Pseudo-epitaxial C60 films prepared by a hot-wall method

We have used both reflection-geometry and grazing-incidence-geometry X-ray scattering to study thin films of C₆₀ evaporated onto mica substrates via a hot-wall technique. The growth mode yields close-packed C₆₀ planes, which are parallel to the substrate surface and which exhibit out-of-plane correlation lengths of 850 Å. In the film plane the C₆₀ is at best pseudo-epitaxial, with a 0.9° distribution of crystallite orientations, a 450 Å in-plane correlation length, and a 3.7% lattice mismatch, better than obtained by other thin film techniques but far from the accepted definition of single crystal thin film epitaxy.     

Investigation of the conditions for feeding filamentary silicon crystals,growing in a reactor with hot walls

An estimate of the factors which influence the rate of growth of filamentary silicon crystals in a standard chloride system using a quartz reactor with hot walls is given. It is shown that a diffusion form of crystallization is observed under the conditions investigated.Voronezh State Technical University. Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 10, pp. 22–26, October, 1995.     

Spin effects in instanton models

Nonperturbative nolocal structure of QCD vacuum is well described by instanton model. Specific helicity and flavor structure of zero modes of quarks, in instanton field allows simultaneously to explain some important features of low-and high-energy hadron phenomemology. The basic characteristics of hadron spectrum, partonic sum rules, heavyquark potential etc within the instanton liquid model are briefly discussed.     

Isotopic families of contact manifolds for elliptic PDE

A test for a function to be a solution of an elliptic PDE is given in terms of extensions, as solutions, from the boundaries inside the domains belonging to an isotopic family. It generalizes a result of Ehrenpreis for spheres moved along a straight line.

     

CONCEPTUAL DESIGN STUDIES OF AN 84 GHz, 500 kW, CW GYROTRON

The feasibility of an 84 GHz, 500 kW, CW gyrotron for ECRH on an experimental tokamak will be presented in this paper. Mode competition and mode selection procedures are carefully investigated by considering various candidate modes and the TE_10,4 mode is chosen as the operating mode. A conventional cylindrical cavity resonator with weak input and output tapers and parabolic roundings is considered for interaction studies. Self-consistent, both single mode and time-dependent, calculations are carried out and power and efficiencies are computed for a typical set of beam parameters. The results show that an output power of well over 500 kW, CW and efficiency around 40% can be reached without a depressed collector.     

Approximation of bandlimited functions

Many signals encountered in science and engineering are approximated well by bandlimited functions. We provide suitable error bounds for the approximation of bandlimited functions by linear combinations of certain special functions—the prolate spheroidal wave functions of order 0. The coefficients in the approximating linear combinations are given explicitly via appropriate quadrature formulae.     

Mass Power Spectrum in a Universe Dominated by the Chaplygin Gas

The mass power spectrum for a Universe dominated by the Chaplygin gas is evaluated numerically from scales of the order of the Hubble horizon to 100 Mpc. The results are compared with a pure baryonic Universe and a cosmological constant model. In all three cases, the spectrum increases with k, the wavenumber of the perturbations. The slope of the spectrum is higher for the baryonic model and smaller for the cosmological constant model, the Chaplygin gas interpolating these two models. The results are analyzed in terms of the sound velocity of the Chaplygin gas and the moment the Universe begins to accelerate.     

Studies on amine hydrothiocyanates. IV. Thermal decomposition studies using TG

The thermal decomposition of piperidine hydrothiocyanate, piperazine hydrothiocyanate, and the dihydrothiocyanates of ethylenediamine and 1,3-diaminopropane has been studied using TG. Piperidine hydrothiocyanate decomposes in a single step while the dihydrothiocyanates follow more complicated decomposition patterns yielding H₂S and half of the organic moiety first. The second step involves the loss of H₂S and the remainder of the organic moiety. In each case, complex polymeric materials result. Piperazine hydrothiocyanate also decomposes in two steps, the first involving the loss of half of the piperazine and the second involving the loss of piperazine and H₂S. Kinetic parameters have been determined for all these reactions.