Beiträge zur Chemie des Sulfamids, 1. Mitt.: Zur Konstitution des Disilber-sulfamids

According to spectroscopic (IR, broadline proton NMR) and chemical (alkylation) investigations of disilver sulphamide the following molecular structure is assumed: $$\begin{gathered} O \hfill \\ || \hfill \\ H_2 N\_\_S\_\_NAg| \hfill \\ OAg \hfill \\ \end{gathered}$$ From the IR and NMR data deduction concerning the nature of the chemical bonds in this compound is possible. The instability of the still unknown mono-and trisilver sulphamide is discussed with regard to the structure of disilver sulphamide.     

Synthesis, crystal structure and magnetic property of the novel dinuclear nickel(II) complex with 4-(p-methoxyphenyl)-3,5-bis(pyridine-2-yl)-1,2,4-triazole

A novel dinuclear nickel(II) complex, [Ni₂(MOBPT)₂Cl₂(H₂O)₂]Cl₂ · 7H₂O (MOBPT = 4-(p-methoxyphenyl) −3,5-bis(pyridine-2-yl)-1,2,4-triazole), has been synthesized and characterized by elemental analysis, IR and single crystal X-ray diffraction methods. The crystal structure determination shows that the dinuclear Ni₂N₈ unit is almost planer in which each Ni^II ion is coordinated by four nitrogen atoms from MOBPT equatorially and a water molecule and a chloride ion axially in a distorted octahedral geometry. Magnetic measurements reveal a relatively weak antiferromagnetic exchange in the complex.     

Optical properties of ZnO and ZnO:In nanorods assembled by sol-gel method

Self-assembled zinc oxide (ZnO) and indium-doping zinc oxide (ZnO:In) nanorod thin films were synthesized on quartz substrates without catalyst in aqueous solution by sol-gel method. The samples were characterized by x-ray diffraction (XRD), scanning electron microscope (SEM), Raman-scattering spectroscopy, room-temperature photoluminescence (PL) spectra, and temperature-dependent PL spectra measurements. XRD and Raman spectra illustrated that there were no single In2O3 phase in ZnO lattice after indium doping. The PL spectra of ZnO showed a strong UV emission band located at 394 nm and a very weak visible emission associated with deep-level defects. Indium incorporation induced the shift of optical band gap, quenching of the near-band-edge photoluminescence and enhanced LO mode multiphonon resonant Raman scattering in ZnO crystals at different temperatures. Abnormal temperature dependence of UV emission integrated intensity of ZnO and ZnO:In samples is observed. The local state emission peak of ZnO:In samples at 3.37 eV is observed in low-temperature PL spectra. The near-band-edge emission peak at room temperature was a mixture of excitons and impurity-related transitions for both of two samples.     

Ruthenium-catalyzed cyclization of 3-en-1-ynyl imines with nucleophiles via tandem 5-exo-dig cyclization and nucleophilic addition

Treatment of 3-en-1-ynyl imines with TpRuPPh₃(CH₃CN)₂PF₆ catalyst (1 mol %) in DCE (50 °C, 6 h) effected catalytic cyclization with suitable nucleophiles and gave functionalized pyrroles in good yields. The reaction mechanism is proposed to proceed via (2-pyrrolyl)carbenoid intermediates derived from 5-exo-dig cyclization. This catalytic reaction works well with various nucleophiles, including water, alcohols and anilines.     

Adsorption of 1,10-phenanthroline within a dodecanethiol monolayer: an approach to a switchable electrode surface

A simple method was used to prepare a "switchable" electrode surface by using self-assembled monolayers of dodecanethiol on a gold electrode. The dodecane-modified electrode was electrochemically inactive until the monolayer was soaked in solutions of 1,10-phenanthroline or 2,2'-bipyridine. The electroactive form of the electrode could be reverted back to the nonelectroactive form by rinsing the electrode. Surface IR results showed that both dodecanethiol and 1,10-phenanthroline exist in the mixed monolayer.     

Über die Konfiguration des Prolins im Ergotamin

It is well known that in the ergot alkaloids of the peptide type the proline appears in thel-configuration. Different methods of acid hydrolysis may lead to various cleavage products; hydrolysis by HCl yieldsd-proline, on the other hand hydrolytic cleavage by means of strongly acid cation exchange resin preserved the orginall-configuration.

---

---

Teilveröffentlichung der Dissertation vonH. Kolassa, Univ. Wien, 1973.     

Thermische Polymerisation von Acenaphthylen

Zusammenfassung Acenaphthylen wurde durch Anpolymerisation und zweifache Hochvakuumsublimation gereinigt. Die Reinigungsmethode wird ausführlich beschrieben.Bei verschiedenen Temperaturen wurde mit einer dilatometrischen Methode die thermische Bruttogeschwindigkeit gemessen. Zwischen 95 und 105 °C giltk _br=7,0₈·10¹⁰ exp (– 30,9 kcal/RT).Die beträchtliche Aktivierungsenergie der Bruttoreaktion ist sowohl auf eine große Aktivierungsenergie der thermischen Startreaktion als auch auf eine relativ hohe Wachstumsaktivierungsenergie zurückzuführen.Das Polymerisationsverhalten von Acenaphthylen kann vermutlich aufgrund seiner sterischen Eigenschaften erklärt werden.

---

Summary Acenaphthylene was purified by partial polymerisation, followed by double stage high vacuum sublimation. The method of purification is described in detail.The thermal overall rate was measured at different temperatures by a dilatometric method. Between 95 and 105 °C the following relation holds:k _th=7,0₈ · 10¹⁰ exp (– 30,9 kcal/RT).The considerable energy of activation of the overall reaction depends on a relatively high energy of activation of both the thermal initiation and the propagation reaction.It is supposed, that the polymerisation behaviour of acenaphthylene depends mainly on its steric properties.

     

Improved flask-combustion method for phosphorus in petroleum products

Summary An electrical assembly for the oxygen-flask combustion of lubricants and similar petroleum products is described. The pyrolysis is performed in two consecutive steps. After the ignition and burning of the sample (sorbed on sodium carbonate) the combustion is completed by further heating. The sample weight should not exceed 140 mg. In this way the sensitivity of phosphorus determination of the tentative IP standard procedure is enhanced from 0.01 to 0.001% phosphorus if the volume of solution for the final spectrophotometric measurement is reduced.

---

Zusammenfassung Ein elektrisches Gerät für die Verbrennung von Schmierölen und ähnlichen Erdölprodukten im Schöniger-Kolben wurde beschrieben. Die Pyrolyse erfolgt in zwei aufeinander folgenden Schritten. Nach der Entflammung der an Natriumcarbonat adsorbierten Probe und nach Erlöschen der Flamme erfolgt die vollständige Verbrennung von Einwaagen, die 140 mg nicht überschreiten. So konnte die Empfindlichkeit der Phosphorbestimmung nach der tentativen IP-Standardmethode von 0,01% auf 0,001% Phosphor gesteigert werden, wenn man die spektrophotometrische Messung mit vermindertem Lösungsvolumen durchführt.

---

---

Herrn Professor Dr. H. Lieb zum 90. Geburtstag gewidmet.     

Das Schwingungsspektrum von Magnesium-orthovanadat

The infrared and laser-Raman spectra of crystalline Mg₃(VO₄)₂ are reported and a factor group analysis for the full lattice is presented to support the discussion. The 1,000 to 600 cm^?1 region of the spectrum is essentially related to internal (stretching) modes of the greatly distorted VO₄ tetrahedra, whereas the bands in the low frequency region must be assigned to complex vibrations originating in the interaction of the bending vibrations of the tetrahedral groups with the external modes.     

Liquid–paper interactions during liquid drop impact and recoil on paper surfaces

The spreading and recoiling of water drops on several flat and macroscopically smooth model surfaces and on sized paper surfaces were studied over a range of drop impaction velocities using a high-speed CCD camera. The water drop spreading and recoiling results on several model hydrophobic and hydrophilic surfaces were found to be in agreement with observations reported in the literature. The maximum drop spreading diameter for those model surfaces at impact was found to be dependent upon the initial drop kinetic energy and the degree of hydrophobicity/hydrophilicity of the surface. The extent of the maximum drop recoiling was found to be much weaker for hydrophilic substrates than for hydrophobic substrates. Sized papers, however, showed an interesting switch of behaviour in the process of water drop impaction. They behave like a hydrophobic substrate when a water drop impacts on it, but like a hydrophilic substrate when water drop recoils. Although the contact angle between water and hydrophilic or hydrophobic non-porous surfaces changes from advancing to receding as reported in literature, the change of contact angle during water impact on paper surface is unique in that the level of sizing was found to have a smaller than expected influence on the degree of recoil. Atomic force microscopy (AFM) was used to probe fibres on a sized filter paper surface under water. The AFM data showed that water interacted strongly with the fibre even though the paper was heavily sized. Implications of this phenomenon were discussed in the context of inkjet print quality and of the surface conditions of sized papers. Results of this study are very useful in the understanding of inkjet ink droplet impaction on paper surfaces which sets the initial condition for ink penetration into paper after impaction.