内, 对不同层数、 有无CdS纳米粒子复合的的膜材料的电致变色性能进行研究. 研究结果表明, 20层的复合膜材料性能最佳, 光反差为38.05%, 着色时间为3.57 s, 褪色时间为6.94 s, 最大着色效率达到94.04 cm²/C, 实现了从无色、 蓝色到蓝紫色, 再到无色的可逆颜色变化, 相对于单独P₂W₁₅V₃膜, 光反差提高46.07%, 着色效率提高96.53%, 电致变色性能显著提高.     

苯并噻唑类荧光探针的合成及对N2H4·H2O和HSO-3的检测性能

以苯并噻唑为荧光团, 氰基乙酸乙酯为识别基团, 设计合成了对水合肼和亚硫酸氢盐具有双重检测能力的荧光探针3-(2-羟基-苯并噻唑)-2-氰基-丙烯酸乙酯(HBT-CN). 在二甲基亚砜/磷酸盐(体积比为1：4)的缓冲液中, 探针对水合肼和亚硫酸氢盐具有良好的选择性, 且荧光强度分别增强了5.6倍(500 nm)和7.5倍(458 nm). 结果表明, 在检测过程中, HTB-CN与水合肼发生了还原-缩合反应, 生成了醛腙, 在波长500 nm处发出黄绿色的荧光信号; HBT-CN与亚硫酸氢盐发生了亲核加成反应, 在波长458 nm处发出蓝色的荧光信号, 从而实现了对水合肼和亚硫酸氢盐的差异性定性与定量检测.     

基体石墨的孔隙结构及其对单质Ag扩散的影响

高温气冷堆燃料元件的基体石墨是一种多孔复合材料,是燃料元件的主要组成部分,其结构影响燃料元件的性能和裂变产物在燃料元件中的扩散。 本文利用压汞法表征基体石墨的孔隙结构,并讨论了基体石墨制备工艺中最大压制压强与热处理过程对孔隙结构的影响。 结果表明,基体石墨大孔孔径分布为6001900 nm,高温热处理使基体石墨的总孔隙率、中值孔径、大孔孔容均减小;基体石墨热处理样品的大孔孔容随最大压制压强的增加而呈线性减少,热处理过程单质Ag在石墨基体中的扩散速度与大孔孔容变化具有正相关性。     

In situ fabrication of nanostructured titania coating on the surface of titanium wire: A new approach for preparation of solid-phase microextraction fiber

Nanostructured titania-based solid-phase microextraction (SPME) fibers were fabricated through the in situ oxidation of titanium wires with H₂O₂ (30%, w/w) at 80 °C for 24 h. The obtained SPME fibers possess a ∼1.2 μm thick nanostructured coating consisting of ∼100 nm titania walls and 100-200 nm pores. The use of these fibers for headspace SPME coupled with gas chromatography with electron capture detection (GC-ECD) resulted in improved analysis of dichlorodiphenyltrichloroethane (DDT) and its degradation products. The presented method to detect DDT and its degradation products has high sensitivity (0.20-0.98 ng L⁻¹), high precision (relative standard deviation R.S.D. = 9.4-16%, n = 5), a wide linear range (5-5000 ng L⁻¹), and good linearity (coefficient of estimation R² = 0.991-0.998). As the nanostructured titania was in situ formed on the surface of a titanium wire, the coating was uniformly and strongly adhered on the titanium wire. Because of the inherent chemical stability of the titania coating and the mechanical durability of the titanium wire substrate, this new SPME fiber exhibited long life span (over 150 times).     

Preparation of Europium Induced Conformation—specific anti—calmodulin Monoclonal Antibody

Monoclonal antibody technique was employed to detect the conformational difference of CaM induced by metal ions. A trivalent europium ion induced conformation-specific anti-calmodulin monoclonal antibody was successfully prepared with europium-saturated calmodulin as antigen.     

CX_2(X=H,F,Cl)与甲基异丙基醚C-H键插入反应的理论研究

用从头计算方法在MP2 /6 31G(d)水平上研究了CX2 (X =H ,F ,Cl)与甲基异丙基醚的C -H键插入反应。CCl2 与甲基异丙基醚两个不同的α C的C -H键插入势垒分别为 117.2kJ/mol (甲基 )和 2 0 .6kJ/mol (异丙基 )。CF2 与异丙基α C的C -H键上插入势垒为 12 0 .0kJ/mol,在插入甲基上C -H键时会引起C -O键的断裂。CH2 的插入反应则不需要势垒。对CX2 与二甲醚、甲乙醚、甲基异丙基醚、甲基苄基醚上各种不同的C -H键插入势垒进行了比较 ,甲基和苯基都促使其毗邻的C -H键更容易被CX2 所插入